DeltaOhm | HD32MT.1 HD32MT TCPIP Server.docx
Run the software \\Deltaohm\Programs\IP_Modem\IP Modem Configure.exe
Click Close and choose the right COM number of your PC (baudrate=115200,Parity=None), then
press Open and immediately Power on the IP MODEM (power supply of the Configuration
Cable). Take attention that the Config option should be set.
Re-Power if the software doesn’t reach the IP MODEM in the Output info.
Data Service Center Settings (Figure 2)
Put your router IP fix address (here example is 177.120.61.84) and/or TCPIP domain in the Main
Center, and if you use others address in the Backup Center and 2nd Center domain.
Near the address, put your Port number (here example is 1725) opened to your PC
Note: previously on the router, a port number must be open to your PC.
Put Main, Backup, 2nd , Center DNS.
Press the Save button. Check in Output Info the correct saving by the OK messages.
Press again the Save button if some parameter show “Save… Failed” [*].
Figure 2
IP Modem Setting (Figure 3)
Check the correct setting correspond to the below figure. It’s important to set:
Debug Level: 0
Connect Retry Times: 1000
Reconnect Time Interval: 15
Transfer Meaning: 1
Press the Save button. Check in Output Info the correct saving by the OK messages.
Press again the Save button if some parameter show “Save… Failed” [*].
Figure 3
