INSTALL AND ADJUST HANDLE
.
ASSEMBLY INSTRUCTIONS
9
INSTALL THE CUTOFF KNIFE
1. Align the knife hole with the hole on shield,
then tighten them up with screws.
Cutoff Knife Cutting Attachment
Shield
Screw
Align the two holes on the cutting attachment
shield with the other two holes in the clamping
bracket, then tighten them up with screws.
INSTALL THE CUTTING ATTACHMENT SHIELD
Cutting
Attachment
Shield
Screw
Clamping
Bracket
1. Push the handle down onto the tube,and
set the lower handle into the right place,
so that the parts matched right.
2. Insert the bolt into the bolt hole and push
it through.and put the nut into the nut hole
on the lower handle back.tighten the bolt,
but do not tighten the bolt completely.
3. While holding the unit in the operation,
move the handle to the location that
provides the best grip. Place it a minimum
of 6 inches(152mm) from the end of the grip.
make sure the handle base between arrows.
4. Tighten the bolt until the handle is secure.
D-Handle
Lower Handle
152mm
2. You can adjust the operating angles of the
handle by loosening the handle locking knob.
1. Put the “Bull” Handle between the top and
middle clamps, and then connect the top,
middle and bottom clamps by tightening
the handle locking knob.
U-Handle
Middle Clamp
Bottom Clamp
Locking Knob
Washer
Top Clamp
“D” Handle
“Bull” Handle
