Da-Lite DESIGNER MANUAL SCREEN Manual de usuario

76488 Rev. 7/02Printed in U.S.A.

MAINTENANCE

PROJECTION SCREEN MAINTENANCE

Protect your screen by keeping it rolled in its

case when not in use. Always examine both

front and back of surface before rerolling into

case to make certain screen is free of dust, dirt

or other foreign matter. Use a very soft duster

brush to gently remove foreign particles.

CASE MAINTENANCE

The case of the screen has a Resistovar finish.

This finish is resistant against: water, alcohol,

marring, scratching, and nail polish remover. To

help maintain the best appearance of the case

it is recommended that the case be polished

with any reputable liquid or paste wax polish.

An oil type polish is not recommended because

it allows for the collection of dust and finger

prints. When necessary, this finish may be

wiped with a damp soft cloth using a mild soap

solution, rinsed with clear water and dried with

a soft cloth.

POWER

PRESENTATION PRODUCTS

The

Operating Instructions

For

Designer

Manual Screen

DA-LITE SCREEN COMPANY, INC.

3100 North Detroit Street

Post Office Box 137

Warsaw, Indiana 46581-0137

Phone: 574/267-8101

800-622-3737

Fax: 574/267-7804

http:// www.da-lite.com

e-mail: [email protected]

FOR WALL MOUNTING

HARDWARE PROVIDED

2 – “V” Bars ( one is factory mounted to the

back of the case; one will be mounted to

the wall)

6 – Toggle Bolts, 4"

6 – Lead Shields, #10-14 x 11/2"

6 – Phillips Flat Head Wood Screws, #10 x 2"

TOOLS REQUIRED

Electric Drill

Masonry Bit 5/16" (if mounting in solid masonry

or concrete)

Screw Driver, #2 Flat Tip (if using toggle bolts)

or #2 Phillips (if mounting in solid masonry or

concrete)

INSTALLATION INSTRUCTIONS

Determine the height of the top of the case

from the floor. This will be the height of the

wall mounted “V” bar.

Hold the loose “V” bar to the wall at the height

determined above (MAKE SURE IT IS LEVEL),

and mark the location for the screw holes. To

mount the “V” bar on solid concrete or

masonry wall, drill 5/16" holes and insert the lead

shields. Fasten the “V” bar to the wall using

the #10 x 2" wood screws. If you are mounting

to a hollow wall, drill 1/2" holes and insert the

toggle bolts. Then fasten the “V” bar to the

wall with the toggle bolts. Now set the case in

place on the wall with the “V” bar of the case

nestled into the “V” bar on the wall.

FOR CEILING SUSPENSION

Position and properly anchor screw hooks into

ceiling, beam or other solid surface. Then

proceed to use the two “D” rings that are

factory mounted to the top of the case to hang

the case securely.

TO LOWER AND RAISE PICTURE SURFACE

To lower the picture surface, pull the screen

down all the way. Then hesitate and allow the

screen to retract very slowly until it locks in

place. To raise the picture surface pull down on

the pull bail, then raise quickly, as a window

shade. Keep control of the picture surface. Do

not allow it to roll uncontrolled into the case or

damage to the screen is sure to result.

Allow a minimum of

11/4" from the ceiling

Ceiling

41/4"

Determine

measurement to the

top of the Case

Wall

“V” Bar mounted

to the back of the

Case at the factory

“V” Bar mounted

to the wall

Mount top of

“V” Bar flush

with top of Case

Floor line

Otros manuales de Pantalla de proyección de Da-Lite

Da-Lite

Da-Lite ADVANTAGE ELECTROL Instrucciones de montaje

Da-Lite

Da-Lite ASCENDER ELECTROL Manual de usuario

Da-Lite

Da-Lite Tensioned Contour Electrol 38798LC Manual de usuario

Da-Lite

Da-Lite ADVANTAGE DELUXE ELECTROL Manual de usuario

Da-Lite

Da-Lite ADVANTAGE ELECTROL Manual de usuario

Da-Lite

Da-Lite senIor electrol Manual de usuario

Da-Lite

Da-Lite Boardroom ElEctrol Manual de usuario

Da-Lite

Da-Lite Tensioned Advantage Deluxe Electrol Manual de usuario

Da-Lite

Da-Lite Multi vision imager Manual de usuario

Da-Lite

Da-Lite PERM WALL FRAME Manual de usuario

Da-Lite

Da-Lite advantage Manual de usuario

Da-Lite

Da-Lite ASCENDER ELECTROL Manual de usuario

Da-Lite

Da-Lite Cosmopolitan Electrol Manual de usuario

Da-Lite

Da-Lite ADVANTAGE ELECTROL Manual de usuario

Da-Lite

Da-Lite Tensioned Advantage Deluxe Electrol Manual de usuario

Da-Lite

Da-Lite MULTI-MASK IMAGER Manual de usuario

Da-Lite

Da-Lite Parallax Thin Manual de usuario

Da-Lite

Da-Lite SLIMLINE ELECTROL Manual de usuario

Da-Lite

Da-Lite ADVANTAGE DELUXE ELECTROL Manual de usuario

Da-Lite

Da-Lite DESIGNER CONTOUR MANUAL Manual de usuario

Da-Lite

Da-Lite TENSIONED ADVANTAGE ELECTROL Manual de usuario

Da-Lite

Da-Lite Boardroom ElEctrol Manual de usuario

Da-Lite

Da-Lite Picture King Manual de usuario

Da-Lite

Da-Lite DESIGNER ELECTROL Manual de usuario

Manuales populares de Pantalla de proyección de otras marcas

FART PRODUKT

FART PRODUKT Standard SCREEN Manual de usuario

Draper

Draper E Series Manual

Elite Screens

Elite Screens Elite Tripod Series Manual de usuario

Laarhoven

Laarhoven Companion II Manual de usuario

Renogy

Renogy RMS-LFPS-US Manual de usuario

Samsung

Samsung S*H65* Manual de usuario

FONESTAR

FONESTAR PPTR-43100-FA Manual de usuario

Slide Clear

Slide Clear Varro XL Manual de usuario

Elite Screens

Elite Screens M85XWS1-SRM Manual de usuario

OS РХ-090Н Manual de usuario

Niko

Niko 10-845 Manual de usuario

Speaka Professional

Speaka Professional 2357532 Manual de funcionamiento

Sima

Sima XL-72 Manual de usuario

Jasic

Jasic EVO 2.0 ET-200P Manual de usuario

Elite Screens

Elite Screens Starling 2 Series Manual de usuario

InFocus

InFocus SC-WALL GRY-92H Manual

Barco

Barco OverView MVL-615 Manual de usuario

Draper

Draper Envoy Manual