CyberData 011528 Manual
Quick Reference 931826A © 2021, CyberData Corporation, ALL RIGHTS RESERVED© 2021, CyberData Corporation, ALL RIGHTS RESERVED 931826A Quick Reference
Installation Method
The site where you install the switch may greatly affect its performance. When installing, please take the following into
consideration:
• Test the PoE network drop before connecting the CyberData device.
• Use caution when inserting or modifying connections and install the product in a clean, flat wall surface.
• Ensure there are no temperature or humidity concerns in the intended environment. See the Specs tab at
https://www.cyberdata.net/products/011528 for the acceptable temperature and humidity operating ranges.
• To prevent electrical issues, avoid installing in close contact with other electrical wires, next to in-wall insulation, or exposing
the circuit board upon completing the installation.
• Never install components in wet locations or during lightning storms.
• It is advised to consult a certified electrician for installation.
Typical Wall Installation
Parts
1
Plug in the network cable and angle in
2Secure Unit with Faceplate Screws
3
Fold agnuts down,
then insert into wall cutout and
tighten screws
(1) Low Voltage Bracket
(2) Faceplate Screws
(2) PCBA Mounting Screws
Accessory Kit
(1) PCBA(1) Faceplate
Dimensions
Mount PCBA to Faceplate
Contacting CyberData
2.756 [70]
4.567 [116]
0.177 [4.5] 3.900 [99]
3.270 [83]
DIMENSIONS ARE IN INCHES [MILLIMETER]
Dimensions are in Inches [Millimeters]
2.250 [57.15]
3.875 [98.43]
Dimensions are in Inches [Millimeters]
Faceplate
PCBA
Mounting Screw
Sales: 831-373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website: http://support.cyberdata.net/
RMA Department: 831-373-2601 ext. 136
RMA Status: http://support.cyberdata.net/
Warranty Information: http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
http://www.cyberdata.net/
The IP Endpoint Company
Installation Quick Reference
In-Wall 2-Port Gigabit PoE Switch
011528
Wall Cutout
© 2021, CyberData Corporation, ALL RIGHTS RESERVED 931826A Quick Reference Quick Reference 931826A © 2021, CyberData Corporation, ALL RIGHTS RESERVED
The Standard RJ-45 Introduction
Regarding cable-making methods, a cable that does not meet the standards of the sequence data will make the data transmission
speed slow, unstable, and even be blocked. Ta bl e 1 represents the standard RJ-45 jack and the connector (Figure 1) and pin
definition:
Figure 1. Standard RJ-45 Jack / Connector
The Standard Cable, RJ-45 Pin Assignment
The following figures show a straight cable and a crossover cable connection. Use a straight cable connection to connect switch/
Hub or other devices:
Straight cable for the switch (uplink MDI-II port) to switch/Hub or other devices connection.
Crossover cable for switch (MDI-X port) to switch/hub or other network devices (MDI-X port) connection.
Table 1. RJ-45 Connector Pin Definitions
Pin Number Signal
1 _TX1 +(PoE Power+)
2 _TX1 - (PoE Power+)
3 _RX1 + (PoE Power-)
4_TX2+
5_TX2--
6 _RX1 - (PoE Power-)
7_RX2+
8_RX2-
1 2 3 4 5 6 7 8
Powering on the In-Wall 2-Port Gigabit PoE Switch
Your existing central POE Switch powers the CyberData switch. No additional power supply is required. Plug your cable from your
main PoE switch into the ethernet port of the CyberData switch, which will power on for use.
How the Input Power is Distributed
Typical Installation
LED Status Description
PD (Orange) ON Switch has a connection from the PD port to the PSE device.
Power has been successfully applied.
OFF Connection to the PSE device is not present. No power has been applied to the switch.
PSE (Orange) ON PD device such as IP phone is connected to the port and drawing power.
OFF PD device is not connected or no power is being drawn from the switch.
Link/Act (Green) ON
A valid link
is
established.
Blink Traffic is present on port.
OFF
No
link
has been established.
Otros manuales de Cambiar de CyberData
CyberData
CyberData Hub Manual de usuario
CyberData
CyberData 10776 Manual de usuario
CyberData
CyberData KS-1000 Manual de usuario
CyberData
CyberData 11006 Manual de usuario
CyberData
CyberData 011236 Manual
CyberData
CyberData 011508 Manual
CyberData
CyberData 4-Port PoweredUSB 2.0 Hub Manual de usuario
CyberData
CyberData 11187 Manual
CyberData
CyberData 10807 Manual de usuario
CyberData
CyberData 4-Port PoweredUSB 2.0 Hub 011006 Manual de usuario
CyberData
CyberData IBM SI/O Manual de usuario
CyberData
CyberData 11187 Manual
CyberData
CyberData 011539 Manual
CyberData
CyberData 10630 Manual de usuario
CyberData
CyberData 10845 Manual de usuario
CyberData
CyberData 10807 Manual de usuario
CyberData
CyberData 011539 Manual
CyberData
CyberData 10630 Manual de usuario
CyberData
CyberData 4-Port Powered USB 2.0 Hub 010845 Manual de usuario
CyberData
CyberData 011187 Manual
