DFI P4X533-ALE Manual de usuario

P4X533-ALE

Rev. A+

System Board

User’s Manual

80310409

p4x533-ale 80310409 1.pmd 2/18/2004, 8:11 AM1

www.DataSheet4U.com

This publication contains information that is protected by copyright.

No part of it may be reproduced in any form or by any means or

used to make any transformation/adaptation without the prior

written permission from the copyright holders.

This publication is provided for informational purposes only. The

manufacturer makes no representations or warranties with respect to

the contents or use of this manual and specifically disclaims any

express or implied warranties of merchantability or fitness for any

particular purpose. The user will assume the entire risk of the use or

the results of the use of this document. Further, the manufacturer

reserves the right to revise this publication and make changes to its

contents at any time, without obligation to notify any person or

entity of such revisions or changes.

Trademarks

Windows®98, Windows®98 SE, Windows®ME, Windows®2000,

Windows NT®4.0 and Windows®XP are registered trademarks of

Microsoft Corporation. Intel®, Pentium®4 and Celeron are regis-

tered trademarks of Intel Corporation. VIA is a registered trade-

mark of VIA Technologies, Inc. Award is a registered trademark of

Award Software, Inc. Other trademarks and registered trademarks

of products appearing in this manual are the properties of their

respective holders.

Caution

To avoid damage to the system:

•Use the correct AC input voltage range.

To reduce the risk of electric shock:

•Unplug the power cord before removing the system chassis

cover for installation or servicing. After installation or servicing,

cover the system chassis before plugging the power cord.

p4x533-ale 80310409 1.pmd 2/18/2004, 8:11 AM2

www.DataSheet4U.com

Battery:

•Danger of explosion if battery incorrectly replaced.

•Replace only with the same or equivalent type recommend by

the manufacturer.

•Dispose of used batteries according to the battery

manufacturer’s instructions.

FCC and DOC Statement on Class B

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a

residential installation. This equipment generates, uses and can ra-

diate radio frequency energy and, if not installed and used in ac-

cordance with the instruction manual, may cause harmful interfer-

ence to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

•Consult the dealer or an experienced radio TV technician for

help.

Notice:

1. The changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority

to operate the equipment.

2. Shielded interface cables must be used in order to comply with

the emission limits.

p4x533-ale 80310409 1.pmd 2/18/2004, 8:11 AM3

www.DataSheet4U.com

Notice

This user’s manual contains detailed information about the system

board. If, in some cases, some information doesn’t match those

shown in the multilingual manual, the multilingual manual should

always be regarded as the most updated version. The multilingual

manual is included in the system board package.

To view the user’s manual, insert the CD into a CD-ROM drive. The

autorun screen (Mainboard Utility CD) will appear. Click the

“TOOLS” icon then click “Manual” on the main menu.

p4x533-ale 80310409 1.pmd 2/18/2004, 8:11 AM4

www.DataSheet4U.com

Table of Contents

Chapter 1 - Introduction

1.1 Features and Specifications.................................................................................

1.2 Hyper-Threading Technology Functionality Requirements...

1.3 Package Checklist...........................................................................................................

Chapter 2 - Hardware Installation

2.1 System Board Layout ...........................................................................................

2.2 System Memory...........................................................................................................

2.3 CPU........................................................................................................................................

2.4 Jumper Settings.............................................................................................................

2.5 Rear Panel I/O Ports..............................................................................................

2.6 I/O Connectors...........................................................................................................

Chapter 3 - BIOS Setup

3.1 Award BIOS Setup Utility....................................................................................

3.2 VIA RAID BIOS Setting Utility........................................................................

3.3 Updating the BIOS.......................................................................................................

p4x533-ale 80310409 1.pmd 2/18/2004, 8:11 AM5

www.DataSheet4U.com

Introduction

108

Chapter 4 - Supported Softwares

4.1 Desktop Management Interface................................................................

4.2 Drivers, Utilities and Software Applications................................

4.3 Installation Notes.......................................................................................................

Appendix A - Enabling the Hyper-Threading

Technology

A.1 Enabling the Hyper-Threading Technology....................................

Appendix B - Using the Suspend to RAM

Function

B.1 Using the Suspend to RAM Function................................................

Appendix C - System Error Messages

C.1 POST Beep.......................................................................................................................

C.2 Error Messages.............................................................................................................

Appendix D - Troubleshooting

D.1 Troubleshooting Checklist...............................................................................

100

104

110

101

p4x533-ale 80310409 1.pmd 2/18/2004, 8:11 AM6

www.DataSheet4U.com

Introduction

1.1 Features and Specifications

1.1.1 Features

Chipset

•VIA®chipset

-North bridge: VIA®P4X533

-South bridge: VIA® VT8237

Processor

The system board is equipped with Socket 478 for installing one

of the following supported processors.

•Intel®Pentium®4 (Prescott and Northwood) processor up to

2.8+GHz

-Intel Hyper-Threading Technology

-FSB: 800MHz (overclock) / 533MHz / 400MHz

•Intel®Celeron®processor

System Memory

•Two 184-pin DDR DIMM sockets

•Supports up to 2GB using PC1600 (DDR200), PC2100

(DDR266) and PC2700 (DDR333) unbuffered DDR SDRAM

DIMM, 2.6V type

Chapter 1 - Introduction

DIMMs

2MBx64

4MBx64

8MBx64

Memory Size

16MB

32MB

64MB

DIMMs

16MBx64

32MBx64

64MBx64

Memory Size

128MB

256MB

512MB

p4x533-ale 80310409 1.pmd 2/18/2004, 8:11 AM7

www.DataSheet4U.com

Introduction

Expansion Slots

•1 AGP slot

•5 PCI slots

AGP (Accelerated Graphics Port)

AGP is an interface designed to support high performance 3D

graphics cards. It utilizes a dedicated pipeline to access system

memory for texturing, z-buffering and alpha blending. The universal

AGP slot supports AGP 8x with up to 2133MB/sec. bandwidth and

AGP 4x with up to 1066MB/sec. bandwidth for 3D graphics

applications. AGP in this system board will deliver faster and better

graphics to your PC.

Onboard Audio Features

•AC’97 2.2 extension compliant codec

•Supports Microsoft®DirectSound/DirectSound 3D

•AC’97 supported with full duplex, independent sample rate

converter for audio recording and playback

•S/PDIF-out compressed digital output

•6-channel audio output via software

S/PDIF

S/PDIF is a standard audio file transfer format that transfers digital

audio signals to a device without having to be converted first to

an analog format. This prevents the quality of the audio signal

from degrading whenever it is converted to analog. S/PDIF is usu-

ally found on digital audio equipment such as a DAT machine or

audio processing device. S/PDIF on the system board sends

surround sound and 3D audio signal outputs to amplifiers and

speakers and to digital recording devices like CD recorders.

6-channel Audio via Software

The audio jacks at the rear panel will support 6-channel audio

only when the audio utility is configured to support this function.

The mic-in at the rear will be disabled. Use the front audio’s mic-

in jack.

p4x533-ale 80310409 1.pmd 2/18/2004, 8:11 AM8

www.DataSheet4U.com

Introduction

Onboard LAN Features

•Phy fast ethernet controller

•Integrated IEEE 802.3, 10BASE-T and 100BASE-TX compatible

PHY

•32-bit PCI master interface

•Integrated power management functions

•Full duplex support at both 10 and 100 Mbps

•Supports IEEE 802.3u auto-negotiation

•Supports wire for management

Serial ATA (SATA) IDE Interface with RAID

Serial ATA is a storage interface that is compliant with SATA 1.0

specification. With speed of up to 1.5Gbps, it improves hard drive

performance even in data intensive environments such as audio/

video, consumer electronics and entry-level servers.

•Two SATA (Serial ATA) interfaces which are compliant with

SATA 1.0 specification (1.5Gbps interface)

•Supports RAID 0, RAID 1 and JBOD

PCI Bus Master IDE Controller

•Supports ATA/33, ATA/66, ATA/100 and ATA/133 hard drives

•UDMA Modes 3, 4, 5 and 6 Enhanced IDE (data transfer rate

up to 133MB/sec.)

•Bus mastering reduces CPU utilization during disk transfer

•Supports ATAPI CD-ROM, LS-120 and ZIP

USB Ports

The system board supports USB 2.0 and USB 1.1. USB 1.1 sup-

ports 12Mb/second bandwidth while USB 2.0 supports 480Mb/

second bandwidth providing a marked improvement in device

transfer speeds between your computer and a wide range of si-

multaneously accessible external Plug and Play peripherals.

p4x533-ale 80310409 1.pmd 2/18/2004, 8:11 AM9

www.DataSheet4U.com

Introduction

BIOS

•Award BIOS, Windows®98/2000/ME/XP Plug and Play

compatible

•Supports SCSI sequential boot-up

•Flash EPROM for easy BIOS upgrades

•Supports DMI 2.0 function

•4Mbit flash memory

Desktop Management Interface (DMI)

The system board comes with a DMI 2.0 built into the BIOS. The

DMI utility in the BIOS automatically records various information

about your system configuration and stores these information in the

DMI pool, which is a part of the system board's Plug and Play

BIOS. DMI, along with the appropriately networked software, is

designed to make inventory, maintenance and troubleshooting of

computer systems easier. Refer to chapter 4 for instructions on

using the DMI utility.

Rear Panel I/O Ports (PC 99 color-coded connectors)

•One PS/2 mouse port

•One PS/2 keyboard port

•One DB-9 serial port

•One DB-25 parallel port

•One S/PDIF-out RCA jack

•Four USB 2.0/1.1 ports

•One RJ45 LAN port

•Three audio jacks: line-out, line-in and mic-in

I/O Connectors

•Two connectors for 4 additional external USB 2.0/1.1 ports

•One front audio connector for external line-out and mic-in

jacks

•One CD-in internal audio connector

•Two Serial ATA connectors

•Two IDE connectors

•One floppy connector

•Two ATX power supply connectors

•Two fan connectors

p4x533-ale 80310409 1.pmd 2/18/2004, 8:11 AM10

www.DataSheet4U.com

Tabla de contenidos

Otros manuales de Placa madre de DFI

DFI

DFI 790fx-m2r Manual de usuario

DFI

DFI 845PE-ML Manual de usuario

DFI

DFI CS35-EC Manual de usuario

DFI

DFI LANParty UT ICFX3200-T2R/G Manual de usuario

DFI

DFI LanParty NF3 Ultra-DF Manual de usuario

DFI

DFI G7B630-N Manual de usuario

DFI

DFI CMS631-Q470E/H420E Manual de usuario

DFI

DFI CB50-V3 Manual de usuario

DFI

DFI KD630-H110 Manual de usuario

DFI

DFI AL170 Manual de usuario

DFI

DFI AL102 Manual de usuario

DFI

DFI CP100-NRM Manual de usuario

DFI

DFI E586-ICP Manual de usuario

DFI

DFI 865pe infinity Manual de usuario

DFI

DFI CS181 Manual de usuario

DFI

DFI Blood-Iron G41-T33 Manual de usuario

DFI

DFI SB630-CRM Manual de usuario

DFI

DFI LanParty UT NF590 SLI-M2R/G Manual de usuario

DFI

DFI PR611-C621 Manual de usuario

DFI

DFI ak75-ec A+ Manual de usuario

DFI

DFI AD73 RAID Manual de usuario

DFI

DFI 586ITBD Manual de usuario

DFI

DFI CS632-Q370 Manual de usuario

DFI

DFI ADS310-R680E Series Manual de usuario

Manuales populares de Placa madre de otras marcas

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Manual de usuario