Find a Location for the Domain 3000
Remove the Domain 3000, antenna, and Powered RF Antenna from
the box.
Install the Domain 3000 at or near its final location such that the IR
emitters can reach all of your AV components. An Internet connection
is useful, but not necessary. You should be able to easily see the
Domain 3000 while working from your PC.
Attach IR Emitters to your AV Components
To find out where the IR receiver is located on the AV component, use
a sheet of cardboard with a small hole in the middle of it. Place the
cardboard against the front of the AV component and move the hole
around the front while sending IR commands to the AV component via
the remote control that came with it. There should only be a small area
where the IR commands can be received. That area is the IR receiver.
Paste the IR emitter on top of it.
If you have a back projection TV and the IR receiver is behind the
screen (i.e., there is not a separate IR pick up any where on the TV),
then your choices for controlling it are: use RS-232, open the unit and
attach the emitter directly to the receiver (often easier than it sounds),
use a high power blaster.
