MMI 2G –MMI 3G
1. To install the DAS®receiver, refer to the specific user manual;
Warning on the connection of the power supply cable:
- RED wire (fig.3) must be DISCONNECTED.
The switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activity
- YELLOW wire (fig.1) must be connected to the +12V permanent/battery
- BLACK wire (fig.2) must be connected to the GND.
Multiconn Srl
2
Power supply cable 1
2
3
2. Disconnect the original Fiber Optical cable (fig.4) from one of the original multimedia accessories inside the car (DVD, GPS, Amplifier, etc…)
and match it directly to DAS®fiber optic female connector of the harness on equipment (fig.5).
4
4 5
MMI2G –MMI3G Installation: