Dedrone 1 Safety
IM-Inst-RF30009en 5
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will nopersonal t occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•Reorient or relocate the RF-300.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/television technician for help.
WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE
SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW.
Caution!
To prevent permanent exposure, the device should be installed and operated
with a minimum distance of 20 cm (7.87 in) between the device and your body.
1.3 Safety Information
Read, follow and retain all of the following safety instructions. Heed all warnings on the unit
and in the operating instructions before operation.
Warning! Setup should be carried out by trained personnel only, in accordance
with the national electric code, ANSI/NSPA, and all local country codes.
Do not attempt to service this device yourself. Refer all servicing to qualified
service personnel. This device has no user-serviceable internal parts.
Whenever any damage to the device has occurred, unplug the devices from the
power source by disconnecting the patch cable and refer servicing to qualified
service personnel. Such damages can be:
•the patch cable is damaged
•an object has fallen on the device
•the device has been dropped, or its enclosure has been damaged
•the device does not operate normally when the user follows the operating
instructions correctly
Adjust only those controls specified in the operating instructions. Improper
adjustment of other controls may cause damage to the unit.
Despite careful construction, electrical devices can cause fires. Do not mount the
RF-300 in areas containing highly flammable materials or gases. Do not mount the
RF-300 in a potentially explosive atmosphere.
Do not install product near any heat sources such as radiators, heaters, exhaust air
systems or other equipment (including amplifiers) that produce heat.
