DFI P4X400-A Manual de usuario

P4X400-A

P4X400-AL

Rev. A+

System Board

User’s Manual

71300311

This publication contains information that is protected by copyright.

No part of it may be reproduced in any form or by any means or

used to make any transformation/adaptation without the prior

written permission from the copyright holders.

This publication is provided for informational purposes only. The

manufacturer makes no representations or warranties with respect to

the contents or use of this manual and specifically disclaims any

express or implied warranties of merchantability or fitness for any

particular purpose. The user will assume the entire risk of the use or

the results of the use of this document. Further, the manufacturer

reserves the right to revise this publication and make changes to its

contents at any time, without obligation to notify any person or

entity of such revisions or changes.

Trademarks

Windows® 98, Windows® 98 SE, Windows® ME, Windows® 000,

Windows NT® 4.0 and Windows® XP are registered trademarks of

Microsoft Corporation. Intel® and Pentium® 4 are registered

trademarks of Intel Corporation. VIA is a registered trademark of

VIA Technologies, Inc. Award is a registered trademark of Award

Software, Inc. Other trademarks and registered trademarks of

products appearing in this manual are the properties of their

respective holders.

Caution

To avoid damage to the system:

• Use the correct AC input voltage range.

To reduce the risk of electric shock:

• Unplug the power cord before removing the system chassis

cover for installation or servicing. After installation or servicing,

cover the system chassis before plugging the power cord.

Battery:

• Danger of explosion if battery incorrectly replaced.

• Replace only with the same or equivalent type recommend by

the manufacturer.

• Dispose of used batteries according to the battery

manufacturer’s instructions.

Joystick or MIDI port:

• Do not use any joystick or MIDI device that requires more than

10A current at 5V DC. There is a risk of fire for devices that

exceed this limit.

FCC and DOC Statement on Class B

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC rules.

These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a residential

installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio TV technician for

help.

Notice:

1. The changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority

to operate the equipment.

. Shielded interface cables must be used in order to comply with

the emission limits.

Notice

This user’s manual contains detailed information about the system

board. If, in some cases, some information doesn’t match those

shown in the multilingual manual, the multilingual manual should

always be regarded as the most updated version. The multilingual

manual is included in the system board package.

To view the user’s manual, insert the CD into a CD-ROM drive. The

autorun screen (Main Board Utility CD) will appear. Click “User’s

Manual”.

System Board

This user’s manual is for the P4X400-A and P4X400-AL system

boards. The only difference between these boards is the P4X400-AL

system board supports onboard LAN.

Table of Contents

Chapter 1 - Introduction

1.1 Features and Specifications..................................................................................

1. Hyper-Threading Technology Functionality Requirements..........

1.3 Package Checklist.........................................................................................................

Chapter 2 - Hardware Installation

.1 System Board Layout ...........................................................................................

. System Memory...........................................................................................................

.3 CPU........................................................................................................................................

.4 Jumper Settings.............................................................................................................

.5 Rear Panel I/O Por ts..............................................................................................

.6 I/O Connectors...........................................................................................................

Chapter 3 - Award BIOS Setup Utility

3.1 The Basic Input/Output System.....................................................................

3.1.1 Standard CMOS Features.............................................................

3.1. Advanced BIOS Features..............................................................

3.1.3 Advanced Chipset Features ......................................................

3.1.4 Integrated Peripherals.........................................................................

3.1.5 Power Management Setup............................................................

3.1.6 PnP/PCI Configurations....................................................................

3.1.7 Frequency/Voltage Control............................................................

3.1.8 Load Fail-Safe Defaults.....................................................................

3.1.9 Load Optimized Defaults..............................................................

3.1.10 Set Supervisor Password...............................................................

3.1.11 Set User Password..............................................................................

3.1.1 Save & Exit Setup.................................................................................

3.1.13 Exit Without Saving..............................................................................

3. Updating the BIOS.....................................................................................................

Introduction

119

Chapter 4 - Supported Softwares

4.1 Desktop Management Interface.................................................................

4. Drivers, Utilities and Software Applications.....................................

4.3 3D Audio Configuration....................................................................................

4.4 Installation Notes......................................................................................................

Appendi A - Enabling the Hyper-Threading

Technology

A.1 Enabling the Hyper-Threading Technology...........................................

Appendi B - Using the Suspend to RAM

Function

B.1 Using the Suspend to RAM Function...................................................

Appendi C - System Error Messages

C.1 POST Beep....................................................................................................................

C. Error Messages...........................................................................................................

Appendi D - Troubleshooting

D.1 Troubleshooting Checklist.................................................................................

108

111

115

1 1

Introduction

1.1 Features and Specifications

1.1.1 Features

Chipset

• VIA® P4X400 chipset

- VT8754/VT8 35CE

Processor

The system board is equipped with Socket 478 for installing one of

the following supported processors.

• Intel® Pentium® 4 Processor with Hyper-Threading Technology -

533MHz FSB

• Intel® Pentium® 4 processor (478-pin)

- 533MHz system data bus

- 400MHz system data bus

• Intel® Celeron® processor (478-pin)

- 400MHz system data bus

Note:

Refer to section 1.2 and appendix A for more information on

the Hyper-Threading Technology.

System Memory

• Three 184-pin DDR DIMM sockets

• Supports up to 3GB using PC1600 (DDR 00), PC 100

(DDR 66), PC 700 (DDR333) or PC3 00 (DDR400)

unbuffered DDR SDRAM DIMM, .5V type

Chapter 1 - Introduction

DIMMs

2MBx64

4MBx64

8MBx64

Memory Size

16MB

32MB

64MB

DIMMs

16MBx64

32MBx64

64MBx64

Memory Size

128MB

256MB

512MB

Introduction

Expansion Slots

The system board is equipped with 1 AGP slot and 5 PCI slots.

AGP (Accelerated Graphics Port

AGP is an interface designed to support high performance 3D

graphics cards. It utilizes a dedicated pipeline to access system

memory for texturing, z-buffering and alpha blending. The universal

AGP slot supports AGP 8x with up to 133MB/sec. bandwidth and

AGP 4x with up to 1066MB/sec. bandwidth for 3D graphics

applications. AGP in this system board will deliver faster and better

graphics to your PC.

Onboard Audio Features

• Supports Microsoft® DirectSound/DirectSound 3D

• AC’97 supported with full duplex, independent sample rate

converter for audio recording and playback

• S/PDIF-in/out compressed digital output

• 6-channel audio output

Onboard LAN Features (P4X400-AL only

• Integrated LAN controller

• Integrated IEEE 80 .3, 10BASE-T and 100BASE-TX compatible

PHY

• 3 -bit PCI master interface

• Integrated power management functions

• Full duplex support at both 10 and 100 Mbps

• Supports IEEE 80 .3u auto-negotiation

• Suppor ts wire for management

Rear Panel I/O Ports (PC 99 color-coded connectors

• Two USB .0/1.1 ports

• One RJ45 LAN port (P4X400-AL only)

• Two DB-9 serial ports

• One DB- 5 parallel port

• One mini-DIN-6 PS/ mouse port

• One mini-DIN-6 PS/ keyboard port

• One game/MIDI port

• Three audio jacks: line-out, line-in and mic-in

Introduction

I/O Connectors

• Two connectors for 4 additional external USB .0/1.1 ports

• One front audio connector for external line-out and mic-in jacks

• Two internal audio connectors (AUX-in and CD-in)

• One 4-channel audio output connector

• One S/PDIF-in/out connector

• One connector for IrDA interface

• Two IDE connectors

• One floppy drive interface supports up to two .88MB floppy

drives

• Two ATX power supply connectors

• One Wake-On-LAN connector

• CPU fan and chassis fan connectors

PCI Bus Master IDE Controller

• Two PCI IDE interfaces support up to four IDE devices

• Supports ATA/33, ATA/66, ATA/100 and ATA/133 hard drives

• UDMA Modes 3, 4, 5 and 6 Enhanced IDE (data transfer rate

up to 133MB/sec.)

• Bus mastering reduces CPU utilization during disk transfer

• Supports ATAPI CD-ROM, LS-1 0 and ZIP

S/PDIF

S/PDIF is a standard audio file transfer format that transfers digital

audio signals to a device without having to be converted first to an

analog format. This prevents the quality of the audio signal from

degrading whenever it is converted to analog. S/PDIF is usually

found on digital audio equipment such as a DAT machine or audio

processing device. The S/PDIF connector on the system board sends

surround sound and 3D audio signal outputs to amplifiers and

speakers and to digital recording devices like CD recorders.

6-channel Audio

The 4-channel audio connector which supports four audio output

signals: center channel, subwoofer, rear right channel and rear left

channel; together with the line-in and mic-in jacks (at the rear panel)

support 6-channel audio output.

Introduction

IrDA Interface

The system board is equipped with an IrDA connector for wireless

connectivity between your computer and peripheral devices. The

IRDA (Infrared Data Association) specification supports data

transfers of 115K baud at a distance of 1 meter.

USB Ports

The system board supports USB .0 and USB 1.1. USB 1.1

supports 1 Mb/second bandwidth while USB .0 supports 480Mb/

second bandwidth providing a marked improvement in device

transfer speeds between your computer and a wide range of

simultaneously accessible external Plug and Play peripherals.

BIOS

• Award BIOS, Windows® 98/ 000/ME/XP Plug and Play

compatible

• Supports SCSI sequential boot-up

• Flash EPROM for easy BIOS upgrades

• Supports DMI .0 function

• Mbit flash memory

Desktop Management Interface (DMI

The system board comes with a DMI .0 built into the BIOS. The

DMI utility in the BIOS automatically records various information

about your system configuration and stores these information in the

DMI pool, which is a part of the system board's Plug and Play

BIOS. DMI, along with the appropriately networked software, is

designed to make inventory, maintenance and troubleshooting of

computer systems easier. Refer to chapter 4 for instructions on using

the DMI utility.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Placa madre de DFI

DFI

DFI FS051 Manual de usuario

DFI

DFI AL051 Manual de usuario

DFI

DFI AL171 Manual de usuario

DFI

DFI HD101-H81 Manual de usuario

DFI

DFI Infinity NF series Manual de usuario

DFI

DFI KD630-H110C Manual de usuario

DFI

DFI HD332-H81 Manual de usuario

DFI

DFI AD73 Pro Manual de usuario

DFI

DFI G586VPS Pro Manual de usuario

DFI

DFI WL551 Manual de usuario

DFI

DFI GHF51 Manual de usuario

DFI

DFI CMS311-W480E/Q470E Manual de usuario

DFI

DFI CS620-H310 Manual de usuario

DFI

DFI LanParty DK P35 series Manual de usuario

DFI

DFI Infinity NF650I Ultra Manual de usuario

DFI

DFI SB336-Ni Manual de usuario

DFI

DFI SB331-D Manual de usuario

DFI

DFI CS103-C246 Manual de usuario

DFI

DFI G5M300-P Manual de usuario

DFI

DFI SR330-N Manual de usuario

DFI

DFI CS551-Q370 Manual de usuario

DFI

DFI KD631-C236/Q170 Manual de usuario

DFI

DFI AD73 Pro Manual de usuario

DFI

DFI CS170-Q370/C246 Manual de usuario

Manuales populares de Placa madre de otras marcas

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Manual de usuario