© 2020 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are
trademarks of the General Electric Company and are used under license. iBeacon is a trademark of
Apple Inc. Information provided is subject to change without notice. All values are design or typical
values when measured under laboratory conditions.
CTRL036 (Rev 09/18/20)
Daintree™ |Single Rocker Self-Powered ZigBee®Switch
www.gecurrent.com
T1-888-694-3533
Commissioning (cont.)
Cycle through the sixteen channels
Here is a chart of the ZigBee channels and the
corresponding radio frequencies (in MHz).
When the switch is on the correct channel,
the compatible system will provide a link
conrmation indication.
Consult the instructions for the compatible system
for details of the link conrmation indication.There
should be a visible or audible exchange indicated
on the system, and the switch will be linked to the
system.
Exit linking mode on the switch by pressing any
other button on the switch.
For problems with the compatible system, please
contact the system provider.
To change the switch’s channel, short press the
selected switch button (less than 7 seconds) once
after entering commissioning mode. This will reset the
channel used by the switch to channel 11.
If the switch was already operating on channel 11
(default condition) then the radio channel will remain
unchanged. This ensures that the switch will always
use channel 11 as the starting point for the channel
adjustment.
Short press the selected button (less than 7
seconds) again to move to the next channel.
For each such button press, the switch transmits on
the next channel. If channel 26 has been reached then
channel 11 will be used next.
*Daintree EZ Connect Preprogrammed to Channel ID 15
Channel ID Lower Center Upper
Frequency Frequency Frequency
11 2404 2405 2406
12 2409 2410 2411
13 2414 2415 2516
14 2419 2420 2421
15* 2424 2425 2426
16 2429 2430 2431
17 2434 2435 2436
18 2439 2440 2441
19 2444 2445 2446
20 2449 2450 2451
21 2454 2455 2456
22 2459 2460 2461
23 2464 2465 2466
24 2469 2479 2471
25 2474 2475 2476
26 2479 2480 2481
ZBT-S1AWH Daintree EZ Connect Self-Powered
Wireless Rocker Switch
Range 30-100 ft or 10-30 m (typical)
Frequency 2.4 GHz (ZigBee channels 11-26)
Power Supply Self-generated when switch is pressed
Buttons 2 (1 rocker)
Dimensions 2.75 (W) x 4.5 (H) x 0.62 (D) inches
Operating -13º to +149º F
Temperature (-25º to +65º C)
Radio Certied according to FCC, IC
Certications and CE regulations
Addressing Factory Set Unique ID
Specications
Contains FCC ID: SVZ-PTM215Z
Contains IC: 5713A-PTM215Z
The enclosed device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (i.) this device may not cause
harmful
interference and (ii.) this device must accept any interference
received, including
interference that may cause undesired operation.
Always follow local electrical codes when installing this device. Installation
should be performed by a qualied electrician.
This device or certain aspects thereof is protected by at least one of the U.S.
or international patent or has at least one such patent application pending.
