DFI CA64-TC Manual de usuario
CA64-TC
CA64-TN
Rev. A+
System Board Users Manual
Carte Mère Manuel Pour Ut l sateur
System-Plat ne Benutzerhandbuch
Tablero Electrón co del S stema Manual del Usuar o
49820127
Copyr ght
This publication contains information that is protected by copyright.
No part of it may be reproduced in any form or by any means or
used to make any transformation/adaptation without the prior
written permission from the copyright holders.
This publication is provided for informational purposes only. The
manufacturer makes no representations or warranties with respect to
the contents or use of this manual and specifically disclaims any
express or implied warranties of merchantability or fitness for any
particular purpose. The user will assume the entire risk of the use or
the results of the use of this document. Further, the manufacturer
reserves the right to revise this publication and make changes to its
contents at any time, without obligation to notify any person or
entity of such revisions or changes.
© 001. All Rights Reserved.
Trademarks
Microsoft® MS-DOS®, WindowsTM, Windows® 95, Windows® 98,
Windows® 98 SE, Windows® ME, Windows® 000 and Windows
NT® 4.0 are registered trademarks of Microsoft Corporation. Intel®,
Pentium® III and CeleronTM are registered trademarks of Intel
Corporation. VIA C3 is a registered trademark of VIA Technologies,
Inc. Award is a registered trademark of Award Software, Inc. Other
trademarks and registered trademarks of products appearing in this
manual are the properties of their respective holders.
Caut on
To avoid damage to the system:
Use the correct AC input voltage range.
To reduce the risk of electric shock:
Unplug the power cord before removing the system chassis
cover for installation or servicing. After installation or servicing,
cover the system chassis before plugging the power cord.
Battery:
Danger of explosion if battery incorrectly replaced.
Replace only with the same or equivalent type recommend by
the manufacturer.
Dispose of used batteries according to the battery
manufacturers instructions.
Joystick or MIDI port:
Do not use any joystick or MIDI device that requires more than
10A current at 5V DC. There is a risk of fire for devices that
exceed this limit.
FCC and DOC Statement on Class B
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio TV technician for
help.
Notice:
1. The changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
. Shielded interface cables must be used in order to comply with
the emission limits.
4
Quick Setup Guide
Qu ck Setup
Gu de
Table of Contents
Chapter 1
Quick Setup Guide.............................................
Chapter 2
nglish......................................................................
Chapter 3
Français (French).................................................
Chapter 4
Deutsch (German)................................................
Chapter 5
spañol (Spanish)..................................................
5
24
39
56
73
Note:
The users manual in the provided CD contains detailed information
about the system board. If, in some cases, some information doesnt
match those shown in this manual, this manual should always be
regarded as the most updated version.
5
Quick Setup Guide
Qu ck Setup
Gu de
Chapter 1 - Quick Setup Guide
Table of Contents
1.1 System Board Layout..................................................................................................
1. Jumpers.....................................................................................................................................
1.3 Ports and Connectors................................................................................................
1.4 Award BIOS Setup Utility.......................................................................................
6
8
11
19
6
Quick Setup Guide
Qu ck Setup
Gu de
1.1 System Board Layout
CA64-TC
(Supports nboard Audio)
7
Quick Setup Guide
Qu ck Setup
Gu de
CA64-TN
Note:
The illustrations on the following pages are based on the CA64-TC
system board, which is the board that supports onboard audio.
8
Quick Setup Guide
Qu ck Setup
Gu de
1.2 Jumpers
1.2.1 Frequency Ratio Settings - SW1
Important:
The frequency ratio of some processors shown in the table may
have been locked by the manufacturer. If you are using this kind
of processor, setting an extended ratio for the processor will have
no effect. The system will instead use its factor y default ratio.
*** denotes future processors.
700MHz --- 10.5x
--- 4.5x
--- 5x
Processor SW1
66MHz 100MHz
Freq.
Ratio
5.5x
Processor SW1
66MHz 100MHz
Freq.
Ratio
---
---
---
---
6x
6.5x
7x
7.5x
8x---
500MHz
---
133MHz 133MHz
650MHz
700MHz 933MHz
866MHz
800MHz
750MHz 1GHz
800MHz
667MHz
733MHz
---
550MHz
600MHz
600MHz
---
8.5x
9x
9.5x
10x
11x
566MHz 850MHz
600MHz 900MHz
1.13GHz
1. GHz
1. 6GHz
--- ---
633MHz 950MHz
667MHz ---
***
***
--- 11.5x
--- 1 x
--- ***
--- ***
***
9
Quick Setup Guide
Qu ck Setup
Gu de
Most processors with frequency ratio greater than 8x have
locked frequency ratio therefore does not have the flexibility of
using extended ratio. If your processor does not have locked
frequency ratio, you can set SW1 according to the desired ratio.
The processors supported by the system board support VID
(Voltage Identification). The switching voltage regulator on the
system board will automatically set the voltage regulator
according to the voltage of the processor.
1.2.2 CPUs Front Side Bus - JP1 and JP2
Warning:
Some processors, when overclocked, may result to the processors or
systems instability and are not guaranteed to provide better system
performance. If you are unable to boot your system due to
overclocking, make sure to set these jumpers back to their default
settings.
Auto*
66MHz
100MHz
133MHz
JP1
1- On
-3 On
-3 On
All Off
JP2
1- On
-3 On
All Off
1- On
* denotes default setting
1 3
1- On
1 3
1 3
-3 On
All Off
10
Quick Setup Guide
Qu ck Setup
Gu de
1.2.3 Clear CMOS Data - JP3
-3 On:
Clear CMOS Data
1- On: Normal
(default)
1
3
1
3
Otros manuales para CA64-TC
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Placa madre de DFI
DFI
DFI NB76-BC Manual de usuario
DFI
DFI CMS631-Q470E/H420E Manual de usuario
DFI
DFI ADS630-R680E Manual de usuario
DFI
DFI BL630-DR Manual de usuario
DFI
DFI P4X400-A Manual de usuario
DFI
DFI Blood-iron P45 Series Manual de usuario
DFI
DFI G686IPA Manual de usuario
DFI
DFI PT880-AL Manual de usuario
DFI
DFI C586VX/E Manual de usuario
DFI
DFI NS70-EC Manual de usuario
DFI
DFI CS101-H310 Manual de usuario
DFI
DFI SB600-C Manual de usuario
DFI
DFI LanParty UT CFX3200-DR Manual de usuario
DFI
DFI P2XBL/D Manual de usuario
DFI
DFI PB61-ZX Manual de usuario
DFI
DFI P5BV3+/e Manual de usuario
DFI
DFI FS051 Manual de usuario
DFI
DFI TGU171 Manual de usuario
DFI
DFI EB3486-TN Manual de usuario
DFI
DFI LanParty 925X-T2 Manual de usuario
Manuales populares de Placa madre de otras marcas
Gigabyte
Gigabyte GA-9IVDT Manual de usuario
Texas Instruments
Texas Instruments ADS8372EVM Manual de usuario
Commell
Commell MS-C73 Manual de usuario
IBT Technologies
IBT Technologies MB860 Manual de usuario
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manual de usuario
Biostar
Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación
