Cornelius The Profile PR150 BC Manual de usuario

IMPORTANT:

TO THE INSTALLER.

It is the responsibility of

the Installer to ensure that

the water supply to the

dispensing equipment is

provided with protection

against backflow by an air

gap as defined in

ANSI/ASME A112.1.2-1979;

or an approved vacuum

breaker or other such

method as proved effective

by test.

Water pipe connections

and fixtures directly

connected to a potable

water supply shall be

sized, installed, and

maintained according to

Federal, State, and Local

Codes.

Operator’s Manual

THE PROFILE ICE/DRINK DISPENSER

Model: PR150 BC

IMI CORNELIUS REMCOR INC 500 REGENCY DRIVE GLENDALE HEIGHTS, IL 60139–2268

Telephone (800) 551–4423 Facsimile (800) 519–4423

Specifications

Width: 31.88”

Depth: 27.81”

Counter cutout width: 30.00”

Counter cutout depth: 26.25”

Height above counter: 21.25”

Depth below counter: 29.00”

Ice storage capacity: 150 lbs

Weight empty: 285 lbs

Weight full: 435 lbs

Equipment #: 608

Page 1

INSTALLATION INSTRUCTIONS

COUNTER HEIGHT

(INCHES)

DISPENSER

DEPTH

(INCHES

AVAILABLE SPACE

BELOW DISPENSER

(INCHES)

USE KIT NO.

30 29 1 CONSULT FACTORY

31 29 2 CONSULT FACTORY

32 29 3 620517502

AND

629087406

33 29 4 629087406

34 29 5 629087406

34–1/2 29 5–1/2 629087412

AND

620517502

35 29 6 629087412

36 29 7 629087412

COUNTERTOP INSTALLATION

IMPORTANT: It is the responsibility of the installer to ensure that the drains from the dispensing

equipment is installed and maintained according to Federal, State, and local laws.

1. Locate the dispenser indoors on a level countertop.

The dispenser must be sealed to the countertop. The MOUNTING TEMPLATE (see Figure 1) indicates the

opening that must be cut in the countertop. Locate the desired position for the dispenser, then mark the

outline dimension on the countertop using the dimensions given or use the full size template enclosed.

Apply a continuous bead of NSF International (NSF) listed silastic sealant (Dow 732 or equivalent) approxi-

mately 1/4 inch inside the dispenser outline dimensions and around all openings. Position the dispenser on

the countertop within the outline dimensions. All excess sealant must be wiped away immediately.

2. The drain tube is routed through the large opening in the bottom of the dispenser. See the MOUNTING

TEMPLATE (see Figure 1) for locating the required clearance hole in the countertop for these utility lines.

The power cord is routed through hole in the side of the dispenser electrical control box.

3. SINK DRAIN ASSEMBLY: Connect the drain tube to an open drain. Additional drain tubing is provided with

the Dispenser. The drain tube must continuously pitch downword and contain no “traps” or improper drain-

age will result.

A. Use 3/4–inch nominal plastic pipe.

B. To assureproper drainage, do not allow a “trap” to form in the drain line. Be sure drain line runs flat

with bottom of the dispenser.

IMPORTANT: This dispenser must be installed with adequate backflow protection to comply with

Federal, State, and Local Codes.

4. Clean the hopper interior (See CLEANING INSTRUCTIONS).

Equipment #: 608

Page 2

5. Electrical specifications: 115V/60Hz/5.2A

Connect dispenser power cord to 120 VAC 60Hz 15-Amp 34-wire grounded receptacle.

FOOT PRINT OF UNIT

ON COUNTERTOP

THE ABOVE FIGURE SHOWS THE REQUIRED CUTOUT FOR PLACING THE ICE DISPENSER INTO A COUNTERTOP. THE DASHED

LINE IS THE ACTUAL CUTOUT DIMENSIONS WHILE THE SOLID LINE SHOWS THE AMOUNT OF OVERHANG FOR THE DISPENSER.

COUNTER CUTOUT

FOR DROP IN UNIT

FRONT OF COUNTERTOP

F IGUR E 1. MOUNTING T E MPL AT E

Equipment #: 608

Page 3

30”

31-7/8”

26-1/4”

27-3/16”

Equipment #: 608

McCann's Engineering & Mfg., Co.

C AR B O N AT O R

SPECI FI CATI ONS

-Brass Water Pump with I ntegral Strainer,

100GPH, 250 psi By-Pass

-1/4 MF Co2I nlet, 3/8 MF Water I nlet,

(2) 3/8 MF Soda Water Outlets

-Stainless Steel Base, Rubber Feet for Sound I solation

ELECTRI CAL

-115 VAC 60 Hz Single Phase, 7 amps, 1/3 HP

FEATURES

-Two-Piece Probe Design - Reduces Service Time

-Right Angle Probe Service Cord

-Heat Sink Probe Cap

-I mproved Probe Electronics

E2000 Series

Big Mac

10 1

/2"

12 3

/4"

13 1

/2"

Page 4

Otros manuales para The Profile PR150 BC

Tabla de contenidos

Otros manuales de Dispensador de Cornelius

Cornelius

Cornelius SUBWAY PEPSI SPIRE 3.0 Guía de configuración

Cornelius

Cornelius QUEST 4000 Manual de usuario

Cornelius

Cornelius JetSpray JS7 Manual de usuario

Cornelius

Cornelius Millenium II Manual de usuario

Cornelius

Cornelius CNB BIB Manual de usuario

Cornelius

Cornelius JT20D Manual de usuario

Cornelius

Cornelius UltraFlow Manual de usuario

Cornelius

Cornelius ED2XX-B Series Manual de usuario

Cornelius

Cornelius UF-1 Guía de configuración

Cornelius

Cornelius NITROPRO MINI Manual de usuario

Cornelius

Cornelius Quest Elite 2000 Manual de usuario

Cornelius

Cornelius VENTURE Manual de usuario

Cornelius

Cornelius Millennium II 6000 Manual de usuario

Cornelius

Cornelius NITROPRO MINI Manual de usuario

Cornelius

Cornelius 2232 Manual de usuario

Cornelius

Cornelius Jetspray JT20-W25 Manual de usuario

Cornelius

Cornelius REMCOR 1550 Guía de configuración

Cornelius

Cornelius NITROPRO MINI Manual de usuario

Cornelius

Cornelius ABS 2.0 Manual de usuario

Cornelius

Cornelius IDC PRO 255 Manual de usuario

Cornelius

Cornelius 318569000 Manual de usuario

Cornelius

Cornelius Vitalize430 Manual del operador

Cornelius

Cornelius IDC Pro255 Manual de usuario

Cornelius

Cornelius AquaCare Manual de usuario

Manuales populares de Dispensador de otras marcas

Silver King

Silver King Majestic SK12MAJ Guía de inicio rápido

Franke

Franke F3Dn Twin Manual de usuario

STIEBEL ELTRON

STIEBEL ELTRON UltraHot Plus Manual de usuario

DAN DRYER

DAN DRYER 282 Manual de usuario

Essity

Essity Tork 473208 Manual de usuario

CBS

CBS SD300BU-88 Guía de configuración

Sealey

Sealey MK77 Manual de usuario

Fluid Management

Fluid Management Accutinter 1600 Manual de usuario

Franke

Franke DVS SD99-010 Manual de usuario

Graco

Graco Dispensit 1053-10C Guía de solución de problemas

ITALTINTO

ITALTINTO i50 Manual de usuario

Coca-Cola

Coca-Cola FREESTYLE 9000 Manual de usuario

Graco

Graco ProMix 2KE Manual de instrucciones

TECHCON SYSTEMS

TECHCON SYSTEMS TS1251 Manual de usuario

Wayne

Wayne GLOBAL VISTA CNG Manual de usuario

clarsen

clarsen H133 Manual de usuario

PicoBrew

PicoBrew Zymatic Manual de usuario

BOWMAN

BOWMAN BP-007 Manual de usuario