4. Service. Installation and Start-up Chocolino Duo / Cafélino Duo
1. Place the machine on a flat Connect the plug to an
waterproof surface. earthed 230V 10A wall outlet.
Note: Make sure air is able to circulate freely
behind the machine.
2. Connect the factory-supplied tube to the cold water feed using a ½” R- connection
piece. Make sure no folding or sharp bending occurs when you push the machine
back in place.
If the water pipeline is new, flush the system with water first to remove copper
shavings. These can damage the inlet valve.
The new tube set supplied with the appliance must be used. Old tubes may not be
reused. Connection to a closable valve is recommended.
Min. water pressure; 2 bar (200kPa). Max. water pressure: 8 bar (800kPa).
3. Open the water tap.
4. Hit the ON/OFF switch inside the panel.
The water tank will fill automatically with
1.8 litres of water.
The element will not be powered until the water
reaches the level indicator.
The temperature is set to 85º Celsius.
5. Shut the panel door.
8.
ON / OFF
switch
