CommScope TC-96370-IP Manual de usuario

12 Port Single Fiber Splice Cassette for

Propel Panel

PROPEL

PRODUCT PAGE

QR CODE

Prepare cable for single fiber splice cassette installation

Group feeder fibers into two groups (1-12 and 13-24), then refer to Table 1 for

Feeder and Pigtail Lengths. “Feeder Strip Length” is the recommended length

of fiber to bring into the cassette. “Feeder Cut Length” and “Pigtail Cut Length”

is measured from the front of the cassette and is the recommended cut length

for the initial splice. A maximum of (1) rework is allowed per splice.

Route fibers into base

(a) Position spools to prepare for routing. (b) Route pigtail and feeder fibers

corresponding to fibers 1-12 counterclockwise starting along the outer half of

the cassette and work inwards with each consecutive loop. (c) Line up the pegs

on the cassette base with the mounting holes on the spool to finish routing.

(d) Insert spool into base and ensure all fibers are under retaining fingers.

(e) Position spool of fiber 13-24 as shown to prepare for routing. Ensure fibers

are tucked under retaining feature (f) Repeat steps a-d until routing is completed.

Apply Cover

(a) Line the cover with the slots near the front of the cassette base. (b) Lay

the cover flat on the base and ensure all the tabs on the side of the cover

and bases are lined up. With one hand holding the cassette base, push cover

forward with other hand to engage tabs. Double check the rear tab is

also engaged to prevent the cover from sliding off.

Table 1: Pigtail and Feeder Lengths

12 Port Cassette, shown above

Tools and Materials Required

FIBER FUSION SPLICER

AND CLEAVER

STRIPPER

FIBER SCISSORS

SMALL SIDE CUTTER

TAPE

MEASURE

MARKER

TAPE

ISOPROPYL

ALCOHOL INCLUDED:

SPLICE PROTECTORS

(40 mm LONG)

and CABLE TIES

(30 - 40 mm LONG)

Page 1 of 4Page 4 of 4

Quick

Start

TC-96370-IP · Rev B · August, 2023

Strength Member

Splice

Protectors

Feeder

Pigtail

Feeder

Prepare to place feeder

fiber in cassette

Using thumb & finger, disengage

rear tab by lifting and pulling

backward to remove the cover.

Remove cassette cover Measure and trim pigtail and feeder

Install feeder fiber in splice cassette

http://www.commscope.comhttp://www.commscope.com

(a) Strip fibers to recommended Feeder Strip length per table 1. Leave

approximately 1” (2.5 cm) of strength member. Secure cable tie around fiber

strength member. (b) Optional: Wrap smaller diameter cable with provided grey

foam for better securement. (c) Snip off ends of cable ties close to head.

(d) Push the head downward until it is below the top of the cassette wall.

(If using a 24f cable, separate fibers 1-12 and 13-24. Then use one tie-off

location at the cassette entry point.)

(a) Remove spool and splice

holder from cassette. Locate

ends of pigtail marked with tape.

(b) Unspool and extend pigtail

fiber beyond front of cassette.

Extend feeder fibers beyond the front of the cassette base, then measure and

trim pigtail and feeder to specified cut length per Table 1.

Install splice protectors

on all fibers to be spliced

Use provided splice protectors.

Splice protector length should be

45mm maximum.

Splice feeder and pigtail

fibers

Strip, clean, and splice fibers

following recommened method.

Preparing to load splice

protectors

Locate “P” and “F” marking on

spool. When loading splice

protectors, ensure pigtail is exiting

spool through the side with “P”

marking and the feeder is exiting

through the side with “F” marking.

bLoad splice protectors

into splice holder

(a) Load splice protectors into

splice holder (b) Utilizing the spool

fiber retainers, route pigtail fibers

counterclockwise until feeder and

pigtail fibers converges.

Page 2 of 4 Page 3 of 429004-A

Otros manuales de Hardware de red de CommScope

CommScope

CommScope NG4access ODF Platform Value-Added Module Manual de usuario

CommScope

CommScope CPP-UDDM-SL-1U-24 Manual de usuario

CommScope

CommScope RUCKUS SmartZone 300 Manual de usuario

CommScope

CommScope FPX Series Manual de usuario

CommScope

CommScope LSX Manual de usuario

CommScope

CommScope FOSC-OC-6 Manual de usuario

CommScope

CommScope Mini-OTE 300 Manual de usuario

CommScope

CommScope AMP NETCONNECT MRJ21 Manual de usuario

CommScope

CommScope FDC-W8-FAT Manual de usuario

CommScope

CommScope SYSTIMAX AirSPEED AP542 Manual de usuario

CommScope

CommScope UNJ10G Manual de usuario

CommScope

CommScope ION-M7P Manual de usuario

CommScope

CommScope NOVUX DSC 650 Manual de usuario

CommScope

CommScope MRJ21 Quick Fit Cassette Manual de usuario

CommScope

CommScope ONECELL RP5200 Manual

CommScope

CommScope CPPR-QF-F-1U-E Manual de usuario

CommScope

CommScope NETCONNECT 1479542-1 Manual de usuario

CommScope

CommScope WCS-2 Manual de usuario

CommScope

CommScope NG4access ODF Platform Value-Added Module Manual de usuario

CommScope

CommScope ION-U EU H 23/23 Manual de usuario

CommScope

CommScope SYSTIMAX 100BASE-T Manual de usuario

CommScope

CommScope SYSTIMAX EHD Manual de usuario

CommScope

CommScope SCIL-B Manual de usuario

CommScope

CommScope Uniprise Solutions HFTP-HD6B-1U-24 Manual de usuario

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

D-Link

D-Link ShareCenter DNS-320L Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

D-Link

D-Link ShareCenter DNS-343 Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario