Network Connection
5
MENU
IPC
Network Cable Network Cable
Switch
Router Computer
● Access the camera through IP-Tool
① Make sure that the camera and the PC are connected via LAN.
② Find the IP-Tool from the CD and then install it in the computer.
After that, run the IP-Tool as shown below.
Device Network Search
Immediate Refresh
name
name
name
IPC
IPC
IPC
unknown
unknown
unknown
192.168.2 26.201
192.168.1 .2
192.168.1 .3
80
80
80
9008
9008
9008
255.255.
255.255.
255.255.
Modify Netw ork Parameter
Mac Address
IP Address
Modify
CE :98 :23 :75 :35 :22
192 .168 . 226 . 201
255 . 255 . 255 . 0
192 .168 . 226 . 1
i
Tip: Enter the adm inistrator password, and
then modify the network parameters.
Total Device: 3
Local IP Address:192.168.1.4Subnet Mask:25 5.255.255.0 Gateway: 192.168.1.1 DNS：210.21.196.6
Device Name Device Type IP Address Http Port Data Port Subnet
Product Model
About
Subnet Mask
Gateway
Restore IPC Default Configuration
450043001517 A2
③
④ Secure the mounting base with camera to the wall with screws as
shown below.
Route and connect the cables.
Rotate 0°~350°
Pan 0°~360°
Tilt 0°~70°
⑤
the camera on a monitor and then adjust the camera according to
the figure below to get an optimum angle.
Three-axis adjustment. Before adjustment, preview the image of
⑥ Replace
sensor can be seen from the outside. If the light sensor is hidden,
please re-adjust the lens. After that, fix the lower dome with the
screws.
the lower dome to the camera and make sure the light
Transparent Dome Maintenance
Transparent dome is an optical element. As dirt, dust or fingerprints on the
dome will reduce the clarity of the image, please don’t touch or wipe the
cover surface directly during installation and use. Please refer to the
following cleaning tips to clean it.
*
* If there is water or grease on the dome, please gently wipe off the water
drop or grease with a soft cloth and then use oil-free cotton cloth with
neutral detergent to wipe it several times from the center outward.
Finally, change the cloth to dry it.
* If there are fingerprints on the dome, please use oil-free cotton cloth or
paper soaked with neutral detergent to wipe it several times from the
center outward and then dry it with a soft cloth.
If there is dust on the dome, please use a dry soft brush to gently brush it .
Tips
Light Sensor
③ Double click the camera information listed in the IP-Tool to
open the web browser.
The default IP address of this camera is 192.168.226.201.
Then follow directions to download and install the plugin if
prompted.
④ Activate and log in the camera. The default username is admin;
the default password is 123456 or you need to self-define the
password. Please operate according to the actual situation.
Here we take accessing IP camera via LAN for example.
