5
5.2.9 Do not use this fan heater in the immediate surroundings of a bath, a shower,
swimming pool or other environment where it may come into contact with water.
5.2.10 If the supply cord is damaged during use, discontinue use and have it
replaced by the manufacturer, local service agent or similarly qualified persons in
order to avoid a hazard.
5.2.11 Keep children and animals away from the appliance.
5.2.12 Do not place the appliance on moving vehicles or somewhere it can be
tipped over.
5.2.13 If the appliance is not used for an extended period, unplug the appliance.
Never remove the plug by pulling on the cord.
5.2.14 Keep the heater at a safe distance from curtains or other items that can
block the air inlet.
5.2.15 Never use the appliance with wet hands or operate the appliance when
there is water on the power cord.
5.2.16 Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities. Contact local government for information regarding
any disposal options. If electrical appliances are disposed of in landfills or dumps,
hazardous substances can leak into the groundwater.
5.2.17 This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they are supervised or given instruction concerning the correct
use of the appliance by a person responsible for their safety.
5.2.18 Do not allow children to play with the appliance.
6. Operating Instructions
6.1 Position the fan heater so that it stands upright on a firm level surface and at a
safe distance from wet environments, sources of water and any flammable
objects.
6.2 Connect the fan heater to the mains power supply.
6.3 Set the thermostat dial to the MAX setting and let the heater operate on full
power.
6.4 The fan heater will switch on when the heating selector dial is set to one of the
power settings. It will take up to 3 minutes for the heater to reach optimum
temperature.
6.5 Once the room reaches the required temperature, turn the thermostat dial
counter-clockwise until the thermostat clicks and the heating element switches off.
Leave the dial in this position to maintain the room temperature. Once the
temperature drops, the heating element will switch on again to maintain
temperature.
6.6 Before switching off the heater, please turn the thermostat dial to the MIN
position and turn the heat selector dial to the fan only position, let the appliance
cool down for two minutes then turn off the heater and pull out the plug.
6.7 On certain models there is an additional thermostat to control the fan motor. If
