Dedicated Micros NetVu Connected DS2 Instrucciones de instalación y funcionamiento
Addendum
Dedicated Micros ©2007
1
Using IP cameras with NetVu Connected DS2
IP Cameras are congured on the OSD and via the web interface on the unit. The unit uses an on-
screen (OSD) paged menu system to guide users through the installation process. The integrated
web pages allow remote conguration using an internet browser such as Internet Explorer or
Netscape Navigator.
Entering the Menus
There are two types of menu; User and Installer. The Installer menu will enable IP Cameras to be
added. To enter the Installer menu, press and hold the Menu button for approximately 3 seconds.
Note: If a password has been set and enabled it will be necessary to enter the Installer password
to gain access to the menus. This is disabled by default.
Via the OSD
Tap the Menu button until the ‘Camera Setup’ page is displayed. Use the Camera buttons to select
the input to be congured (select an input that does not already have an analogue feed). Use the
down cursor key to highlight the ‘Camera Type’ menu item and select IP Camer
Camera Type
Colour and monochrome cameras are detected automatically, allowing colour/mono switching
cameras to be connected. The camera type can be manually congured as IP Camera, Colour or
Mono if necessary. Selecting IP Camera will show the Edit option to enter the IP camera details.
Edit IP Camera Settings
Camera 1
Type
URL
PORT
Camera number
FPS
NetVu Server
<none>
00000
00
00
See text
000.000.000.000
00001-65535
01 - 64
1 - 99
IP
C
amera
S
etu
p
IP Camera Setup
Camera X
This is the input into the back of the DVR. Since this video feed will be via the network, select a
channel that does not have a physical analogue connection.
Type
The unit can recognise a range of IP cameras as well as digital video feeds from NetVu Servers.
These include;
NetVu Server JVC VN-C20 JVC VN-C625 JVC VN-C655
Axis 2120 Axis 211 Axis 2140 Axis 214 PTZ
AL9710
Note: Other cameras utilising the same stream/telemetry protocol as those listed above
will also be supported.
Note: Refer to the Important Conguration notes below.
Dedicated Micros ©2007
2
URL
Enter the IP address that will send the IP stream
Port
Enter the port number to be used for this stream.
Camera Number
If a NetVu Server is being used, this parameter will specify which camera number from the Server
will be used to provide the stream.
FPS
Enter the frames per second that the camera has been set to deliver.
Via the Web Interface
The unit supports the capability to connect directly to IP Cameras (Cameras connected directly to a
network, broadcasting a digital video stream from an IP address). It can also connect to other NetVu
Connected DVR’s and treat one of the network feeds from that DVR as a digital video stream.
1. Ensure IP Cameras are enabled in the Advanced Features menu (System-
>Advanced Features)
2. Select Cameras->Camera and Record Setup
3. Select a free camera input.
Note: Because the feed for this camera input will be delivered through the network, it is
recommended that you select an input that does not have a camera connected at the back
of the unit.
4. Change the Camera Type for the selected camera input to ‘IP’.
5. Repeat this operation for each of the IP feeds to be connected, save the page.
6. Click on Cameras->IP-Camera and Record Setup to congure each IP camera
feed.
7. The camera type will be lled in for each of the selected IP cameras, logged
against the camera number that was selected.
8. Select the type of IP Camera. If the feed is coming from a NetVu Connected
Server, select NetVu Server.
9. Enter the URL of the IP video source in the next column.
10. If the video feed is coming from a NetVu Connected DVR or a server with multiple ,
enter the camera number on the source that will be used as the feed for this IP camera input. If
If the source is single IP camera,set to camera 1.
11. Enter the xx number into the IPCam Cam column.
12. Enter the Framerate that will be allocated to the camera. This should equate to the
camera’s internal setting - this will be the maximum viewing or recording rate of the IP camera. .
Dedicated Micros ©2007
3
Important Conguration Notes
•Ensure that the IP Source (Camera or DVR) has the capacity available to stream
video in addition to any other overhead
• Ensure that any third party IP source is correctly congured to deliver streaming
video to the specied requirements.
• All IP Camera Recording should use JPEG proles, and Prole Recording.
• The IP Camera image size should not exceed 18KB or 2CIF.
• The feeds from all IP Camera should be limited to 4Mbits/sec and be limited to
80pps. If the rst cameras absorb the available bandwidth, later IP cameras may
not be connected.
i.e. The unit can be configured to record;
• 1 IP Camera @ 16pps using an 18K image, plus 15 composite inputs at 4pps
• 16 IP Cameras @ 1pps using an 18K image with no composite inputs
Contact Technical Support for configurations between the two extremes shown
• For Axis 214 PTZ, select AXIS 214 and select AXIS IP for the telemetry type.
•Axis 211is the general default protocol used by Axis. It is likely that any future
Axis cameras will work using Axis 211, using a default username root and
password root)
• Pre-alarm is not currently supported
• MPEG4 and Unicast RTP is not currently supported.
• VMD and Activity is not currently supported on IP cameras.
• BOSCH iSCSI protocol is not currently supported.
Certain IP cameras must have the same username and password congured in /etc/ip_cams.ini.
The default settings for the third party IP cameras should be sufcient. It may be necessary to
congure the individual cameras using the individual cameras web pages to optimise results.
If different passwords are required for the same IP camera types, then the camera entry in the
ip_cams.ini must be duplicated for each password.
i.e. The details in ip_cams.ini for Axis 211 and Axis 211A are exactly the same - they could
be selected as an alias of each other - if different passwords were wanted for each, or if
different responses to high, medium or low requests were needed.
[AXIS_211]
image_url=axis-cgi/mjpg/video.cgi?camera=<cam>&resolution=<res>&fps=<fps>
high=2CIF
med=CIF
low=QCIF
user=root
pass=root
netvu=compatible
[AXIS_211A]
image_url=axis-cgi/mjpg/video.cgi?camera=<cam>&resolution=<res>&fps=<fps>
high=2CIF
med=CIF
low=QCIF
user=root
pass=root
netvu=compatible
Note: The ini le dictates what the system requests from the IP camera as high, medium or low.
The IP Source will send images based upon the request, or upon what the individual IP
source has set up as low, medium or high.
Dedicated Micros Ltd.
1200 Daresbury Park, Daresbury,
Cheshire, WA4 4HS, UK
Dedicated Micros Europe
Neckarstrafle 15,
41836 Hückelhoven, Germany
Dedicated Micros France
9-13 rue du Moulinet
75013 Paris, France
Dedicated Micros Slovenia
Delavska cesta 26,
4208 Sencure, Slovenia
MI-A-DS2AD/E2-0
Dedicated Micros Benelux
Joseph Chantraineplantsoen 1,
3070 Kortenberg, Belgium
Dedicated Micros USA.
14434 Albemarle Point Place, Suite 100,
Chantilly, Virginia 20151 USA
Dedicated Micros USA.
23456 Hawthorne Blvd., Suite 100,
Torrance, CA 90505, USA
Dedicated Micros, Australia PTY.
5/3 Packard Avenue, Castle Hill,
NSW 2154, Australia
Dedicated Micros, Asia PTY
16 New Industrial Road,
#03-03 Hudson Techno Centre,
Singapore 536204
Dedicated Micros Middle East
Building 12, Suite 302, P.O. Box 500291, Dubai
Internet City, Dubai, United Arab Emirates
Dedicated Micros (Malta) Ltd.
BLB017, Bulebel Industrial Estate,
Zejtun, ZTN08, Malta
[AXIS_241Q]
image_url=axis-cgi/mjpg/video.cgi?camera=<cam>&resolution=<res>&fps=<fps>
high=2CIF
med=CIF
low=QCIF
user=root
pass=root
netvu=compatible
[AXIS_241]
image_url=axis-cgi/mjpg/video.cgi?camera=<cam>&resolution=<res>&fps=<fps>
high=2CIF
med=2CIF
low=CIF
user=user
pass=pass
netvu=compatible
A user connecting with the password user and the password pass will be sent a higher quality image
from the same camera than a user logging on with username root and password root.
Tabla de contenidos
Otros manuales de DVR de Dedicated Micros
Dedicated Micros
Dedicated Micros SD Range Manual de usuario
Dedicated Micros
Dedicated Micros Digital Sprite 2 Instrucciones de instalación y funcionamiento
Dedicated Micros
Dedicated Micros Digital Sprite 2 Manual de usuario
Dedicated Micros
Dedicated Micros DV-IP Series Manual de usuario
Dedicated Micros
Dedicated Micros D3 Manual de usuario
Dedicated Micros
Dedicated Micros D4 Manual de usuario
Dedicated Micros
Dedicated Micros DV-IP NV4 Manual de usuario
Dedicated Micros
Dedicated Micros NetVu Uniplex UP/MAN/002/M Guía de configuración
Dedicated Micros
Dedicated Micros TransVu Express Manual de usuario
Dedicated Micros
Dedicated Micros Digital Sprite 2 Manual de usuario
Dedicated Micros
Dedicated Micros SD Range Instrucciones de funcionamiento
Dedicated Micros
Dedicated Micros SD Excel Manual de usuario
Dedicated Micros
Dedicated Micros Digital Sprite 2 Manual de usuario
Dedicated Micros
Dedicated Micros SD Range Instrucciones de funcionamiento
Dedicated Micros
Dedicated Micros BX2 Manual del propietario
Dedicated Micros
Dedicated Micros D4 Instrucciones de instalación y funcionamiento
Dedicated Micros
Dedicated Micros Eco4 Series Instrucciones de funcionamiento originales
Dedicated Micros
Dedicated Micros Digital Sprite 2 Manual de usuario
Dedicated Micros
Dedicated Micros Eco9 Manual de usuario
Dedicated Micros
Dedicated Micros Digital Sprite 2 Instrucciones de instalación y funcionamiento
