DGTEC DG-HD5210 Manual de usuario
INTRODUCTION
This User Manual will help you to operate your receiver in a safe manner while enjoying
all the features and benefits it provides for your entertainment
This User Manual must be read by every person that is:
•Installing
•Connecting
•Operating
•Cleaning
DISPOSAL OF USED ELECTRICAL AND ELECTRONIC DEVICES
All products that are marked either directly or labeled on the packaging with the following
icon:
Cannot be disposed of through the normal household waste channels. These products
must be disposed of through specialised collection centres for the recycling of electric
and electronic devices
By disposing of this product as required by law, you are contributing to the protection of
the environment.
Incorrect disposal can be dangerous to human health and hazardous to the environment.
2
Table of contents
Safety Instructions
4
Positioning
5
Front Panel / Rear Panel
7
RemoteControlUnit 9
ConnectingyourSTB 11
MainMenu 13
1.Installation 13
2. TV Channel 14
3. Radio Channel 14
4. Edit Program 14
5. System Setting 15
6. System Info 17
Trouble Shooting 19
Specification 20
3
4
Safety precautions
Before operating the receiver, please thoroughly read the following safety precautions.
You are required to read all the notes, instructions and warnings contained in this User
Manual
Basic safety precautions
Connecting to the mains
·During electrical storms unplug the receiver from the mains.
·To avoid the risk of fire and electric shock, do not expose the receiver to any water.
Keep away from exposure to the sun.
·Don’t open the housing otherwise there is the risk of electric shock.
·Only connect the receiver to a properly installed 100-240V, 50-60 Hz mains socket.
· When appliance is not used for long periods of time, please disconnect the plug from
the mains.
· If objects or liquids enter the receiver, immediately unplug power from mains. Refer
appliance to a qualified service technician before using it again otherwise there is a risk
of electric shock.
· Please make sure that the power supply (socket) is easily accessible.
· Do not damage the mains cable.
· If the mains cable is damaged, refer to a qualified DGTEC technician for repair before
using the receiver again otherwise there is the risk of electric shock.
· Do not allow children to use the receiver without supervision.
· Always refer maintenance to a qualified DGTEC technician. Purchase spare parts from
the manufacturer only.
5
Positioning
Place the receiver on a stable, even surface.
Avoid placing it near:
¾Sources of heat
¾Naked flames, like candles,
¾Devices with strong electromagnetic fields, like speakers.
¾Do not place objects filled with liquids (such as vases) on the receiver.
· Avoid direct sunlight and exceptionally dusty places.
· Never cover the ventilation holes. Ensure sufficient ventilation of the receiver.
· Do not place heavy objects on the receiver.
· Humidity can occur inside when moving the receiver from a cold to a warm place. In this
case, wait for about 1 hour before operating the unit.
Run the antenna cable so that no one can step on or stumble across it.
.
General Introduction
UNPACKING
Unpack the unit and check to make sure that all of the following items
are included in the box:
1X Remote Control Unit (RCU)
1X User’s Manual
2X AAA batteries
1X Digital Terrestrial Receiver
1X Composite cable
1X Component Cable
6
7
Front Panel/ Rear Panel
Front Panel
（1） STANDBY: Switches the STB between operation and standby modes.
（2） DISPLAY: Display the channel number while operating and the
timewhileinstandbymode.
（3） CH (-/+): Change channel or items from top to bottom on the menu.
（4） VOL (-/+): Turns up/down volume or changes the page of channel list.
（5） OK: Display the channel list and selects the item on the menu.
（6） MENU: To display the main menu or return to a previous menu.
8
Front Panel/ Rear Panel
Rear Panel
(1) AERIAL IN: Input for antenna.
(2) LOOP OUT: Loop signal output to VCR, etc.
(3) HDMI connection
(4) S/PDIF: S/PDIF audio format output system.
(5) S-VIDEO: S-VHS Video output
(6) Y/Pb/Pr RCA A/V: Component connection (Y/Pb/Pr)
(7) Video RCA A/V: Composite connection
(8) Audio (white: left audio, red: right audio): Right & left audio for Component
connection
(9) RS-232: To connect to your PC for software upgrade (only used by qualified
DGTEC technician)
(10) POWER: Power ON/OFF switch
9
Remote Control Unit
10
Remote Control Unit
1 STANDBY Switch between Operation and Standby mode
2 NUMBERIC
BUTTONS
Changes channels or selects the menu
options.
3 FORMAT
4 EPG Electronic Program Guide button displays the
TV/Radio program guide broadcasting by the
TV provider
5 MENU Turn to the main menu or return to previous
menu
6 VOL (◄/►)Turn up/down volume; Change the page of
channel list.
7 OK Enter into the menu you choose or select the
current option
8 TXT View the Teletext information
9 SUBTL To display the Subtitle text
10 PAUSE Pause to freeze the screen while watching TV
11 AUDIO Change audio mode to left right and stereo
12 MUTE Turn off volume
13 TV/RADIO Switch between TV and Radio mode
14 FAV Enter into favorite list
15 INFO Display information of programs and current
settings
16 EXIT Return to previous menu
17 CH (▲/▼)Change channels or items from top to bottom
on the menu
18 PAGE UP Press to jump one page up or ZOOM up when
enabled
19 PAGE DOWN Press to jump next page or ZOOM down while
zoom is enabled
20 A.RATIO 16:9/4:3
21 RECALL Press to return to previous channel
Installing the batteries in the remote control
1. Press down on the retaining catch on the lid of the battery recess on the remote
control and remove the lid.
2. Insert two AAA batteries into the recess.
Be careful to insert the batteries as shown in the diagram inside the recess.
3. Replace the lid over the recess and gently push down on the lid until it snaps firmly
into place.
Tabla de contenidos
Otros manuales de Receptor de DGTEC
