Dezac Rio CWAX3 Manual de usuario

PROFESSIONAL

WAX HEATER

ENGLISH 4

FRANÇAIS 10

DEUTSCH 16

NEDERLANDS 22

ESPAÑOL 28

PORTUGUÊS 34

ITALIANO 40

WARNINGS

• Please read all instructions thoroughly and retain for future reference.

• Keep out of reach from children and pets.

• This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience

and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance. Cleaning and maintenance shall not be made by children without supervision.

• This appliance MUST be earthed.

• If you suffer from a skin condition, consult your dermatologist before use.

• Do not use on cuts or broken skin.

• Do not use on areas that have had cosmetic surgery.

• The appliance may be cleaned by wiping with a damp cloth. Do NOT use solvents or abrasive cleaners.

• Do NOT use this appliance if it is not working properly. If the power lead is damaged, it must be replaced by the manufacturer or its service agent or

similarly qualified person in order to avoid a hazard.

ENGLISH

KNOW YOUR UNIT

1Lid

2Removeable Pan

3Power Input

4Temperature or timer display

5°C indicator

6Up (Increase)

7Down (decrease)

8Solid wax programme

9Soft wax programme

0Delay timer

!Start/Stop

@Power cord

£Heating

9Soft wax programme

0Delay timer

!Start/Stop

@Power cord

£Heating

PATCH TEST

Always do a patch test on the inside of your forearm or on a small area of your skin for possible skin reaction.

Wait 24 hours. If irritation occurs do not use this product.

IMPORTANT INFORMATION

• This product is intended for use by persons who are experienced in waxing.

• The displayed temperature is for the heater not the wax. The heating dot (£) next to the displayed temperature

indicates when the wax is being heated.

• Always test the wax temperature by applying only a small amount of wax to the skin.

• Always follow the instructions provided with the wax you are using.

• Persons insensitive to heat must be careful when using the appliance.

• During the 24-hour period following your treatment, you should avoid hot baths, tanning beds, saunas or other heat

treatments.

• In case of burns, run the affected area under cold water for at least 10 minutes and seek medical advice.

• If you feel tingling or severe pain during use, remove the wax immediately and rinse thoroughly with water.

If sensation persists, seek medical advice.

Some waxes specify a specific temperature for use. The heater temperature can be adjusted using the UP and DOWN buttons before

pressing the start button.

ADJUSTING THE HEATER TEMPERATURE

DELAY TIMER

STEP 1

Press the Delay Timer button.

STEP 2

Use the UP and DOWN buttons to adjust the delay timer

to between 0.5 hours and 24 hours.

NOTE: To reset the temperature or delay timer while the unit is in use, p ress Start/Stop to deactivate the current setting, then use the UP and

DOWN buttons to adjust as above.

GETTING STARTED

STEP 1

Press the Start button and the unit will start heating. The heater will rapidly rise to the 90°C pre-set temperature.

STEP 2

Stir every 10 minutes until the wax is at the desired consistency for use.

STEP 3

Depending on the amount of wax being heated it will take between 30 and 60 minutes to heat the wax to

approximately 90°C. The wax temperature will then be maintained.

Connect the power cord to the unit and plug into the mains supply.

STEP 3

Press the Start/Stop button to set the time delay.

SOLID WAX

• Add a quantity of solid wax to the wax pot and place in the heater.

• Press the Solid Wax button, then press the Start/Stop button.

• The heating element temperature increases to 125°C and heats the wax for approximately 45 minutes and then reduces to 90°C. The wax

temperature is then maintained at approximately 90°C.

Important: Only use the wax when the indicated temperature is 90°C.

• To end the programme press either the Solid wax button or the Start/stop button.

SOFT WAX

• Place the soft wax container in the heater.

• Press the Soft Wax button, then press the Start/Stop button.

• The heater temperature increases to 135°C and heats the wax for approximately 45 minutes and then reduces to 90°C. The wax

temperature is then maintained at approximately 90°C.

Important: Only use the wax when the indicated temperature is approximately 90°C.

• Stir wax every 10 minutes while heating.

• To end the programme press the Soft Wax button or the Start/Stop button.

QUICK HEAT UP PROGRAMMES

STEP 2

Stir every 10 minutes until the wax is at the desired consistency for use.

STEP 3

Depending on the amount of wax being heated it will take between 30 and 60 minutes to heat the wax to

approximately 90°C. The wax temperature will then be maintained.

Read these instructions carefully

before use and then retain for

future use.

This product is for indoor use only. This product complies with current

EU product legisl

AFTER USE

CLEANING & MAINTENANCE

• Unplug the wax heater, clean off residue wax and allow it to completely cool.

• Store in a cool, dry place.

For best results, clean away excess wax while the unit is still hot.

To do this:

• Unplug the power supply.

• Use a hot wax cleaner applied to a cloth to remove any wax.

SPECIFICATION

Model: CWAX3

Capacity: 500ml

Voltage: 230V~50 Hz

Power: 110W

Temperature: 30-150°C (86-275°F)

DISPOSAL

The Waste of Electrical and Electronic Equipment (WEEE) Directive (2012/19/EU) has been put in place to recycle products using

best available recovery and recycling techniques to minimise the impact on the environment, treat any hazardous substances

and avoid the increasing landfill. This product is classed as Electrical or Electronic equipment so please ensure that at the end

of the life of this product it is disposed of in the correct manner in accordance with local authority requirements. It must NOT be

disposed of with household waste.

CUSTOMER CARE

If you have any questions, please contact us at: [email protected]

To reorder additional accessories, please visit

www.riobeauty.com or contact your local distributor.

GUARANTEE

To register your two year guarantee online, visit: www.riobeauty.com/warranty_online.htm

FRANÇAIS

PRÉCAUTIONS D’EMPLOI

• Veuillez lire attentivement toutes les consignes et les conserver pour pouvoir vous yréférer ultérieurement.

• Conservez hors de la portée des enfants et des animaux domestiques.

• Cetappareilpeutêtreutilisépardesenfantsâgésde8ansetplusetpardespersonnesauxcapacitésphysiques,sensoriellesoumentalesréduites

ou présentant un manque d’expérience et de connaissances si ces enfants ou ces personnes sont supervisés ou ont reçu des instructions concernant

l’utilisation de l’appareil en toute sécurité et comprennent les dangers potentiels. Les enfants ne doivent pas jouer avec l’appareil. Les enfants ne

doivent ni nettoyer ni entretenir l’appareil sans surveillance.

• CetappareilDOITêtreraccordéàlaterre.

• Si vous présentez une affection cutanée, consultez votre dermatologue avant utilisation.

• Ne pas utiliser sur des coupures ou sur une peau abîmée.

• Ne pas utiliser sur les zones ayant subi une chirurgie esthétique.

• Pour nettoyer l’appareil, essuyez avec un chiffon humide. Ne PAS utiliser de solvants ni de détergents abrasifs.

• Ne PAS utiliser cet appareil s’il ne fonctionne pas correctement. Si le cordon d’alimentation est endommagé, il doit être remplacé par le fabricant ou

son représentant ou toute autre personne qualifiée, afin d’éviter tout danger possible.

VOUS FAMILIARISER AVEC VOTRE APPAREIL

1Couvercle

2Cuve amovible

3Entrée alimentation

4Affichage de la température ou

de la minuterie

5Indicateur °C

6PLUS (augmentation)

7MOINS (diminution)

8Programme cire dure

9Programme cire molle