Cube Design RAW gable ends Manual de usuario
RAW gable ends
Phone no:
Email:
Website:
Version:
+45 86 98 74 11
www.cube-design.dk/en
02-01-2024
Cube Design A/S
Vadstedvej 212 | DK-8450 Hammel | Phone no.: +45 86 98 74 11 | www.cube-design.dk/en | cube@cube-design.dk
Parts list:
1. 2 x gable ends
2. 1 x metal frame in 2 or
3 pieces
3. 4,5 x 16 mm screws for
brackets and magnets
4. 4 mm magnets
5. 4 mm washers
Assembly manual for RAW gable ends
A product by Cube Design
CUBE
DESIGN
Cube Design A/S
Vadstedvej 212 | DK-8450 Hammel | Phone no.: +45 86 98 74 11 | www.cube-design.dk/en | [email protected]
Step 1: Position the inner side of the RAW gable end as shown.
Step 2: Mount each of the metal frames with the supplied screws and washers in the pre-drilled holes:
Place a washer between bracket and gable, and then mount a screw through the washer.
For easier assembling use a universal joint or exible bit holder.
Step 3: Place the outer gable on a soft non-scratching surface. Take care not to scratch the surface.
Mount the supplied magnets with screws in the pre-drilled holes.
Assembly manual for RAW gable ends
CUBE
DESIGN
Cube Design A/S
Vadstedvej 212 | DK-8450 Hammel | Phone no.: +45 86 98 74 11 | www.cube-design.dk/en | [email protected]
Do not over-tighten the screws as the magnets may break.
Step 4: Place the outer gable in the metal frame, and gently push it in place, until the magnets snap.
The RAW gable end is assembled and nished.
You can now mount other accessories, like cable tray or acoustic screen for Bench.
Enjoy your new RAW gable ends!
Assembly manual for RAW gable ends
CUBE
DESIGN
Tabla de contenidos
Otros manuales de Mobiliario de interior de Cube Design
