Diamond 60/90 PCE Manual de usuario

Mod: E60/5P9T

Production code: 60/90 PCE

07/2012

INDEX

Paragraph Instructions for the installer

1Compliance with the EEC Directives

1.1 Installation diagrams

1.2 Wiring diagrams

1.3 Electrical data

1.4

2Preparing for installation

2.1 Laws, technical regulations and general rules

2.2 Installation

2.2.1 Electrical connection

2.2.1.1 Equipotential connection

Paragraph User instructions

3Getting ready to work

3.1 Instructions for use – Turning on and off electric hotplates

3.2 Ventilated electric oven

3.2.1 Oven characteristics

3.2.2 Control selector knobs and thermostat

3.2.3 Operation selector knob symbols

3.2.4 Indicator lights

3.2.5 Safety thermostat

4Maintenance, cleaning and care

4.1 Cleaning of oven interior

4.2 Information on electricity and its use

1COMPLIANCE WITH THE “EEC” DIRECTIVES

NOTE: The cookers are made in compliance with the essential requirements established

by the EEC directives in agreement with the “EEC 73/23 Low Voltage Directive, with the

“EEC 89/336 EMC Directive, supplemented by the “CE” mark according to the EEC

Directive 93/68.

1.3 ELECTRICAL DATA

MODEL 60/30 PCE 60/60 PCE 60/60 CFE

RATED VOLTAGE 400V – 3N~ 50/60 Hz

OVEN POWER kW // 2.245

TOTAL POWER kW 36 8.245

No. HOTPLATES

TIMES POWER 2 x 1.5 4 x 1.5 4 x 1.5

CABLE TYPE H05RN-F H05RN-F H05RN-F

POWER CABLE

CROSS SECTION 5 x 1.5 mm² 5 x 1.5 mm² 5 x 2.5 mm²

DIMENSIONS mm

WIDTH

DEPTH

HEIGHT

300

600

280 (410)

600

280 (410)

600

850 (960)

The data plate contains all data which is required for installation and is located on the back

of the left-hand side.

2PREPARING FOR INSTALLATION

The appliance must be positioned in a well aerated place, if possible under a suction hood

to ensure complete evacuation of the steam created when cooking. Before using the

appliance for the first time, remove all the protection sheets, clean all the surfaces with a

soft cloth, warm water and soap to remove all traces of the antirust products applied during

production.

To install the appliance close to walls, partitions, kitchen units, decorative claddings, etc.,

they ought to be made with non flammable materials or leave a gap of at least 100 mm

between them and the appliance.

It is essential to comply with the fire prevention rules.

The appliances can be positioned, depending on the model, as top appliances. floor-

standing appliances or in series together with others in our range on bases or stands.

The main switch and outlet must be near the appliance and easy to reach.

Level the appliance, adjust its height and stability by turning the levelling feet.

2.1 LAWS, TECHNICAL REGULATIONS AND GENERAL RULES

Comply with the following rules during installation:

1) accident prevention standards;

2) the laws in force in the country where the appliance is installed;

3) read all the indications given in this handbook carefully as they provide important

information for safe installation, use and maintenance;

4) keep this handbook in a safe place for future reference by those who use the

appliance.

2.2 INSTALLATION

Only specialised personnel should install, start and service the appliance.

Installation must be carried out in compliance with the laws in force in the country where

the appliance is installed.

The manufacturer declines all responsibility if the appliance malfunctions due to incorrect

installation, tampering, improper use, bad maintenance, failure to comply with the local

laws and inexperience in using the appliance.

INSTRUCTIONS FOR THE QUALIFIED INSTALLER

APPLIANCE WEIGHING MORE THAN 40 Kg

CONNECT THE POWER CABLE

TO THE TERMINAL BOARD BEFORE PUTTING

THE APPLIANCE IN ITS FINAL POSITION

2.2.1 ELECTRICAL CONNECTION

1) The hobs with electric hotplates and the cookers are delivered set up for operation at

VAC 400 + 3N

2) Connect to the electricity line, interposing a suitably rated automatic circuit breaker,

where the opening distance between the contacts must be at least 3 mm. Furthermore,

the supply voltage must not deviate from the voltage value by ± 10%.

3) The characteristics of the flexible cable chosen for connection to the electricity line

must not be inferior to the type with rubber insulation H05RN-F and it must have a

nominal cross section suitable to absorb maximum current; hence, as indicated in table

1.1, it must have the same minimum cross section indicated relative to the cooker

model.

4) On the “top” hobs, cable input and the terminal board are at the back and in order to

connect up you have to unscrew the screws and unhook the protection cover. To

connect up: put the flexible cable through the grommet and cable relief strain, connect

the single wires to their corresponding terminals.

5) It is essential that the appliance is connected to an effective earth plug. For this

purpose, near the connection terminal board there is a terminal marked with a plate

with the symbol on it and to which the earth wire must be connected (yellow-green).

This wire must be long enough so that, if the cable relief strain slackens, it can only be

stressed after the power wires have been disconnected.

NOTE: earthing must comply with current laws.

2.2.1.1 EQUIPOTENTIAL CONNECTION

If you are installing several appliances in a row, the kitchen must be connected to an

equipotential system whose effectiveness must be verified in accordance with the

relative current laws. The connection is found on the rear part of top appliances, and on

the left-hand side of the base for floor-standing appliances. It is marked with the tag

"EQUIPOTENTIAL".

Earth terminal wires

NOTE: The manufacturer declines all responsibility if safety regulations are not

complied with as described above.

USER INSTRUCTIONS

3GETTING READY TO WORK

Cookers are appliances for cooking food and must only be used by professionally qualified

personnel in the way indicated in this instruction manual. Any other improper use can be

dangerous.

3.1 USE INSTRUCTIONS. TURNING ELECTRIC HOTPLATES ON AND OFF

Each cooking hotplate can be set to 6 positions. Turn the switch of the hotplate from "0" to

the desired position. The indicator light will come on. The green indicator light indicates

that electricity is being supplied to the appliance. To turn off the hotplates, turn the switch

to "0".

Above the knob, there is a symbol which marks the position of the hotplate.

When turned on, the hotplate will operate which corresponds to the symbol of the knob

which is turned.

3.2 VENTILATED ELECTRICAL OVEN

3.2.1 OVEN CHARARCTERISTICS

DIMENSIONS:

Height 59.6 cm

Width 59.6 cm

Depth 54 cm

Usable volume l. 50

HEATING ELEMENTS AND COMPONENTS

Grill heating element 1400 W

Top heating element 900 W

Base heating element 1300 W

Oven light 15 W

Fan motor 30 W

Maximum absorbed power 2.2 kW

Power supply voltage 230 V (50/60 Hz)

Oven accessories:

Drip pan 1

Oven rack 1

IMPORTANT:

grease used in manufacturing and thermal insulation of the oven may cause smoke and

unpleasant odours at first lighting. For this reason, it is advisable at first use to heat the

empty oven for about an hour at the maximum temperature, so as to eliminate this small

inconvenience.

3.2.2 CONTROL SELECTOR KNOBS AND THERMOSTAT

To use the electric oven, you must use the both selector knob which makes it possible to

select the type of heating which is most suitable for the various cooking need, as well as

the thermostat knob which must be set to the desired temperature.

The various kinds of heating are indicated by symbols which will be described below. The

thermostat will keep the set temperature constant during cooking.

3.2.3 VENTILATED OVEN SELECTOR KNOB SYMBOLS

Fan only operation

(rapid defrost)

The use of the fan only without any heating

makes it possible to defrost foods quickly and

efficiently.

Multiple ventilated cooking

The simultaneous action of the two heating

elements and of the fan make it possible to

cook different kinds of foods on more than

one level without mixing aromas.

Ventilated grill

The combined action of the grill and the fan

ensures uniform cooking.

Even large pieces of meat and especially

high-volume foods can

be grilled perfectly.

Operation with only traditional

grill heating element

With the opeation of only the upper heating

element excellent results are obtained in the

cooking of meats of low to medium thckness.

Perfect for toasting bread, for baked pasta

and vegetables.

3.2.4 INDICATOR LIGHTS

The ovens are equipped with 2 indicator lights, one green and one orange.

The green light indicates that any single component, whereas the orange one is connected

to the thermostat and operates intermittently whenever the thermostat cuts in to keep the

temperature constant.

3.2.5 SAFETY THERMOSTAT

In order to avoid dangerous overheating due to improper use of the appliance or defective

components, the oven is equipped with a safety thermostat which disconnects the

electrical power supply in case of abnormal operation. When the oven temperature lowers,

the thermostat resets automatically. Therefore, if the thermostat cuts in, to use it again it is

sufficient to wait for the oven to cool and eliminate the cause. If however the thermostat

has cut in due to a component defect, it is necessary to contact technical service.

4MAINTENANCE, CLEANING AND CARE

ATTENTION: you must never spray the appliance with direct jets of water nor use a

water cleaner!

Before you start cleaning the appliance it must be disconnected from the electricity via the

main switch.

The cooking hotplates must be cleaned only after they have cooled off.

Clean the steel parts with a soft cloth, water and detergent. The detergent used must not

contain chlorine or abrasives as they can damage the steel surfaces. After it has been

cleaned, rinse with water and dry with a dry cloth.

4.1 Cleaning of oven interior

Wash the enamelled parts with lukewarm water, detergent, and a soft sponge.

Do not use steel wool or abrasive substances, to avoid damaging the enamel.

Rinse well and dry with a soft cloth. If there are food residues after cooking it is advisable

to clean the oven, so that the food residue does not burn and become more difficult to

clean after the next use.

For accurate cleaning inside the door glass panels, it is advisable to remove the inner

glass panel;

Completely open the door and unscrew the two screws that hold the inner glass panel.

Clean both glass panels with warm water and a soft cloth.

Re-assemble all after cleaning.

-What to do if the appliance is going to be out of use for long periods of time.

First of all disconnect it from the electricity. Clean it thoroughly, following the

instructions, and dry it.

-What to do in the case of malfunctions.

In the case of failures, turn the appliance off and notify the assistance service.

-Maintenance.

Only specialised personnel must be allowed to service the appliance. Before starting,

disconnect the appliance from the mains socket.

We advise you to have the appliance checked at least once a year by a qualified

installer. We also advise you to stipulate an assistance contract.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Horno de Diamond

Diamond

Diamond G77/4BFE7 Manual de usuario

Diamond

Diamond E77/2P4T-N Manual de usuario

Diamond

Diamond EFP/66R-M Hoja de especificaciones

Diamond

Diamond LD4/35-N Manual de usuario

Diamond

Diamond FVS-711/TS Manual de usuario

Diamond

Diamond LOGIC LINE PLUS LD4/35-N Manual de usuario

Diamond

Diamond GASTR023/X N Hoja de especificaciones

Diamond

Diamond Gas Series Manual de funcionamiento

Diamond

Diamond GASTRO23/X-N Manual de usuario

Diamond

Diamond Combi DIGITAL SDE/XC-10 Manual de usuario

Diamond

Diamond Combi DIGITAL Manual de usuario

Diamond

Diamond DFV-1011/N Manual de usuario

Diamond

Diamond DFV-411/S Manual de usuario

Diamond

Diamond AC/SS21 Manual de usuario

Diamond

Diamond CGE23 N Hoja de especificaciones

Diamond

Diamond BRIO Series Hoja de especificaciones

Diamond

Diamond Diverso WR-FD24-MT Manual de usuario

Diamond

Diamond LOGIC LINE PLUS LD18/35-N Manual de usuario

Diamond

Diamond GL6/35-D Manual de usuario

Diamond

Diamond DFV-511/TS Manual de usuario

Diamond

Diamond FVS-611 Hoja de especificaciones

Diamond

Diamond Optima Series Manual de usuario

Diamond

Diamond FDEK 0623 P Series Guía de inicio rápido

Diamond

Diamond SBES/XC-06 Manual de usuario

Manuales populares de Horno de otras marcas

Bosch

Bosch HVA531NS0 Manual de usuario

Electrolux

Electrolux EOF6P46X Manual de usuario

NEFF

NEFF B44S32 5GB Series Manual de usuario

Combi

Combi BLODGETT BC142GDS Manual de usuario

AEG

AEG COMPETENCE 311704300 Manual de usuario

Falcon

Falcon DOMINATOR PLUS G3106 Series Guía del usuario

Rational

Rational SCC WE 61G Manual de usuario

Smeg

Smeg DOSPA38X Manual de instalación y operación

Electrolux

Electrolux air-o-convect 20 GN 2/1 Manual de usuario

Miele

Miele HR 1954-2 Manual de usuario

KHIND

KHIND OT50 Manual de usuario

Henny Penny

Henny Penny Smoker Box Manual de usuario

Lang

Lang ECOD-AP Manual de usuario

AEG

AEG BEK455310M Manual de usuario

Frigidaire

Frigidaire FNGE90JGR Manual de usuario

Hotpoint

Hotpoint FE9 S831 JSH IX Manual de usuario

GE Advantium SCB2000 Manual de usuario

AEG

AEG DE401301DM Manual de usuario