Danfoss Ikompact Manual de usuario

Danfoss does not take responsibility of an incorrect installation, interferences produced by collision of frequencies, nor of the

management of the working frequencies in fixed facilities, where several radio remotes systems, share or can share, the same zone

or working area.

Warning

Proceed with caution; the equipment may not be connected correctly which may lead to unforeseeable movements on starting-

up. Make sure that the crane is stopped for the entire duration of the assembly process, keep the work area free and wear

protective clothing.

To guarantee the specified autonomy it is necessary to use AAA LR03 (x4) alkaline batteries with nominal capacities between 900

and 1155 mAh. It is highly recommended to use brands with + type or similar with nominal capacities close to 1155 mAh.

Rechargeable batteries are NOT recommended, as its nominal capacity is lower than the desired one.

Description

Legend:

1. Status LED

2. Feedback LEDs

3. START Button

4. STOP Button (if no STOP option)

5. STOP Pushbutton Option

6. Hook attachment

7. Removable EEPROM module

8. Alkaline batteries

Installation Guide

ikompact

Remote Control

©Danfoss | March 2020 AN312055927725en-000102 | 1

1. Proceed to connect the power supply and the outputs

according to the connection block diagram provided with the

system. The configuration of the radio node can last up to 1

minute.

2. Place the EEPROM and the charged alkaline batteries.

3. If the transmitter has the STOP button, press and pull it out.

The status LED will blink in blue until the Stand-by mode is

reached, then it will turn into fixed blue.

4. If the transmitter does not have the STOP button, press the

start button. The status LED will blink in green until the

transmitter is linked with the receiver.

5. When the receiver confirms the link, the status LED will turn

into fixed green, and will enter working mode. The system will

be fully operational in order to action any maneuver.

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products

already on order provided that such alterations can be made without subsequent changes being necessary in specifications already agreed.

2 | ©Danfoss | March 2020 AN312055927725en-000102

Otros manuales para Ikompact

Otros manuales de Mando a distancia de Danfoss

Manuales populares de Mando a distancia de otras marcas

Panasonic

Panasonic EUR7622KB0 Manual de usuario

Bang & Olufsen

Bang & Olufsen Beo4 Manual de usuario

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Manual de usuario

Multiplex

Multiplex PROFI TX 9 Manual de usuario

One Remote

One Remote RMB4 Manual de usuario

FUTABA

FUTABA 9ZAP - PART2 Manual de usuario

HR Matic

HR Matic HR MULTI 3 Manual de usuario

Yamaha

Yamaha ACC-GNRST-30-20 Manual de usuario

EisSound

EisSound KBSOUND Manual de usuario

Marantz

Marantz RC101 Manual de usuario

Conrad

Conrad FS20 TC6 Manual de usuario

Anritsu

Anritsu MP1777A Manual de usuario

Niles

Niles WVC100 Guía de solución de problemas

RCA

RCA RCU1300 Manual de usuario

Bang & Olufsen

Bang & Olufsen BEO6 Manual de usuario

GE 94901 Manual de usuario

Onbon

Onbon YQ1-75 Manual de usuario

FUTABA

FUTABA R7108SB Instrucciones de instalación