DECswitch 900EE
Quick Start
This card explains how to quickly install and configure the DECswitch 900EE module. The
intended audience is the person that will install and configure this module. Check the
boxes after completing each step. You need the following items to install this product:
• DECswitch 900EE module.
• DEChub 900 MultiSwitch, a
DEChub ONE, or a DEChub ONE-
MX docking station.
• Phillips head screwdriver (DEChub
ONE docking station only)
• Setup port device (PC or terminal).
• Setup port cable and (optionally) an
adapter.
• You must know the IP address,
subnet mask, and community string
before you begin.
For detailed instructions and important safety information, see the DECswitch 900EE
Installation and Configuration manual, or the DEChub ONE Installation manual, or the
DEChub ONE-MX Installation manual.
Install the Module (Choose A or B)
A. Installing the Module into a DEChub ONE or DEChub ONE-MX:
If further detail is needed to perform any of the following steps, refer to the DEChub ONE or
the DEChub ONE-MX Installation manual.
1) Make sure AC power to the DEChub ONE or DEChub ONE-MX Docking Station
is disconnected.
2) For a DEChub ONE:
a) Place the module on a flat surface (table).
b) Use a Phillips-head screwdriver to loosen the screw and L-bracket from
the DEChub ONE.
c) Gently seat the module into the DEChub ONE and tighten the screw.
3) For a DEChub ONE-MX:
a) Place the module on a flat surface (table).
b) Gently seat the module into the DEChub ONE-MX until the tab
engages.
c) Align the screw holes on the table top mount bracket with the holes on
the DEChub ONE-MX and on the network module. Attach the bracket
using three #6-32 pan-head screws.
