Coca-Cola FREESTYLE 9000 Guía de referencia

Classified - Confidential

Memo: Coca-Cola Freestyle Extended Shutdown

(72 Hours or more) Re-open Procedures (9000)

We understand that business needs are changing rapidly in the food service environment. As a result

of the COVID-19 crisis, your Coca-Cola Freestyle dispenser may require additional steps to begin normal

operation again. The following procedures provide additional guidance for your 9000 dispenser(s).

Should you need additional help or support, please contact Coca-Cola at 1-800-318-COKE (2653). We

appreciate your continued partnership and business!

Basic Cleaning

The following helpful parts for the basic cleaning protocols are available through Coca-Cola

Freestyle Small Parts Program. If you do not have the newest version of the nozzle and

injector ring brush part as shown below, previous versions of this part canbe used.

Basic cleaning protocols for re-open include:

•Clean and sanitize the ice bin and lid

•If an ice maker is installed, follow the specific manufacturer guidelines for cleaning of ice

maker

•Follow established cleaning procedures for ice chute and exterior surfaces. (refer to

the Freestyle 9000 User Guide if help is needed on this step)

Unclogging the Nozzle

•As a result of the extended down time and reduced dispenser usage, more extensive

procedures are recommended for the nozzle injector ring

and nozzle tip in order to clear clogs and ensure quality

beverages are pouring for guests.

oRemove the nozzle tip and soak it in warm water with food grade sanitizer

oWhile the nozzle tip is soaking:

▪Wet both ends of the angled nozzle brush in

hot water.

Classified - Confidential

▪Use both ends of the brush and clean the nozzle injector ring vigorously

at an angle. A stabbing motion can be used to remove clogs from the

holes. The blue ring in picture 1 below notes the location of holes. Picture

2 also shows the location of the nozzle injector ring holes for scrubbing.

▪Soak a clean microfiber cloth in hot water and hold it against the

nozzle injector ring for 10 seconds and squeeze water into the holes

▪Repeat these steps as often as necessary to loosen clogs

oRe-attach the nozzle tip

Classified - Confidential

Water and Carbonation Systems

The following internal and backroom components illustration may be helpful in identifying

equipment during this next section of procedures.

•IN THE BACK ROOM:

oTurn on water

oPlug in the water booster

oEnsure the C02 valve is turned on

•AT DISPENSER:

oIf the dispenser is powered off, the door will need to be opened manually to

access the power button:

▪Engage the manual door release at the lower left of the bottom door. A

screwdriver or other sturdy tool that fits in thehole can be used. Once

the bottom door is open, there is a manual door release at the bottom

left of the upper door. The power button is at the lower left just inside

the top door.

Classified - Confidential

o Turn on the C02 at the dispenser (see image below). The C02 lever should face

horizontal as shown.

oPlug in dispenser, if unplugged from the wall outlet

oPower on the dispenser with the green power switch

Ice and First Test Pour

•Check that the ice maker is working and re-set per manufacturing instructions, if

needed. If it was turned off, turn on ice maker or manually fill the ice bin with ice.

•Navigate to the consumer mode screen on the dispenser (as shown below)

•Pour enough still water to fill a 32-ounce cup 4 times (or a total of 128 ounces).

•Pour enough Dasani Sparkling water or sparkling water to fill a 32-ounce cup 4 times (or

a total of 128 ounces). This may require more than one pour.

Classified - Confidential

Ingredients

•Check HFCS (High Fructose Corn Syrup) enjoy by date. Replace if empty or past the enjoy

by date.

•Check NNS (Non-Nutritive Sweetener) enjoy by date. Replace if empty or past the enjoy

by date. Next, follow the procedures outlined below to ensure NNS is flowing smoothly

in your dispenser(s).

oAccess the Crew Dashboard

oOn the Crew Dashboard, select “Service Menu,” then select “Cartridge or

Package Replacement,” then select the “NNS” option.

o Next, enter the NNS code found on the NNS box

oSelect “OK” when the NNS Override prompt appears on the screen

Classified - Confidential

o Then, select the green “Auto Prime”option

oIn the event the “Auto Prime”function fails, you will see the screen image shown

below. Please follow the steps as listed. Additional help is available by calling

1- 800-318-COKE (2653).

•Check ingredient cartridge quantity and enjoy by date. PLEASE NOTE: Per theCustomer

Relief Package developed due to COVID-19, Coca-Cola is able to offer a ONE TIME

PRODUCT SHELF LIFE EXTENSION on applicable BIB & Freestyle products to minimize

out of date product and write offs. An ingredient cartridge can be used 15 days past the

enjoy by date printed on the cartridge. HFCS and NNS BIBs are not included in the 15-

day extension. Replace if necessary. Follow the prompts on the crew screen to prime the

ingredients replaced.

•Ingredients should not have been removed, but if

there are empty slots, please clean/sanitize the

probe (as shown in the image to the right), and

insert cartridges in the proper location by scanning

the RFID tag and allowing the dispenser to show

where to insert the cartridge (flashing light on the

correct cartridge slot).

Classified - Confidential

•You can access the crew dashboard three different ways, as outlined below.

•Holding the RFID tag on the ingredient cartridge in front of the reader (as shown above) will

also cause a red light to flash at the proper slot inside the dispenser (see image on the

right) If help is still required, call 1-800-318-COKE (2653)

•Pour enough still water to fill a 32-ounce cup 4 times (or a total of 128 ounces).

•Pour enough Dasani Sparkling water or sparkling water to fill a 32-ounce cup 4 times (or a

total of 128 ounces). This may require more than one pour.

•Do atest pour on beverages, being sure to include diet drinks.

NOTE: If any ingredients will not pour,verifythat

the cartridge is not empty by checking the

ingredient remaining information on the crew

screen(see image on the right). If it is not empty

and adrink still will not pour, it may be necessary to

repeat the nozzle injector ring steps as discussed in

the“Unclog the Nozzle” section.

Additional Cleaning Step

•Perform daily cleaning and sanitization of the nozzle ring and nozzle tip.

Taste Test

•Taste several beverages.

NOTE: Carbonation requires cold temperatures. If the ice maker was turned off or the

manual fill bin is empty, it may take a few hours before thedrinks taste like they have

enough carbonation.

Classified - Confidential

Assistance:

Should you need assistance completing any or all these tasks, please call the MyCokeTech support

line at 1-800-318 -COKE (2653) and ask to speak with a Senior Technical Advisor. Senior Technical

Advisors are available 24/7/365 and are ready to help!

Otros manuales para FREESTYLE 9000

Tabla de contenidos

Otros manuales de Dispensador de bebidas de Coca-Cola

Coca-Cola

Coca-Cola Post Mix System Manual de usuario

Coca-Cola

Coca-Cola Freestyle 7100 Manual de usuario

Coca-Cola

Coca-Cola Freestyle 7000 Manual de usuario

Coca-Cola

Coca-Cola Freestyle 7100 Manual de usuario

Coca-Cola

Coca-Cola Freestyle 9100 Manual de usuario

Coca-Cola

Coca-Cola Freestyle 9OOO Manual de usuario

Manuales populares de Dispensador de bebidas de otras marcas

PEGAS

PEGAS Evolution Manual de usuario

Ugolini

Ugolini MT micro Manual de usuario

Bunn

Bunn SLCA-7 Instrucciones de instalación

Gekkeikan

Gekkeikan Sake Machine Manual de usuario

Olympia

Olympia DH709 Manual de usuario

Marco

Marco ECOSMART PB10 Manual de usuario

Marvel

Marvel ML24BN Series Manual

Cecilware

Cecilware 2K-GB-LD Manual

Sure Vend

Sure Vend 673 Manual de usuario

Cornelius

Cornelius 2 Flavor Post-Mix Cold Coffee Dispenser Quest... Manual de usuario

Nostalgia Electrics

Nostalgia Electrics KEG7000SS Manual de usuario

Bunn

Bunn LCR-3 HV Guía de solución de problemas

Servend

Servend SV-200 Manual de usuario

EdgeStar

EdgeStar VBR440 Manual de usuario

Cornelius

Cornelius A.B.S. Unit Manual de usuario

CDS AUTOMATEN

CDS AUTOMATEN ML-16C2-C Manual de usuario

Siemens

Siemens GA 3000 Manual de instrucciones y seguridad

Cornelius

Cornelius FCB V4 Especificaciones