D-Link DSN-6000 Series Manual de usuario

DSN-6000 Series

iSCSi iP SAN StorAge

Quick Installation Guide+

Installations-Anleitung+

Guide d’installation+

Guía de instalación+

Guida di Installazione+

ENGLISH

Quick Installation Guide

DSN-6000 series

IP SAN storage HDD trays

If any of the items are missing, please contact your reseller.

iSCSI IP SAN storage

Package Contents

RS-232 cables

Before installation

Before starting, prepare the following items.

1. A host with a Gigabit Ethernet NIC or iSCSI HBA.

2. CAT 5e, or CAT 6 network cables for management port and iSCSI data ports.

3. Prepare storage system conguration plan.

4. Prepare management port and iSCSI data ports network information. When using static IP, please

prepare static IP addresses, subnet mask, and default gateway.

5. 10GbE switches (recommended). Or 10GbE switches with LCAP / Trunking (optional).

6. CHAP security information, including CHAP username and secret (optional).

Power cords

CD Keys, screws for

drives and rail kit

Rail kitGBIC transceiver

and cable for

DSN-6410/ 6420

only

ENGLISH

Install drives

Note : Skip this section if you purchased a solution populated with drives.

To install SAS or SATA drives with no Bridge Board use the front mounting holes:

To install SATA drives with Bridge Board (DSN-654), t the Bridge Board rst.

Then install the drive using the rear mounting holes:

Drive slot numbering

Slot 1 Slot 4 Slot 7 Slot 10

Slot 2 Slot 5 Slot 8 Slot 11

Slot 3 Slot 6 Slot 9 Slot 12

Hard drives can be installed into any slot in the enclosure. Slot numbering will be reected in

web UI.

Note: It is advisable to install at least one drive in slots 1 ~ 4. System event logs are saved

to drives in these slots; If no drives are tted the event logs will be lost in the event of a

system reboot.

ENGLISH

Deployment

Please refer to the following topology and have all the connections ready.

1. Setup the hardware connection before powering on servers. Connect console cable, management

port cable, and iSCSI data port cables in advance.

2. In addition, installing an iSNS server is recommended for dual controller system.

3. Power on IP SAN storage and JBOD (optional) rst, and then power on hosts and iSNS server.

4. To ensure MPIO is set-up automatically it is recommended that you log on the target twice (from

controller 1 then controller 2).

Note: iSNS server is recommended for dual controller system.

DSN-6110: 1GbE to SAS/ SATA IP SAN storage, Single controller.

DSN-6120: 1GbE to SAS/ SATA IP SAN storage, Dual redundant controller.

ENGLISH

DSN-6410: 10GbE to SAS/ SATA IP SAN storage, Single controller.

DSN-6420: 10GbE to SAS/ SATA IP SAN storage, Dual redundant controller.

ENGLISH

1.Web UI

The D-Link DSN-6000 family includes a simple to use Graphical User Interface (GUI)

for integration and management. Be sure to connect the LAN cable, open a browser

and enter:

http://192.168.0.32

A dialog box for authentication will pop up.

User name: admin

Default password: 123456

After login, choose the functions that list on the left hand side to start your conguration.

2.Quick installation

Please make sure that there are some free drives installed in this system. Please check the

hard drive details in “/ Volume conguration / Physical disk”.

Step1: Click the “Quick installation”; follow the steps to set up system name and date / time.

Step2: Conrm the management port and DNS IP addresses are correct, and click “Next”.

Conguration

Step 1 Step 2

ENGLISH

Step 3: Set up the data port IP and click “Next”.

Step 4: Set up the RAID level and volume size and click “Next”.

Step 3 Step 4

Step 5: Check all items, and click “Finish”.

Step 6: Done.

3.Logon Microsoft iSCSI initiator

Here are the step by step instructions to setup Microsoft iSCSI Initiator. Please visit Microsoft

website for latest iSCSI initiator. This example is based on Microsoft Windows Server 2008 R2.

Step 5

ENGLISH

Connect

1.Run Microsoft iSCSI Initiator.

2.Input IP address or DNS name of the target. And

then click “Quick Connect”.

3.Click “Done”.

4.Your Computer can now connect to an iSCSI disk.

Technical Support

United Kingdom (Mon-Fri)

Home Wireless/Broadband 0871 873 3000 (9.00am–06.00pm, Sat 10.00am-02.00pm)

Managed, Smart, & Wireless Switches, or Firewalls 0871 873 0909 (09.00am – 05.30pm)

(BT 10ppm, other carriers may vary.)

Ireland (Mon-Fri)

All Products 1890 886 899 (09.00am-06.00pm, Sat 10.00am-02.00pm)

€0.05ppm peak, €0.045ppm off peak Times

Internet

http://www.dlink.co.uk

ftp://ftp.dlink.co.uk

DEUTSCH

Installationsanleitung

DSN-6000 Produktreihe

IP SAN

(Speichernetzwerk-

Gerät)

Festplatten-

Einschübe

Wenn eines dieser Elemente fehlt, wenden Sie sich bitte an Ihren Vertriebspartner oder

Fachhändler.

iSCSI IP SAN (Speichernetzwerk)

Packungsinhalt

RS-232 Kabel

Vor der Installation

Stellen Sie vor dem Start die folgenden Elemente bereit.

1. Ein Host mit Gigabit Ethernet NIC oder iSCSI HBA (Host-Bus-Adapter).

2. CAT 5e oder CAT 6 Netzwerkkabel für den Management-Port und für die iSCSI Datenports.

3. Erstellen Sie einen Kongurationsplan des Speichersystems.

4. Erstellen Sie Netzwerkinformationen für den Management-Port und die iSCSI Datenports. Geben

Sie bei Verwendung einer statischen IP bitte die statischen IP-Adressen, die Subnetzmaske und das

Standard-Gateway an.

5. 10 GigabitE-Switches (empfohlen). Als Alternative 1 GbE-Switches mit LCAP / Trunking (optional).

6. CHAP-Sicherheitsinformationen, einschließlich CHAP-Benutzername und 'Secret' (optional).

Netzkabel

CD Schlüssel,

Schrauben für

Laufwerke und

Führungsschienen

FührungsschienenGBIC-Transceiver

und Kabel nur für

DSN-6410/6420

DEUTSCH

Installation der Laufwerke

Hinweis: Überspringen Sie diesen Abschnitt, wenn Sie das System mit installierten Laufwerken

erworben haben.

Verwenden Sie die vorderen Montagelöcher, um SAS- oder SATA-Laufwerke ohne Bridge-Board zu

installieren:

Um SATA-Laufwerke mit Bridge-Board (DSN-654) zu installieren, montieren Sie zuerst das Bridge-

Board.

Installieren Sie dann das Laufwerk unter Verwendung der hinteren Montagelöcher:

Nummerierung der Laufwerk-Slots

Slot 1 Slot 4 Slot 7 Slot 10

Slot 2 Slot 5 Slot 8 Slot 11

Slot 3 Slot 6 Slot 9 Slot 12

Festplatten können in jedem Slot des Gehäuses installiert werden. Die Slot-Nummerierung

wird auf der Webbenutzeroberäche wiedergegeben.

Hinweis: Es ist ratsam, mindestens ein Laufwerk in den Slots 1 ~ 4 zu installieren.

Systemereignisprotokolle werden auf Laufwerken in diesen Slots gespeichert.

Wenn keine Laufwerke montiert werden, gehen die Ereignisprotokolle im Fall eines

Systemneustarts verloren.

Otros manuales para DSN-6000 Series

Tabla de contenidos

Idiomas:

Otros manuales de Hardware de red de D-Link

D-Link

D-Link DNS-321 - Network Storage Enclosure Hard Drive... Manual de usuario

D-Link

D-Link DSM-750 - MediaLounge High-Definition Draft N Media... Manual de usuario

D-Link

D-Link Express EtherNetwork DI-604 Manual de usuario

D-Link

D-Link DHP-W311AV Manual de usuario

D-Link

D-Link DCS-1000 Manual de usuario

D-Link

D-Link COVR-P2502 Manual de usuario

D-Link

D-Link ShareCenter Quattro DNS-345 Manual de usuario

D-Link

D-Link DNS-722-4 Manual de usuario

D-Link

D-Link xStack Storage DSN-4000 Series Manual de operación y mantenimiento

D-Link

D-Link Nuclias DNH-100 Manual de usuario

D-Link

D-Link ShareCenter DNS-315 Manual de usuario

D-Link

D-Link SharePort DIR-825 Manual de usuario

D-Link

D-Link COVR-3902 Dimensiones

D-Link

D-Link DNS-1250-04 Manual de usuario

D-Link

D-Link DAP-3711 Manual de usuario

D-Link

D-Link SHARECENTER PRO 1100 Manual de usuario

D-Link

D-Link DLM-3500 Manual de usuario

D-Link

D-Link xStack Storage DSN-2000 Series Manual de usuario

D-Link

D-Link MYDLINK DNR-322L Manual de usuario

D-Link

D-Link MYDLINK DNR-322L Manual de usuario

D-Link

D-Link ShareCenter Pulse DNS-320 Manual de usuario

D-Link

D-Link DSL-2520U Manual de usuario

D-Link

D-Link COVR-P2502 Manual de usuario

D-Link

D-Link DNR-2060-08P Manual de usuario

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario

Lanner

Lanner NCA-1525 Manual de usuario

Cantek

Cantek NR310-4 Manual de usuario