Cuppaz Sleek Manual del propietario
!
! !
!
!
How to Use and Care for Your Sleek
!
info@ cuppaz.com !!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!hotline: 852 2812 0428!
! !
2!
Table of Contents
Get to know the important buttons, lights and key parts…….………………………………………….………………3
This part should be read carefully: it’s about safety!..............................................................................4
First time using The Sleek? Follow these 7 steps for the priming cycle!.............................................7
Rinsing in 8 steps after the priming cycle……………………………………………………………………………………....9
Turning on The Sleek in 6 steps…………………………………………………………………………………….……….………12
Adjusting for cup height in 1 step………………………………………………………….………..……………………….…….14
The Correct Use of Buttons……………….……………………………………………………………………………………..…...14
Dispensing your beverage from The Sleek in 7 steps ……………………………………………………………..……16
Reprogramming the quantity of beverage…………………………………….……………………………………………....19
Dispensing cappuccino / milk coffee in 9 Steps with The Sleek……………………………………….…….....20
Dispensing Milk with The Sleek in 4 Steps ………………………………………………….……………………...……..24
Reprogramming the Amount of Milk in the Cup in 4 Steps ………………………………………………..…….26
Milk Jug Cleaning Cycle in 4 Steps…………………………………………….…………………………………………………28
How The Sleek communicates with you………………………………………………………………………………….…...30
Refilling the water tank in 3 steps…………….…………………………………………………………………………….…..…32
Daily Cleaning and Maintenance of your Sleek in 12 steps…………………………….……………………………33
The Sleek helps you save energy……………………………………….……………………………………………………………36
The Sleek will let you know when it is time to descale…….…………………………………………………………..36
How to descale The Sleek in 15 steps…………………………..…….…………………………………………………………..37
Troubleshooting with The Sleek…………………….………….…….…………………………………………………………...41
Technical data on The Sleek…………………………………………..….………………………………………………………....42
Recycling and Responsible Disposal……………………………………………………………………………………………..43
Scan to order machines and capsules using QR codes…………………………………………………………………44
info@ cuppaz.com !!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!hotline: 852 2812 0428!
! !
3!
!
Get to know the important buttons, lights and key parts that will
allow you and The Sleek to communicate!
!
A: "Espresso" button;
B: "Caffè lungo" (long coffee) button;
C: "Caffè filtro" (filter coffee) button;
D: "Cappuccino" button;
E: "Milk coffee" button;
F: "Milk" button;
G: "Multifunction" indicator light;
H: "Descaling" indicator light;
I: On/Off switch;
J: Capsule compartment opening / closing
lever;
K: Water tank cover;
L: Capsule compartment;
M:Water tank;
N: Power cord;
O: Used capsule drawer;
P: Milk jug knob;
Q: Milk dispenser;
R: Coffee dispenser;
S: Milk jug;
T: Top grille for cups;
U: Drip-tray grille;
V: Drip-tray;
Z: Steam outlet fitting.
info@ cuppaz.com !!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!hotline: 852 2812 0428!
! !
4!
This part should be read carefully: it’s about safety!
The Sleek was designed for domestic use and similar purposes. For example the
Sleek likes it in staff kitchen areas in shops, offices and other workplaces. Also in
hotels, lodges, motels, Bed & Breakfasts and other residential environments.
The Sleek only recognizes Cuppaz/Caffitaly System capsules. The combination of
the smart technology in these capsules and the technology in The Sleek will make
you a delicious beverage! Please don’t try to give The Sleek another type of capsule
as this will not work and could lead to malfunctioning.
Please only use The Sleek as directed here. It means that our guarantee to you can be
fulfilled. When the Sleek has been used improperly (in a way not explained here),
our manufacturer can’t be responsible for injury or damage. Sorry!
After removing the packaging, check that The Sleek is not damaged. If damage is
found, or upon the first sign of a defect (unusual noise or odors), or if any problem
occurs inside The Sleek, don’t use it and contact Cuppaz at info@cuppaz.com or call
the Cuppaz hotline at: 852 2812 0428. We’ll get you an undamaged Sleek right
away!
Don’t leave the packaging elements (plastic bags, etc.) within reach of children, as
they are potential sources of danger for them.
Only use The Sleek if the power cord is intact. If the cord is damaged you can get an
electric shock, so please don’t plug it in anywhere. Again: contact Cuppaz at
Only use and store The Sleek indoors. Make sure the electrical elements, plug and
cord, remain dry. Never submerge The Sleek in water (it doesn’t swim!).
info@ cuppaz.com !!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!hotline: 852 2812 0428!
! !
5!
Protect The Sleek from sprays and drips. Water and electricity together can cause
danger of electrocution.
Only connect The Sleek to power outlets complying with the requirements of the
law. Make sure that the power supply voltage matches the rating shown on the data
plate, located on the bottom of The Sleek.
The surface on which The Sleek is installed must be level, solid, stationary and heat
resistant; the bearing surface must not exceed an angle of 2°. No wobbly surfaces
for The Sleek!
Don’t leave The Sleek’s power cord near hot surfaces, sharp edges or other sharp
objects that can damage it.
Never place your hands inside the capsule compartment as this can cause injury.
Always close the lever of the Sleek. Never open the lever while a beverage is being
dispensed.
Never remove machine parts, except those indicated in this guide for daily
maintenance.
Don’t insert objects into the openings as this could cause electric shocks. Don’t
attempt any operation on The Sleek that is not described in this guide. Contact
Cuppaz for support at [email protected] or call us at 852 2812 0428.
Don’t pull on the power cord to disconnect it. Remove the plug instead to avoid
damaging it.
The Sleek can be used by persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the
hazards involved.
info@ cuppaz.com !!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!hotline: 852 2812 0428!
! !
6!
The Sleek can be used by children aged from 8 years and above if they have been
given supervision or instruction concerning use of the appliance in a safe way and if
they understand the hazards involved. Cleaning and user maintenance shall not be
made by children unless they are older than 8 and supervised. Keep The Sleek and its
cord out of reach of children aged less than 8 years. Children being supervised not to
play with The Sleek.
Descale the appliance regularly, following the instructions provided. The Sleek may
be damaged if you skip descaling. The Sleek will let you know when to descale.
Clean The Sleek carefully and regularly following the guidelines. If it is not cleaned,
the build-up that forms may be bad for your health. Unplug The Sleek and allow it to
cool before cleaning.
If you do not expect to use The Sleek for a long period of time (leaving on vacation,
etc.), please unplug it.
Thanks for helping us make your experience with The Sleek a safe,
pleasant, and inspiring one by following these safety guidelines!
info@ cuppaz.com !!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!hotline: 852 2812 0428!
! !
7!
First time using The Sleek? Or haven’t used The Sleek in awhile?
Follow these 7 steps for the priming cycle!
1.Fill the tank with fresh, still water.
2.Make sure the lever is closed.
3. Fit the milk dispenser first and then the jug in its special place.
info@ cuppaz.com !!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!hotline: 852 2812 0428!
! !
8!
4. Plug in the appliance and turn it on by pressing the button I.
5. Together with buttons A-B-C, indicator light G also blinks alternately RED.
6.Place a large container (at least 250ml) under the coffee and milk dispensers.
7. Press one of the buttons A-B-C. Wait for the machine to complete the water
circuit filling cycle. The indicator G light goes off.
Note: if the indicator light G continues to blink RED after the filling cycle, repeat
the previous steps.
info@ cuppaz.com !!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!hotline: 852 2812 0428!
! !
9!
Rinsing in 8 steps after the priming cycle
Buttons A,B, C, D, E and F will blink simultaneously when The Sleek is warming
up.
1.When buttons A,B, and C light up steady, do the rinse by pressing button C. Press
the button again to do another rinse.
2. Only remove the milk jug.
info@ cuppaz.com !!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!hotline: 852 2812 0428!
! !
10!
3. Fill the milk jug with water.
4. Fit the milk jug in its special place.
5. Make sure the milk jug knob is in the dispensing position.
6. Place a large container (at least 250ml) under the milk dispenser.
Otros manuales para Sleek
1
Tabla de contenidos
Otros manuales de Cafetera de Cuppaz
