Cornelius Flavor Fusion 22127 Manual de usuario

ED150-8V “K” Style Lid Kit Installation Instructions

INSTALLATION INSTRUCTIONS

FOR ED150-8V “K” STYLE LID KITS, P/N 630200153 AND 630000191

These “K” style kits apply to the following ice makers:

WARNING:

Disconnect power to the unit before installing the adaptor following all lockout/tag out procedures established by the

user. Verify that all the power is off to the unit before performing any work.

Failure to comply could result in serious injury, death or damage to the equipment.

WARNING:

All ice baffle plates and bin stats, if included or recommended in this kit, must be installed as directed in this manual or

the equipment manufacturer’s instructions.

Failure to comply could result in serious injury, death or damage to the equipment.

WARNING:

All of the attachment screws and plates must be installed as directed in this manual.

Failure to comply could result in serious injury, death or damage to the equipment.

1. Unpack the kit.

2. Place insulation strip (item 12) over studs on the baffle and Insert baffle assembly into the adapter lid.

3. Place (2) sealing washers (item 9) over studs and (2) flat washers (item11), then fasten in place with (2) plastic

acorn nuts (item 8).

4. Set ice maker lid on the top of the dispenser.

Table 1. Applicable Models

Ice Maker Width

Cornelius 322/522 22I

Crystal Tips 200/300/400 22”

Ice-O-Matic 22”

Manitowoc 320/420 22”

Scotsman SLC 300/400 22”

Servend S2/4 22”

Table 2. Loose Shipped Parts

Item No. Part No. Name Qty.

152994 Cover, Gray (630000191) 1

52934 Cover, Black (630200153) 1

2 620028801 Lid Assembly 1

3 22127 Bracket 2

4 70217 #8 Screw 12

5 50904 RTV 1

6 90221 Label 1

7 620912201 Installation Instruction 1

8 620701902 Acorn Nut, 8-32 Nylon 2

9 620701901 Sealing Washer 2

10 620037007 Baffle, Ice DF/ED150 1

11 621701903 #8 Nylon Washer 2

12 620505804 Insulation Strip 1

Release Date: November 9, 2010 www.cornelius.com Revision: B

ED150-8V “K” Style Lid Kit Installation Instructions

5. Using the slotted holes in the lid as a template, drill four (4) 0.140” diameter (9/64”) holes at the bottom of the slots

(see Detail A). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four (4) #8 sheet

metal screws, two on each side.

6. Seal the ice maker to the top of the dispenser as follows:

A. Run beads of RTV around the opening in the lid and inside of the perimeter of the ice maker outline so

that the ice maker sets on the RTV.

B. Set the ice maker onto the lid and position it as required.

C. Wipe away the excess RTV.

7. Drill 9/64I diameter holes into the ice maker cabinet using the bracket as a template. Use extreme care not to drill

into any ice maker components (condenser, tubing, etc.). Secure the brackets using the screws provided

8. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the bin ther-

mostat if so equipped or required.

9. If the plastic acorn nuts interfere with the positioning of the plastic manual fill cover, it may be necessary to make

small notches in the back flange of the cover to clear the acorn nuts.

CAUTION:

Bin Thermostat must not interfere with the agitator rotation.

Figure 1. ED150-8V Kit

ED150-8V “K” Style Lid Kit Installation Instructions

Figure 2. Dispenser Assembly

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Máquina de hielo de Cornelius

Cornelius

Cornelius SCOTSMAN CM1000 Series Manual de usuario

Cornelius

Cornelius I Series 224 Manual de usuario

Cornelius

Cornelius Nordic CCM0830 1 Guía

Cornelius

Cornelius CMP 600-30 Manual de usuario

Cornelius

Cornelius Duraflex 150-8 Valve Manual de usuario

Cornelius

Cornelius Starbucks UC100 Manual de usuario

Cornelius

Cornelius D100 Manual de usuario

Cornelius

Cornelius 15303 Manual de usuario

Cornelius

Cornelius Series 200 Manual de usuario

Cornelius

Cornelius Enduro-300 IntelliCarb Manual de usuario

Cornelius

Cornelius Nordic CCM1848 Guía

Cornelius

Cornelius Granita Guía de instalación

Cornelius

Cornelius ED-300 Manual de usuario

Cornelius

Cornelius UCR 700 Series Suplemento

Cornelius

Cornelius 500-Series Manual

Cornelius

Cornelius CHD22 Manual

Cornelius

Cornelius Nordic CCU0300 Series Manual de usuario

Cornelius

Cornelius XTREME 631812001 Guía de configuración

Cornelius

Cornelius 500 - Series Manual de usuario

Cornelius

Cornelius 500 - Series Manual

Cornelius

Cornelius 2306 Manual de usuario

Cornelius

Cornelius Nordic CCM1448 Guía

Cornelius

Cornelius Series 200 Manual de usuario

Cornelius

Cornelius Nordic CCU0150 Manual de usuario

Manuales populares de Máquina de hielo de otras marcas

Hoshizaki

Hoshizaki KMD-460MWJ Manual de usuario

Sub-Zero

Sub-Zero 315I Instrucciones de uso

Unold

Unold 48945 Manual de usuario

Kenmore

Kenmore 2217402A Manual de usuario

GE XPIO43SCSS Manual de usuario

Hoshizaki

Hoshizaki KMD-901MAH Manual de usuario

Whynter

Whynter FIM-450HA Manual de usuario

U-Line

U-Line UMCR014-SC01A Manual de instalación

Andrew James

Andrew James AJ000522 Manual de usuario

Scotsman

Scotsman CME1356 Manual de usuario

Scotsman

Scotsman ACM 25 Manual de usuario

Kärcher

Kärcher IP 120 Manual de usuario

U-Line

U-Line SS1095 Manual de usuario

Maytag

Maytag MIM1554WRS - Ice Maker Manual de usuario

Hoshizaki

Hoshizaki KM-630MAH Manual de usuario

Princess

Princess Yonanas Manual de usuario

Unold

Unold 48946 Manual de usuario

Electrolux

Electrolux E15IM60GP Manual de usuario