Cornelius Pressurized Liquid Base Beverage Dispense... Manual de usuario

FlavorFusion Icemaker Adaptor Kit Installation Instructions

INSTALLATION INSTRUCTIONS

FLAVORFUSION ICEMAKER ADAPTOR KIT

FOR P/N 629088658, 629088659, 629088660, 629088661,

629088692, 629088693, 629088694, AND 629088695

FIGURE 1

WARNING:

Disconnect power to the unit before installing adaptor following all lock out / tag out procedures established by the

user. Verify all of the power is off to the unit before performing any work. Failure to comply could result in serious

injury, death or damage to the equipment.

WARNING:

All of the attachment screws and plates must be installed as directed in this manual. Failure to comply could result

in serious Injury, Death or Damage to the equipment.

Icemaker Adaptor Kit

Bar Cross Braces

Revision Date: August 3,2010 www.cornelius.com Revision: D

FlavorFusion Icemaker Adaptor Kit Installation Instructions

1. Place bar into first set of pockets inside the ice bin

FIGURE 2

2. Place ice maker rail supports into the pockets in the ice bin as shown in Figure 2.

3. Hook cross braces over top of bar and place into outer pockets inside the ice bin (at back end).

4. Place Icemaker Adaptor Kit on top of unit.

5. Place icemaker on top of kit. DO NOT slide icemaker into position on the lid.

6. Apply a continuous bead of NSF International (NSF) listed silastic sealant (Dow 732 or equivalent),

supplied in kit to seal the icemaker to the top of the adapter kit. All excess sealant must be wiped

away immediately.

7. Secure the icemaker to the adapter by drilling 9/64” diameter holes, using one of the two brackets

supplied in the kit, into both the rear of the icemaker and rear of the icemaker adapter kit. Use

extreme care not to drill into any icemaker components!!! Secure the brackets using the screws

provided.

ICE MAKER

SUPPORT RAIL

FlavorFusion Icemaker Adaptor Kit Installation Instructions

8. The next steps discuss loading and securing the icemaker onto the kit. Please read all the

followingsteps to determine which mounting method should be utilized. Equally important is to

determine if there is sufficient access in the area of the mounting brackets after the dispenser is

lifted onto the counter. Access should be carefully considered before installation continues because

sufficient room is required for drilling holes, installing screws, etc.

Two options are supplied with this kit for securing the icemaker to the kit. (See Figure 3)

Option 1: Includes two flat brackets. This method may be used if there is sufficient access to the

back of the dispenser in the areas of the mounting brackets.

Option 2: Includes two angle brackets. This method may be used if there is not sufficient access to

the back of the dispenser in the areas of the mounting brackets. Pre-drilling holes should be

considered when using this option.

Figure 3

MOUNTING OPTION 1

(FLAT BRACKETS) MOUNTING OPTION 2

(ANGLE BRACKETS)

FlavorFusion Icemaker Adaptor Kit Installation Instructions

9. Assemble bin stat to icemaker as shown. The bin stat must not interfere with the agitator rotation

and not be in the path of ice falling from the icemaker.

FIGURE 4. BIN STAT ASSEMBLY

Installation is completed. For optimal performance, do not fill ice bin more than 2/3 capacity (maximum fill

is 4” below top of bin).

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Adaptador de Cornelius

Cornelius

Cornelius 255 Manual de usuario

Cornelius

Cornelius P/N 629087002 Manual de usuario

Cornelius

Cornelius P/N 629088650 Manual de usuario

Cornelius

Cornelius P/N 629088667 Manual de usuario

Cornelius

Cornelius P/N 620032802 Manual de usuario

Cornelius

Cornelius P/N 629088662 Manual de usuario

Cornelius

Cornelius ED 2 Series Manual de usuario

Cornelius

Cornelius P/N 629088733 Manual de usuario

Cornelius

Cornelius ED-300 Manual de usuario

Cornelius

Cornelius P/N 629088756 Manual de usuario

Cornelius

Cornelius ED Manual de usuario

Cornelius

Cornelius 629096828 Manual de usuario

Manuales populares de Adaptador de otras marcas

PCB Piezotronics

PCB Piezotronics 090B274 Manual de usuario

Auvidea

Auvidea J20 Manual del producto

Gossen MetraWatt

Gossen MetraWatt AT3-III E Manual de usuario

Akribis

Akribis ITF-21-BISS-MIT Manual de usuario

Tenda

Tenda W54U Manual de usuario

ROHO

ROHO AGILITY Manual de usuario

PROLiNK

PROLiNK WN2001 Manual de usuario

Hawking

Hawking HUF2 Manual de usuario

Airlink101

Airlink101 AWLC4030 Manual de usuario

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Manual de usuario

Philips

Philips SWA4554S/10 Manual de usuario

JVC

JVC TS-C9D2B Manual de instrucciones

NETGEAR

NETGEAR A6100 Manual de usuario

D-Link

D-Link DWA-121 Manual de usuario

Philips

Philips SWA2037 Manual de usuario

Basalte

Basalte 0610-20 Manual de usuario

Yealink

Yealink EHS40 Manual de usuario

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Manual de usuario