Concordia Ascent-Touch Manual de usuario
User Guide
Ascent-Touch Brewer
Table of Contents
Important Safety Information............................... 1
The Ascent-Touch Brewer Components .................. 2
Using the Brewed Coffee System ....................... 3
Starting the System ..................................................... 3
Machine Software Overview ................................ 4
System Menu ................................................................. 4
Accessing the System Menu...........................................4
Check Statistics ..............................................................4
Beans and the Bean Hopper................................ 5
Storing Coffee Beans.................................................... 5
Filling a Bean Hopper .....................................................5
Inserting the Hopper Stopper..........................................5
Removing the Hopper Stopper .......................................5
Cleaning and Maintenance .................................. 6
Daily Cleaning Procedures ........................................ 6
Daily Cleaning Timer.......................................................6
Perform the Clean Cycle.................................................7
Clean Drain Grate and Drain Tray ..................................9
Clean Exterior Surfaces ..................................................9
Refill Consumables .........................................................9
Display Messages.......................................................... 10
Troubleshooting ............................................................ 10
FAQ ................................................................................. 10
Customer Service (800) 778-0990 1
Important Safety Information
The safety of you and your customers is important to Concordia. The
Ascent-Touch Brewer dispenses hot liquids. Please follow all safety
precautions outlined in this manual, in order to reduce the risk of electric
shock, burns, and/or injury to persons or property.
Machine Operation
Do not use the machine for anything other than its specific
intended purpose.
Close supervision is required anytime the machine is used near
children.
Machine must be installed in a safe and stable location and in
accordance with Concordia’s installation requirements.
Machine to be installed with adequate backflow protection to
comply with the applicable federal, state, or local plumbing codes
having jurisdiction.
Do not attempt to override safety interlocks.
Do not operate the machine with unauthorized parts or
attachments. Improper use may cause fire, electrical shock,
hazard, or injury.
Hot Surfaces and Liquids
Care must be taken around the machine, as hot liquids are
produced and dispensed. Serious burns can occur.
Do not touch hot surfaces or parts.
Electrical
To protect against electrical hazards, do not immerse the power
cord, plugs, or machine in water or any other liquid.
Turn the power switch to the OFF position when the machine will
not be used for an extended period.
NOTE: Perform a thorough clean prior to switching the machine
off for an extended period. See cleaning and maintenance
procedures on page 6.
Do not operate the machine with an improper or damaged power
cord or plug, or after the machine has been damaged in any
manner.
Customer Service (800) 778-0990 2
The Ascent-Touch Brewer Components
1. Touch Screen
The touch screen provides a user-friendly interface for selecting and pouring beverages.
2. Front Door
The lower section of the front door opens to access the grounds bin for cleaning and
maintenance.
3. Product Outlet
The product outlet is where beverages and hot water are dispensed.
4. Power Switch
The power switch is located on the middle left side on the back of the machine.
5. Drain Tray and Grate
The drain tray and grate direct excess liquid to the drain.
6. Bean Hoppers
Bean hoppers store whole beans and are located on top of the machine. Up to 4 bean
hoppers may be present.
7. Grounds Bin (Not Shown - See Page 7)
The grounds bin holds the used coffee grounds and is located behind the front door. The
machine will notify you when the grounds bin is full and needs to be emptied.
1
2
3
4
7
6
5
Customer Service (800) 778-0990 3
Using the Brewed Coffee System
Starting the System
The power switch is located at the rear of the machine, on the left side.
1. Press the power switch to the ON position to start the machine.
2. Make sure the grounds bin is in place and the front door is in the
closed position when turning on the machine. The machine will not
warm up if the grounds bin is out or the front door is open.
3. The display will read:
CALIBRATING
If hot water tank is still heating when calibration is complete the display
will read:
TANK IS WARMING
Machine warm-up takes up to 10 minutes. During warm-up, the machine
is heating the water and calibrating the brew group.
WARNING: Wait at least 10 seconds between turning the machine off
and back on again. Quickly flipping the power switch on and off can blow
a fuse within the machine and/or result in machine malfunction.
Customer Service (800) 778-0990 4
Machine Software Overview
System Menu
Accessing the System Menu
Open the door to display the system menu icons.
Daily Clean
The screen will guide you through the cleaning process. For cleaning
procedures, see page 6.
Check Statistics
The screen will display the preventative maintenance schedule,
beverage counts, cleaning schedule, and other beverage statistics.
Customer Service (800) 778-0990 5
Beans and the Bean Hopper
Always use fresh, whole beans to ensure a quality beverage.
WARNING: Never place coffee beans in the grinder using your hand(s).
WARNING: Do not place ground coffee, or other foreign materials, in the bean hopper.
Storing Coffee Beans
Coffee beans are typically sealed in airtight packaging by the roaster. Once the bag has been opened, the
freshness of the beans will begin to decrease.
To store beans that have already been opened, reseal the bag, removing as much air as possible. Store at
room temperature; do not refrigerate or freeze.
Filling a Bean Hopper
1.Remove the hopper lid
2.Pour the beans into the bean hoppers
3.Replace the hopper lid
DO Use fresh, whole coffee beans.
DO NOT Place ground coffee into the bean hopper.
DO NOT Place foreign materials in the bean hopper.
DO NOT Feed beans into the grinder by hand.
Inserting the Hopper Stopper
The hopper stopper blocks the hopper chute when removing a full bean hopper.
1. Place the hopper stopper in the slot at the base of the bean hopper and push it into the bean hopper.
2. With the hopper stopper in place, you can remove a full hopper from the machine. Make sure to hold the
lid on top of the hopper
Removing the Hopper Stopper
To remove the hopper stopper once the bean hopper is back in its proper position on top of the Ascent Touch
Brewer, simply pull the hopper stopper from the bean hopper.
Hopper Stopper
Customer Service (800) 778-0990 6
Cleaning and Maintenance
To ensure sanitation, avoid mechanical failure, and ensure continual
operation, the Ascent Touch Brewer MUST be cleaned and maintained
daily.
Concordia cleaning products must be used in order to ensure proper
cleaning.
NOTE: Do NOT store cleaning products near consumables.
DO NOT USE CLEANING PRODUCTS THAT CONTAIN
BLEACH.
Daily Cleaning Procedures
Daily cleaning and maintenance can be performed in 10 minutes.
1. Perform the clean cycle
2. Empty the grounds bin
3. Clean the drain grate and the drain tray
4. Clean exterior surfaces
5. Clean the product outlet
Daily Cleaning Timer
You must clean the Ascent Touch Brewer every 24 hours. After 24
hours, the clean icon will appear in the upper right corner of the display.
You must clean the machine within the next two hours.
If the machine is not cleaned within two hours after the clean icon
appears the machine will be disabled and you will not be able to pour
drinks until the clean cycle has been performed.
(Clean Icon)
Customer Service (800) 778-0990 7
Perform the Clean Cycle
1. Open the door to show the option icons on top right of screen.
2. Press the DAILY CLEAN icon.
3. Press START CLEAN.
4. The display will show:
PLEASE TAKE OUT AND CLEAR GROUNDS BIN
5. Open the front door and remove the grounds bin. Once the grounds
bin has been emptied and placed back in the system, close the door
and press NEXT STEP.
6. The display will show: GETTING READY
Customer Service (800) 778-0990 8
WARNING: The chamber and surrounding areas will be hot!
7. Use the cleaning brushes provided to clear all coffee debris from the
brew group area. Clean the grinder chutes thoroughly with the white
bristled tube brush. Ensure all coffee grounds have been cleared
from the chute opening. Clean the piston, chamber, and sweep arm
with the paint brush.
8. Close the door and press NEXT STEP.
9. The display will show: RINSING
10. Wait until the rinse cycle finishes and the display shows: DROP
CLEANING TABLET INTO CHAMBER
11. Place one cleaning tablet in the brew chamber and press NEXT
STEP.
Tabla de contenidos
Manuales populares de Sistema de elaboración de cerveza de otras marcas
Curtis
Curtis ThermoPro G4 Series Manual de usuario
Animo
Animo ComBi CB5 Manual de usuario
MoreBeer
MoreBeer BrewSculpture Manual de usuario
Keurig Hot
Keurig Hot Commercial Series Manual de usuario
Keg King
Keg King KEGMASTER XL Manual de usuario
Blichmann Engineering
Blichmann Engineering BrewEasy Compact TC Instrucciones de instalación