Computherm Q7 RF Manual de usuario
COMPUTHERM
Q7RF
Programmable wireless (radio-frequency)
digital room thermostat
Operating Instructions
You can watch the most important aspects of the usage of this thermostat on our video
presentation at www.computherm.info.
- 3 -
GENERAL DESCRIPTION OF THE THERMOSTAT
The
COMPUTHERM
Q7RF type switched-mode room ther-
mostat is suitable to regulate the overwhelming majority of
boilers and air conditioners. It can be easily connected to any
gas boiler having a two-wire thermostat connection point and
to any air conditioning apparatus or electrical apparatus, re-
gardless of whether they have a 24 V or 230 V control circuit.
230 V AC
50 Hz
230 V AC
50 Hz
Boiler
Receiver
Thermostat
- 4 -
The device can be programmed according to customer-spe-
cic requirements so that the heating/cooling system heats/
cools your residence or oce to the required temperature at
the dates and times specied by you, to reduce energy costs
while maintaining comfort. Separate temperature programs
can be prepared for each day of the week. For each day, be-
side 1 xed switching time (PROG ), 6 adjustable switching
times (PROG –PROG ) can be set (at 10-minute intervals)
and a dierent temperature (in 0.5 °C increments) can be as-
signed to all 7 switching times.
The device consists of two units. One of them is the portable
control unit (thermostat), while the other unit is the receiver
that controls the boiler. Because there is a wireless (radio-
frequency) connection between the two units, no cable is
required between the thermostat and the boiler. The two units
have been tuned in the factory. The trouble-free operation
is ensured by its own security code. The installation and
connection of the receiver unit is described in Chapter 10.
- 5 -
To increase the lifetime of the batteries, the thermostat will not
transmit signals continuously. Instead it will repeatedly transmit
the actual signal every 8 minutes. Therefore, the regulation of
the heating or cooling will continue even after a blackout.
The days of
the week
Manual control
indicator
Current
temperature
of the room
Set
temperature
Low battery
voltage
Sign of the
boiler/air
conditioner
working
Time / Time left
time from manual
modication
Program number
Temperature
modication
until the
next manual
interference
Timed manual
control
indication
The information shown on the liquid crystal
display of the thermostat includes the following:
- 6 -
The portability of the thermostat oers the following ad-
vantages:
• no need to lay a cable, which is especially advantageous
when old buildings are being modernized,
• the optimal location of the device can be selected during
operation,
• it is also advantageous when you intend to locate the
thermostat in dierent rooms in the course of the day (e.g.
in the living room during the day but in the bedroom at
night).
The effective range of the transmitter incorporated in the
thermostat is approximately 50 m in open terrain. This
distance may become considerably shorter within a building,
especially when a metal structure, reinforced concrete or
adobe wall stands in the way of radio waves.
This wireless (radio-frequency) thermostat can also be easi-
ly extended with the
COMPUTHERM
Q1RX socket if needed,
with which the thermostat is able to control any electrical de-
vice (e.g. fan heaters, pumps, zone valves, etc.) operating on
- 7 -
230 V (50 Hz; max. 16 A) according to the room temperature.
(Detailed description of the
COMPUTHERM
Q1RX socket and
usage suggestions can be found on our website www.com-
putherm.info.)
The
COMPUTHERM
Q7RF thermostat can be used as an ex-
tension to the
COMPUTHERM
Q5RF or Q8RF multi-zone de-
vices.
The simultaneous use of several
COMPUTHERM
room thermo-
stats and one
COMPUTHERM
Q4Z zone controller provides the
possibility for the thermostats to also control a pump or a zone
valve in addition to starting the heater or cooler. This way it is
easy to divide a heating / cooling system into zones, thanks
to which the heating / cooling of each room can be controlled
separately, thus greatly increasing comfort. Furthermore, the
zoning of the heating / cooling system will greatly contribute to
the reduction of energy costs, as due to this only those rooms
will be heated / cooled at any time where it is required.
- 8 -
1. LOCATION OF THE DEVICE
The thermostat of the
COMPUTHERM
Q7RF type device can
be freely moved in your residence. It is reasonable to locate it
in a room used regularly or for many hours per day so that it is
in the direction of natural ventilation in the room but protected
from drought or extreme heat (e.g. direct sunlight, refrigerator,
chimney, etc). Do not use in wet, chemically aggressive or dusty
environment. Its optimal location is 0.75 - 1.5 m above oor level.
It can be placed on its own stand or can be mounted on a wall.
IMPORTANT WARNING! If the radiator valves in your
flat are equipped with a thermostatic head, adjust it to
maximum temperature or replace the thermostatic head of
the radiator valve with a manual control knob in the room
where the room thermostat is to be located, otherwise the
thermostatic head may disturb the temperature control of
the flat.
- 9 -
2. PUTTING THE THERMOSTAT INTO
OPERATION, BASIC SETTINGS
2.1 Inserting batteries
Pressing the lock on the upper
side of the housing of the ther-
mostat, remove the back cover
of the thermostat as shown in
the figure below.
The battery compartment is in
the inner side of the front panel
of the housing. Insert 2 AA alkaline batteries (LR6 type) in
accordance with the diagram in the battery compartment.
Warning! Alkaline batteries may only be used for this
appliance. Carbon-zinc batteries known as durable or long
life batteries and chargeable accumulators are not suitable
for the operation of this appliance. Icon appearing on the
display to indicate low battery voltage warns reliably that the
batteries should be replaced only when alkaline batteries
are used.
- 10 -
After the batteries have been inserted, the display flashes
the day, time and program number as well as the adjusted
and measured temperatures. (If this information fails to
appear on the display, press the “RESET” button located on
the main panel of the thermostat. After the batteries have
been inserted, snap the front panel of the device into the rear
panel and press the “SET” button. After the “SET” button is
pressed, the display stops flashing, the thermostat goes to
the main screen and the setting process can be started.
2.2 Setting the current day and time
Press the “SET” button to go to the main screen, then press
the “DAY ” button. At this time only the first three letters of
the current day of the day will flash on the display of the
thermostat and the hour and minute values can be seen.
Using the large and buttons on the front panel of
the device, set the current day (Monday MON; Tuesday TUE;
Wednesday WED, etc.). Press the “DAY” button again. At this
time the abbreviation indicating the day stops flashing and
Otros manuales para Q7 RF
3
Tabla de contenidos
Otros manuales de Termostato de Computherm
Computherm
Computherm Q5RF Manual de usuario
Computherm
Computherm Q3 Manual de usuario
Computherm
Computherm Q7 Manual de usuario
Computherm
Computherm Q5RF Manual de usuario
Computherm
Computherm q3rf Manual de usuario
Computherm
Computherm Q8RF Manual de usuario
Computherm
Computherm E300 Manual de usuario
Computherm
Computherm Q7 RF Manual de usuario
Computherm
Computherm T30RF Manual de usuario
Computherm
Computherm S300 Manual de usuario
Computherm
Computherm E Series Manual de usuario
Computherm
Computherm E280 Manual de usuario
Computherm
Computherm B300RF Manual de usuario
Computherm
Computherm Q3 Manual de usuario
Computherm
Computherm B Series Manual de usuario
Computherm
Computherm Q5RF Manual de usuario
Computherm
Computherm Q7 Manual de usuario
Computherm
Computherm q3rf Manual de usuario
Computherm
Computherm B Series Manual de usuario
Computherm
Computherm Q7 RF Manual de usuario
Manuales populares de Termostato de otras marcas
EWELLY
EWELLY EW-181 Manual de usuario
Prolon
Prolon T1100 Instrucciones de instalación
Heatmiser
Heatmiser neoStat Manual de usuario
Aube Technologies
Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario
Mars
Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario
Saswell
Saswell SAS920XWHB-7-S-RF Guía
