Compaq 303500-001 - V 900 - 19" CRT Display Manual de usuario
303512-BK1
Finished Size:
-1/2 by 8-1/2 inches User's Guide
Compaq V900 Color Monitor
cover.p65 9/21/98, 2:31 PM1
303512-BK1
Finished Size:
-1/2 by 8-1/2 inches User's Guide
Compaq V900 Color Monitor
cover.p65 9/21/98, 2:31 PM1
ttttt
Part Number 303512-BK1 Writer: Marianne Silvetti - Saved by Alyce Klingler
Saved date: 09/21/98 2:11 PM
Nicklaus 303512u1
Notice
The information in this guide is subject to change without notice.
COMPAQ COMPUTER CORPORATION SHALL NOT BE
LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR
OMISSIONS CONTAINED HEREIN; NOR FOR INCIDENTAL
OR CONSEQUENTIAL DAMAGES RESULTING FROM THE
FURNISHING, PERFORMANCE, OR USE OF THIS
MATERIAL.
This guide contains information protected by copyright. No part of this
guide may be photocopied or reproduced in any form without prior
written consent from Compaq Computer Corporation.
1998 Compaq Computer Corporation.
All rights reserved. Printed in Taiwan.
Compaq, Deskpro, and QVision are registered in the U. S. Patent and
Trademark Office.
Microsoft, MS-DOS, Windows, Windows NT, and other names of
Microsoft products referenced herein are trademarks or registered
trademarks of Microsoft Corporation.
ENERGY STAR is a U.S. registered mark.
Product names mentioned herein may be trademarks and/or registered
trademarks of their respective companies.
The software described in this guide is furnished under a license
agreement or nondisclosure agreement. The software may be used or
copied only in accordance with the terms of the agreement.
User’s Guide
Compaq V900 Color Monitor
First Edition (July 1998)
Part Number 303512-001
Compaq Computer Corporation
English 1-1
ttttt
Part Number: 303512-001 - Writer: Marianne Silvetti - Saved by: Alyce Klingler
Saved date: 09/21/98 2:11 PM
File Name: Nicklaus
book 1
English
Introduction
The Compaq V900 Color Monitor is a microprocessor-based, intelligent
scanning monitor with a 0.22 horizontal dot pitch that supports
resolutions up to 1600 × 1200.
Product Features
The monitor features include the following:
■ 19-inch (18 in/45.7 cm viewable) FS CRT
■ Easy-to-access front panel controls to adjust screen brightness and
contrast
■ On-screen display in six different languages: English, Dutch,
French, German, Italian, and Spanish
■ Diskette that contains an information file (INF) and an Image
Color Matching file (ICM) for configuring your monitor
■ Universal Serial Bus (USB) bus-powered hub for use with USB
peripherals (mouse, keyboard, etc.)
■ Plug and play capability, if supported by your system
■ Automatic scanning of all horizontal frequencies between 30
and 96 kHz, and vertical frequencies between 48 and 160 Hz
■ Support for VGA and Super VGA to 1600 × 1200 resolutions
■ Energy Saver feature that, when activated, results in a power
savings of greater than 94 percent
■ Macintosh-compatible timing with optional connector*
■ Compliance with the following regulated specifications:
❏ EPA Energy Star
❏ European Union CE Directives
❏ Swedish TCO 1995
*A Macintosh-compatible connector is not supplied with this monitor.
1-2 English
Part Number: 303512-001 - Writer: Marianne Silvetti - Saved by: Alyce Klingler
Saved date: 09/21/98 2:11 PM
File Name: Nicklaus
Graphics Driver
This monitor may require a graphics driver (and/or .INF file) that is
compatible with your computer's graphics adapter. Compaq has created
a Universal Driver Manager (UDM) release that supports all Compaq
QVision, S3, Cirrus Logic, and Matrox graphics adapters found on
Compaq Deskpro and Compaq Workstation products. The UDM eases
graphics driver deployment across Compaq platforms ensuring cross-
compatibility and backward-compatibility. The resulting solution
enables customers to manage and control ongoing software maintenance
costs. The UDM is available on the Support Software CD for Compaq
Desktop, Portable, and Workstation Products, and the Compaq World
Wide Web site (www.compaq.com).
■ You can order the Support Software CD for Compaq Desktop,
Portable, and Workstation Products. This compact disc contains
the latest device drivers, utilities, and flashable ROM images
needed to run MS-DOS, Microsoft Windows 3.1, Windows 95,
Windows NT workstation, and IBM OS/2 on your Compaq
commercial desktop product.
■ You can download the software from the Compaq World Wide
Web site (www.compaq.com).
■ You can purchase backup diskettes.
If you choose to purchase the Support Software CD, you have two
options:
■ You can purchase a single CD-ROM that gives you one-time
access to the latest support software (North America only,
Compaq part number 272505-001).
■ You can purchase a yearly subscription that delivers up to 12
monthly CD-ROMs (Compaq part number 183426-xxx).
The annual subscription ensures your continuous access to the latest
developments.
For help and service outside of the U.S. and Canada or to order the CD
or backup diskettes, contact your Compaq authorized reseller, dealer, or
service provider.
English 1-3
Part Number: 303512-001 - Writer: Marianne Silvetti - Saved by: Alyce Klingler
Saved date: 09/21/98 2:11 PM
File Name: Nicklaus
Information Files
This monitor includes a diskette with two information files that should
be installed onto your computer—an INF file and an ICM file. The INF
file defines monitor resources, and provides specifications used by
Windows 95 to install support software for certain hardware devices.
The INF file ensures monitor compatibility with your computer’s
graphics adapter. The ICM file provides color matching consistency
from monitor screen to printer and is activated from within the graphics
programs that have this feature. To install these files onto your
computer, follow the instructions on the “Configuring Your Compaq
CRT Monitor” card located in the Program License Agreement packet
along with the diskette.
Installing the Monitor
To install the monitor, ensure that the power to the monitor, computer
system, and other attached devices is turned off; then follow these steps:
1. Place the monitor in a convenient, well-ventilated location near
your computer.
2. Connect the monitor signal cable to the 15-pin connector 1on
the rear panel of the computer. Tighten the screws on the end of
the connector.
IMPORTANT: Be sure the signal cable aligns with the 15-pin connector.
Do not force the cable onto the connector or you may damage the signal
cable.
3. Connect the monitor power cord 2to the connector that is
beneath the back panel of the monitor, then plug the other end of
the cord into an electrical outlet that is easily accessible and close
to the monitor.
1-4 English
Part Number: 303512-001 - Writer: Marianne Silvetti - Saved by: Alyce Klingler
Saved date: 09/21/98 2:11 PM
File Name: Nicklaus
!WARNING: To reduce the risk of electric shock or damage to
your equipment:
Do not disable the power cord grounding plug. The
grounding plug is an important safety feature.
Plug the power cord into a grounded (earthed) electrical
outlet that is easily accessible at all times.
Disconnect power from the monitor by unplugging the
power cord from the electrical outlet.
USB Connectors
The base of the monitor has three Universal Serial Bus (USB)
connectors. USB connectors provide plug and play installation of USB-
compatible plug and play devices such as a keyboard, mouse, or
joystick. To use a USB device, ensure the system is powered on, and
plug the device into the USB connector. Use USB connector 3to
connect the USB signal cable to the computer. Use Connectors 1and 2
to connect USB-compatible plug and play devices to the monitor.
IMPORTANT: These USB connectors are not designed for use with high-
power USB devices such as a video camera, scanner, etc. Compaq
recommends connecting high-power USB devices directly to the
computer.
English 1-5
Part Number: 303512-001 - Writer: Marianne Silvetti - Saved by: Alyce Klingler
Saved date: 09/21/98 2:11 PM
File Name: Nicklaus
To maintain the integrity of signal transfers on USB devices, do not use
a cable extender with any USB cables. Low-power USB devices usually
have an attached cable that measures about 3 meters.
✎Most USB-connected devices will operate with Compaq
computers using Microsoft Windows 95, OSR 2.1. If a USB-
connected device fails to operate, it may require a special
device driver that is not supplied with this version of Microsoft
Windows. Contact your vendor for driver availability.
✎Do not connect or daisy-chain a bus-powered device (example:
mouse) to a bus-powered hub device (example: keyboard) that
is connected to a USB connector on this monitor. The
secondary bus-powered device will not operate. All USB bus-
powered devices should be connected directly to the monitor or
to your computer.
1-6 English
Part Number: 303512-001 - Writer: Marianne Silvetti - Saved by: Alyce Klingler
Saved date: 09/21/98 2:11 PM
File Name: Nicklaus
Operating the Monitor
Front Control Panel
No./Icon Control Function
1Contrast Adjusts contrast by turning control to left or right.
2Brightness Adjusts brightness by turning control to left or right.
3Select button 1. Launches on-screen display.
2. Selects function adjustments.
3. Exits menus and on-screen display.
4-Minus button Selects and adjusts the functions.
5+Plus button Selects and adjusts the functions.
6Power switch Turns the monitor on and off.
7Power LED 1. Green indicates monitor is turned on.
2. Yellow indicates suspend mode.
3. Amber indicates sleep mode.
English 1-7
Part Number: 303512-001 - Writer: Marianne Silvetti - Saved by: Alyce Klingler
Saved date: 09/21/98 2:11 PM
File Name: Nicklaus
On-Screen Display Settings
The adjustments for screen settings are located in the on-screen display
and can be viewed in one of six available languages. The on-screen Main
Menu displays the eight functions listed below, the Second Level Menu
displays a variety of selections for screen settings, and the Third Level
Menu displays adjustment scales, toggle switches, etc., for screen settings.
Main Menu 2nd Level Menu 3rd Level Menu
Size and Position Horizontal Size
Horizontal Position
Vertical Size
Vertical Position
Adjustment scale
Overscan: ON/OFF
Geometry/Moiré Pincushion
Pincushion Balance
Trapezoid
Parallelogram
Tilt
Adjustment scale
Horizontal Moiré
Vertical Moiré Adjustment scale
Color 9300 K
6500 K
5500 K
User Color 1
User Color 2
User Color 3
Adjust individual red, green, and
blue colors of the display.
H-Convergence
V-Convergence Adjustment scale
Degauss
Language Lists six languages
available to display on-
screen menus.
Management Power saver
Display Mode
Serial No.
Sleep Timer
ON OFF
ON OFF
(displays Serial No.)
Set Current Time
Set SLEEP Time
Set ON Time
TIMER: ON/OFF
SLEEP NOW
Master Reset Confirm Master Reset
Factory Reset Reset
Cancel
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Monitor de Compaq
Compaq
Compaq V710 Manual de usuario
Compaq
Compaq 8000 - Elite Convertible Minitower PC Manual de usuario
Compaq
Compaq CV7500 Manual de usuario
Compaq
Compaq 378901-008 - FP 700 - 15" LCD Monitor Instrucciones de instalación
Compaq
Compaq P700 Manual de usuario
Compaq
Compaq P1220 Manual de usuario
Compaq
Compaq MV 540 Manual de usuario
Compaq
Compaq ProLiant 5500 Manual de usuario
Compaq
Compaq Q2009 - Compaq - Widescreen LCD Monitor Cómo utilizar
Compaq
Compaq TFT1701 Manual de usuario
Compaq
Compaq S920 Instrucciones de uso
Compaq
Compaq 7500 Series Manual de usuario
Compaq
Compaq MV5500 Instrucciones de uso
Compaq
Compaq P900 Manual de usuario
Compaq
Compaq 2025 Manual de usuario
Compaq
Compaq Compaq S710 Manual de usuario
Compaq
Compaq 1024 Manual de usuario
Compaq
Compaq Flat Panel Monitor tft5017m Manual de usuario
Compaq
Compaq P700 Manual de usuario
Compaq
Compaq P 110 Manual de usuario
