Compaq Netelligent 3024 Manual de usuario
Netelligent 3024/3124
10Base-T Repeater
User Guide
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
iii
Writer: Chris Seiter Project: NOTICE Comments: 185815-001/707049-001
File Name:1_NOTICE.DOC Last Saved On:3/28/96 10:31 AM
NOTICE
The information in this publication is subject to change without notice.
COMPAQ COMPUTER CORPORATION SHALL NOT BE LIABLE FOR TECHNICAL OR
EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN, NOR FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR
USE OF THIS MATERIAL.
This publication contains information protected by copyright. No part of this publication may be
photocopied or reproduced in any form without prior written consent from Compaq Computer
Corporation.
The software described in this guide is furnished under a license agreement or non disclosure
agreement.
The software may be used or copied only in accordance with the terms of the agreement.
Product names mentioned herein may be trademarks and/or registered trademarks of their respective
companies.
1996 Compaq Computer Corporation.
All rights reserved. Printed in the U.S.A.
Compaq
Registered United States Patent and Trademark Office.
Netelligent is a trademark of Compaq Computer Corporation.
Compaq Netelligent 3024/3124 10Base-T Repeater
User Guide
Second Edition (April 1996)
Part Number 185815-002
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
v
Writer: Chris Seiter Project: NOTICE Comments: 707049-001 /185815-002
File Name:2_NOTICE.DOC Last Saved On:3/27/96 10:52 AM
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions in
this manual, may cause interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Class A devices bear a label indicating the interference potential of the device as well as additional
operating instructions for the user, such as the following: This device complies with Part 15 of the Federal
Communications Commission (FCC) Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Canadian Department of Communications
Radio Frequency Statement
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus
set out in the Radio Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux
appareils numriques de la classe A prescrites dans le Règlement sur le brouillage radioélectrique édicté par
le ministères des Communications du Canada.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not
expressly approved by Compaq Computer Corporation may void the user’s authority to operate the
equipment.
Emissions
This equipment complies with EMC directive 89/336/EEC (ITE), which includes EN50081-1 CLASS 1:
1992 (EN55022/CISPR 22 for Class A ITE). It also complies with FCC Class A.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
vi
Writer: Chris Seiter Project: NOTICE Comments: 707049-001/185815-002
File Name:2_NOTICE.DOC Last Saved On:3/27/96 10:52 AM
European Union Notice
Products with the CE (Community European) Marking comply with both the EMC Directive (89/336/EEC)
and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Norms:
■ EN55022 (CISPR 22) - Electromagnetic Interference
■ EN50082-1 (IEC801-2, IEC801-3, IEC801-4) - Electromagnetic Immunity
■ EN60950 (IEC950) - Product Safety
Safety
This equipment complies with UL 1950, Second Edition; CAN/CSA C22.2 No. 950-93, 73/23/EEC Low
Voltage Directive; TUV Rheinland EN60950, 1988; A1/1990, 1993; and A2/1992, 1992, 1993.
Immunity
This equipment complies with EMC directive 89/336/EEC (ITE), which includes EN 50082-1:
■ IEC 801-2 (Electrostatic Discharge)
■ IEC 801-3 (Radiated Immunity)
■ IEC 801-4 (Electrical Fast Transient/Burst)
■ EN55101-4 (Conducted Immunity) (not currently required)
Lithium Battery
The non-volatile RAM (NVRAM) chip on the motherboard contains a non-replaceable lithium battery.
Only trained service personnel should dispose of this chip.
La puce mémoire non volatile contient une pile au lithium non remplaçable. L'élimination de cette puce
devrait être confiée à un personnel qualifié
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
vii
Netelligent 3024/3124 10Base-T Repeater User Guide
Writer: Liz Fischer Project: Contents Comments: 185815-002/707049-001
File Name:T2STM_T.DOC Last Saved On:3/15/96 12:35 PM
Contents
Preface
What in This Guide?.................................................................................................ix
Chapter 1
Overview
Repeater Features....................................................................................................1-1
Management Features.............................................................................................1-2
Technical Specifications.........................................................................................1-3
Dimensions......................................................................................................1-3
Connectors.......................................................................................................1-3
LED Indicators/Configuration Button...............................................................1-3
Environment ....................................................................................................1-4
Front Panel and Back Panel ....................................................................................1-4
Lithium Battery ......................................................................................................1-5
Chapter 2
Media Connection Options
Using the UTP Media Option and Extended Distance.............................................2-1
Configuring Extended Distance for UTP Wiring.....................................................2-2
Using the BNC Media Option.................................................................................2-3
Using the AUI Media Option..................................................................................2-4
Using the Fiber Media Option.................................................................................2-4
Chapter 3
Setting Up the Repeater
Selecting a Location ...............................................................................................3-1
Environmental Requirements...........................................................................3-1
Electrical Requirements...................................................................................3-1
Spatial Requirements .......................................................................................3-1
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
viii
Writer: Liz Fischer Project: Contents Comments: 185815-002/707049-001
File Name:T2STM_T.DOC Last Saved On:3/15/96 12:35 PM
Connecting Power...................................................................................................3-2
Self-Test.................................................................................................................3-4
UTP Cabling Considerations...................................................................................3-5
Twisted-Pair Wire Specifications.....................................................................3-5
Connecting to a Network Station......................................................................3-8
Stacking Repeaters..................................................................................................3-9
Disconnecting Power......................................................................................3-10
Connections Between Repeater Stacks..................................................................3-11
Chapter 4
What Is Segmentation?
Defining Ethernet Segmentation ........................................................................... `4-1
Backplanes and Segmentation.................................................................................4-2
Examples of Network Configurations......................................................................4-3
Example 1........................................................................................................4-5
Example 2........................................................................................................4-6
Example 3........................................................................................................4-8
Example 4........................................................................................................4-9
Example 5......................................................................................................4-10
Chapter 5
Configuring/Monitoring the Repeater
Note for HubView Users.........................................................................................5-1
Configuration Modes ..............................................................................................5-2
Port Activity Monitor (Default Mode).....................................................................5-3
Switching Between Modes...............................................................................5-4
Backplane Segment (Mode 1).................................................................................5-5
Assigning Backplane Segments........................................................................5-6
Link Integrity Enable/Disable (Mode 2)..................................................................5-7
Enabling and Disabling Link Integrity..............................................................5-8
Port Enable/Partition (Mode 3) ...............................................................................5-9
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ix
Netelligent 3024/3124 10Base-T Repeater User Guide
Writer: Liz Fischer Project: Contents Comments: 185815-002/707049-001
File Name:T2STM_T.DOC Last Saved On:3/15/96 12:35 PM
Enabling and Partitioning Ports......................................................................5-10
Chapter 6
Using the Serial COM Port
Serial COM Port.....................................................................................................6-1
Connecting to a Modem...................................................................................6-1
Local Console Interface ...................................................................................6-2
Updating Firmware..........................................................................................6-3
In-Band Management..............................................................................................6-4
Appendix A
Installing a Management Daughterboard
Requirements for the Management Daughterboard.................................................A-1
A Note About Repeater MAC Addresses................................................................A-2
Mounting the Management Daughterboard ............................................................A-3
Glossary
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ix
Neteilligent 3024/3124 10Base-T Repeater User Guide
Writer: Liz Fischer Project: Preface Comments: 185815-002/707049-001
File Name:T2STM_P.DOC Last Saved On:3/27/96 11:32 AM
Preface
This guide describes the configuration and installation of the Compaq
Netelligent 3024/3124 unmanaged and managing 10Base-T repeaters (Part
Numbers 267055-001 and 267060-001, respectively). It is important to review
all chapters of this publication to ensure a successful installation.
Verify that this package contains the following items:
■ 3024/3124 10Base-T repeater with factory-installed UTP media
connector
■ Power cord
■ Compag Netelligent 3024/3124 10Base-T Repeater User Guide
■ Warranty card
What's in This Guide?
Chapter 1— Provices a list of product features, specifications and
requirements.
Chapter 2 — Describes the type of cabling connections available for the
TriSegment repeater.
Chapter 3 — Explains installation procedures. This chapter also details basic
UTP wiring information for workstation connections.
Chapter 4 — Provides a primer for repeater segmentation and configuration
examples.
Chapter 5 — Explains how to view repeater status, select backplane segment
assignments, enable/disable link integrity and partition/enable port
assignments.
Chapter 6 —Describes how to download software and update firmware via
the repeater's front-panel serial port. This chapter also includes information
about in-band management.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
x
Preface
Writer: Liz Fischer Project: Preface Comments: 185815-002/707049-001
File Name:T2STM_P.DOC Last Saved On:3/27/96 11:32 AM
Appendix A — Explains how to upgrade an unmanaged repeater to a
managing repeater
Glossary — Provides a list of common terms used in the guide.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1-1
Netelligent 3024/3124 10Base-T Repeater User Guide
Writer: Liz Fischer Project: Overview Comments: 185815-002/707049-001
File Name:T2STM1.DOC Last Saved On:3/27/96 11:35 AM
Chapter 1
Overview
The Compaq Netelligent 3024/3124 10Base-T unmanaged and managing
repeaters provide 23 10Base-T connections and one modular connection,
which can be 10Base-T (an STP/UTP module is factory installed), Thinnet,
AUI, or Fiber (FOIRL). There are two models available:
■ 3024 10Base-T Repeater (Unmanaged), Part Number 267055-001
■ 3124 10Base-T Repeater (Managing), Part Number 267060-001
Each repeater can support up to three separate eight-port backplane segments
(separate collision domains) and each segment can stand alone or connect to
another segment. The repeater’s plug and play design lets you quickly and
easily connect up to five repeaters in a single stack. No jumpering is required.
The configuration button conveniently located on the repeater's front panel
lets you quickly and easily configure the repeater and divide port groups into
segments.
Repeater Features
The repeater includes these features:
■ 100% NetWare optimized
■ Twenty-four ports: 23 STP/UTP and one modular UTP media module.
Optional media connectors support Thinnet, AUI, and Fiber (FOIRL)
wiring.
■ Support of up to three independent, eight-port backplane segments
(collision domains) per repeater
■ Expandable to five repeater stacks, supporting up to 15 Ethernet
segments and 120 ports
■ Configuration button/LED user interface provides convenient
management on the fly by enabling the user to assign backplane
segments, enable or partition ports, and enable/disable link integrity for
each port
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Reloj de repetición de Compaq
Compaq
Compaq Netelligent 1108 Manual de usuario
Compaq
Compaq Netelligent 1124 Manual de usuario
Compaq
Compaq Netelligent 2008 Manual de usuario
Compaq
Compaq Netelligent 3512 Manual de usuario
Compaq
Compaq Netelligent 2524 Manual de usuario
Compaq
Compaq Netelligent 1009 Manual de usuario
Compaq
Compaq Netelligent 1224 Manual de usuario
Compaq
Compaq Netelligent 1016 Manual de usuario
