Dell PowerConnect 8024 Manual de usuario

www.dell.com | support.dell.com

הדובע תליחת ךירדמ

Dell™ PowerConnect™

8024 and 8024F Switches

Getting Started Guide

使用入门指南

入門指南

Guide de mise en route

Handbuch zum Einstieg

Panduan Pengaktifan

はじめに

시작 안내서

Guía de introducción

Başlangıç Kılavuzu

Model PC8024 and PC8024F

www.dell.com | support.dell.com

Dell™ PowerConnect™

8024 and 8024F Switches

Getting Started Guide

Model PC8024 and PC8024F

Notes, Notices, and Cautions

NOTE: A NOTE indicates important information that helps you make better use of your computer.

NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem.

CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.

____________________

Information in this document is subject to change without notice.

Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.

Trademarks used in this text: Dell, the DELL logo, and PowerConnect are trademarks of Dell Inc.; Microsoft and Windows are registered

trademarks of Microsoft Corporation.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products.

Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.

Model PC8024 and PC8024F

November 2009 P/N X472K Rev. A02

Contents

Installation

Site Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Unpacking the Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Package Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Unpacking Steps . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Mounting the Switch. . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Installing in a Rack . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Installing as a Free-standing Switch . . . . . . . . . . . . . . . . . . 7

Connecting a Switch to a Terminal . . . . . . . . . . . . . . . . . . . . . 7

Connecting a Switch to a Power Supply . . . . . . . . . . . . . . . . . . 8

Starting and Configuring the Switch

Connecting the Terminal to the Switch . . . . . . . . . . . . . . . . . . . 9

Booting the Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Initial Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Management Interface and Out-of-Band Interface . . . . . . . . . . . 11

Initial Configuration Procedure. . . . . . . . . . . . . . . . . . . . . 11

Example Session . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Advanced Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . 15

Retrieving an IP Address From a DHCP Server . . . . . . . . . . . . . 15

Security Management and Password Configuration. . . . . . . . . . . 16

Managing the Switch

Using a Web Browser to Manage the Switch . . . . . . . . . . . . . . . . 19

Starting the Application . . . . . . . . . . . . . . . . . . . . . . . . 19

Understanding the Interface . . . . . . . . . . . . . . . . . . . . . . 19

Getting Started Guide 5

Installation

This document provides basic information to install, configure, and operate

Dell™ PowerConnect™ 8024 and 8024F systems. For more information, see the

User’s Guide

which is available on your

User Documentation

CD, or check the Dell Support web site at

support.dell.com

for the latest updates on documentation and firmware.

Site Preparation

PowerConnect 8024 and 8024F switches can be mounted in a standard 48.26-cm (19-inch) rack

or left freestanding (placed on a flat surface) and function as stand-alone switches.

Before installing the switch or switches, make sure that the chosen installation location meets

the following site requirements:

•

Power

— The switch is installed near an easily accessible 100–250 VAC, 50–60 Hz outlet.

•

Clearance

— There is adequate front and rear clearance for operator access. Allow clearance

for cabling, power connections, and ventilation.

•

Cabling

— The cabling is routed to avoid sources of electrical noise such as radio

transmitters, broadcast amplifiers, power lines, and fluorescent lighting fixtures.

•

Ambient

— The ambient switch operating temperature range is 0 to 45ºC (32 to 113ºF) at a

relative humidity of up to 95 percent, non-condensing.

Unpacking the Switch

Package Contents

When unpacking each switch, make sure that the following items are included:

• One PowerConnect switch

• Two AC power cables

• One RJ-45 to DB9 female cable

• One rack-mount kit for rack installation (two mounting brackets, bolts, and cage nuts)

• One set of self-adhesive rubber pads for the free-standing switch (four pads are included)

•

User Documentation

• Getting Started Guide

• Product Information Guide

6Getting Started Guide

www.dell.com | support.dell.com

Unpacking Steps

NOTE: Before unpacking the switch, inspect the container and immediately report any evidence

of damage.

Place the container on a clean, flat surface and cut all straps securing the container.

Open the container or remove the container top.

Carefully remove the switch from the container and place it on a secure and clean surface.

Remove all packing material.

Inspect the product and accessories for damage.

Mounting the Switch

CAUTION: Read the safety information in the Product Information Guide as well as the safety

information for other switches that connect to or support the switch.

The two AC power connectors are on the back panel of the switch.

Installing in a Rack

CAUTION: Do not use rack mounting kits to suspend the switch from under a table or desk, or attach it

to a wall.

CAUTION: Disconnect all cables from the switch before continuing. Remove all self-adhesive pads

from the underside of the switch, if they have been attached.

CAUTION: When mounting multiple switches into a rack, mount the switches from the bottom up.

Place the supplied rack-mounting bracket on one side of the switch, ensuring that the

mounting holes on the switch line up to the mounting holes in the rack-mounting bracket.

Figure 1 illustrates where to mount the brackets.

Figure 1. Attaching the Brackets

Getting Started Guide 7

Insert the supplied bolts into the rack-mounting holes and tighten with a screwdriver.

Repeat the process for the rack-mounting bracket on the other side of the switch.

Insert the switch into the 48.26 cm (19 inch) rack, ensuring that the rack-mounting holes on

the switch line up to the mounting holes in the rack.

Secure the switch to the rack with either the rack bolts or cage nuts and cage nut bolts with

washers (depending on the kind of rack you have). Fasten the bolts on bottom before

fastening the bolts on top.

NOTICE: Make sure that the ventilation holes are not obstructed.

CAUTION: Make sure that the supplied rack bolts fit the pre-threaded holes in the rack.

Installing as a Free-standing Switch

NOTICE: We strongly recommend mounting the switch in a rack.

Install the switch on a flat surface if you are not installing it in a rack. The surface must be able

to support the weight of the switch and the switch cables. The switch is supplied with four

self-adhesive rubber pads.

Attach the self-adhesive rubber pads on each location marked on the bottom of the switch.

Set the switch on a flat surface, and make sure that it has proper ventilation by leaving 5 cm

(2 inches) on each side and 13 cm (5 inches) at the back.

Connecting a Switch to a Terminal

Connect the DB9 connector of the RJ-45-to-DB9 serial cable to a VT100 terminal or to a

computer running VT100 terminal emulation software.

Connect the RJ-45 connector at the other end to the top RJ-45 port on the rear panel of the

switch. For more information about the location of the console port, see Figure 3.

8Getting Started Guide

www.dell.com | support.dell.com

Connecting a Switch to a Power Supply

CAUTION: Read the safety information in the Product Information Guide as well as the safety

information for other switches that connect to or support the switch.

The PowerConnect 8024 and 8024F switches have two power supplies for redundant or load-

sharing operation. Each power supply can support 300W.

Figure 2 illustrates the location of the

two power receptacles on the rear panel.

Connect one of the supplied AC power cables to one of the AC power connectors located on

the rear panel.

To provide a redundant source of power, connect the second supplied AC power cable to the

other AC power connector located on the rear panel.

NOTE: Do not connect the power cable to a grounded AC outlet at this time. Connect the switch to a

power source as described in the step detailed in "Starting and Configuring the Switch".

Figure 2. Connecting Power Cables

Otros manuales para PowerConnect 8024

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Cambiar de Dell

Dell

Dell Networking 7048 Manual de usuario

Dell

Dell PowerConnect J-EX8208 Instrucciones de instalación

Dell

Dell N2128PX-ON Manual de usuario

Dell

Dell PowerConnect W-Series FIPS Manual del propietario

Dell

Dell PowerConnect B-FCXs Manual de usuario

Dell

Dell PowerConnect 2016 Guía del usuario

Dell

Dell PowerConnect W-IAP175P Manual del propietario

Dell

Dell Networking S6000 System Manual de usuario

Dell

Dell S4820T Manual de usuario

Dell

Dell Networking Z9500 Manual de usuario

Dell

Dell S6010-ON Manual de instrucciones

Dell

Dell PowerEdge M IO Aggregator Manual de usuario

Dell

Dell PowerConnect 2124 Guía del usuario

Dell

Dell Force10 TeraScale E Series Manual de usuario

Dell

Dell PowerEdge 180AS Manual de usuario

Dell

Dell EMC PowerSwitch Z9432F-ON Manual de usuario

Dell

Dell PowerConnect 3424 Manual de instrucciones

Dell

Dell Force10 S4810P Manual de usuario

Dell

Dell R1-2401 Manual de usuario

Dell

Dell PowerConnect 2608 Manual de usuario

Dell

Dell PowerVault 51F Manual de usuario

Dell

Dell 5324 - PowerConnect Switch Manual de instrucciones

Dell

Dell S5048F-ON Manual de usuario

Dell

Dell PowerConnect M8428-k Cómo utilizar

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario