5
950701-01 18/02/21
damaged.
has acid leaks.
it away from direct sunlight and away from heat sources.
Description of the starter
with a lithium battery.
Controls, reports and accessories Fig.1Controls, reports and accessories Fig.1
Jump starting
Use the appliance only as an emergency starter
to support the vehicle battery. Do not use it alone
instead of the battery.
make sure that the clamps cannot disengage from the poles
of the battery during charging.
belts and pulleys.
cable because they are always under tension.
arc or cause incandescent metal splashes.
Sequence of operations
Starter battery must be fully charged (4 led lit).
Carefully follow the starting procedure, failure torefully follow the starting procedure, failure to
The starter automatically recognizes the presenceThe starter automatically recognizes the presence
of the battery and its voltage (12V / 24V). Do not useof the battery and its voltage (12V / 24V). Do not use
the “Over Ride” function unless the starter fails tothe “Over Ride” function unless the starter fails to
recognize the battery.recognize the battery.
11
22 (+)(+) batterybattery
terminal and black charging clampterminal and black charging clamp (-)(-)
battery terminal.battery terminal.
connect the clamp to the battery terminal that is notconnect the clamp to the battery terminal that is not
second clamp to the bodywork at a point far from bothsecond clamp to the bodywork at a point far from both
the battery and the petrol pipes.the battery and the petrol pipes.
When the connection is correct the display shows theWhen the connection is correct the display shows the
33Rotate the ignition key for up to 3 seconds.Rotate the ignition key for up to 3 seconds.
If the vehicle did not start wait at least 15 secondsIf the vehicle did not start wait at least 15 seconds
before trying again.before trying again.
¾
on the display.
¾
will remain in standby mode.
¾¾
out a minimum charge of the battery with a charger beforeout a minimum charge of the battery with a charger before
using the starter.using the starter.
¾¾
the starter:the starter:
¾¾
¾¾
OVER RIDE FUNCTION
Carefully check the battery voltage (12V / 24V) in
order to not damage the electrical system of the
vehicle
1
22ConnecConnec(+) battery
terminal and black charging clamp (-)
battery terminal.
connect the clamp to the battery terminal that is not
second clamp to the bodywork at a point far from both
the battery and the petrol pipes.
3
4
seconds
Start the engine within 30 seconds.
5Rotate the ignition key for up to 3 seconds.Rotate the ignition key for up to 3 seconds.
If the vehicle did not start wait at least 15 seconds
before trying again.
Use as power supply USB / 12V
1
