claber OASIS EVOLUTION 8054 Manual de usuario
CLABER OASIS EVOLUTION 8054
POSITION:
Oasis Evolution must be installed in closed environments, protected from atmospheric agents and poor
weather conditions. To prevent the water in the internal tank from overheating, position Oasis Evolution
in a shaded and cool area, away from windows or glass partitions and in any case, away from direct
sunlight.
Once the installation position has been selected, lift Oasis Evolution holding it at the bottom with both
hands and place it on a unit or a shelf, at a height of approximately 40 - 45 inches from the ground: the
unit or the shelf must be stable, level and be able to support the weight of Oasis Evolution when full of
water (approximately 60 lbs). Also, make sure that Oasis Evolution is at least 28 - 32 inches from the
edge of the tallest pot.
Position the plant pots on the floor in a semicircle near the unit where Oasis Evolution is positioned.
Remember to place a pot saucer below the plants to collect any excess water.
Plant the plastic stakes provided in the soil: each stake will correspond to a dripper(the maximum
number of drippers that can be used with Oasis Evolution is 20 and the minimum is 1. The hose can be
extended up to 65 feet). Generally speaking, for small and medium sized pots, one dripper is sufficient.
For larger pots, two drippers are recommended. If you change the number of drippers, the quantity of
water distributed by each dripper does not change; the number of days the system operates
autonomously changes.
NOTE: the drippers are not adjustable.
FITTING THE BATTERIES:
Remove the control panel as shown above. The Oasis Evolution needs two new AA alkaline 1.5V
batteries that have never been used, with an expiry date exceeding one year.
Act on the keys on the sides of the front panel until you hear it engage.
If present, remove the dead batteries. Connect the new batteries to the connector respecting the
polarity.
Lift up the front panel and reposition it.
For optimal operation, it is recommended that the batteries are replaced at least once a year. Before
using Oasis Evolution, check the battery charge by turning the dial to any program and checking the
display. If the display lights up, the batteries are charged; if the display remains off, the batteries are
dead and need replacing.
CONNECTION:
In order to ensure that Oasis Evolution operates correctly, the two lengths of hose leading from the tank
panel must be long enough to touch the floor before they are connected to the drippers in the first pots:
this simple precaution is necessary to make sure that watering starts correctly.
Unroll the hose laying it out in a ring. Make sure that it does not create a hazard or obstruct people or
animals. Once all the pots have been connected, bring the hose back to the second connector in the
front panel of Oasis Evolution (if necessary, cut off the excess hose using scissors).
Cut the distribution hose approximately ¾ - 1 inch from the stake.
Connect a dripper by pressing the hose firmly onto each end: make sure that the dripper outlet is facing
downwards. Use the same procedure for all the other stakes, until all the drippers required have been
fitted. You have now created the circuit which will distribute the water to the pots, complete with
drippers.
FILLING:
Check that the dial is set to OFF. Fill the tank with 6.6 gallons of clean water. Any liquid or granular
fertilizers are to be added directly to the soil in the pots. Do not, under any circumstances, put them into
the water in the tank.
Close the cover before activating Oasis Evolution.
SELECTING THE WATERING PROGRAM:
Oasis Evolution has 5 programs (4+OFF), specially designed to allow independent operation for 7, 14,
21 or 28 days automatically, which can be selected using the programming selector switch on the front.
The display switches on with the first click of the dial.
Always remember to press START to confirm your choice (including for OFF). If the chosen program is
not confirmed by pressing START, after a few seconds it returns to the program previously set.
NOTE: Oasis Evolution irrigates once a day only.
IMMEDIATE IRRIGATION START:
To select the required program, set the programming selector switch from OFF to the required position:
7, 14, 21 or 28 days and press START. Oasis Evolution is now in operation, automatically controlled by
the electronic timer.
Regardless of the water level in the tank, Oasis Evolution will deliver the same amount of water to your
pots each day (see table) throughout the programmed period, thanks to a special internal device which
automatically regulates the water pressure. As can be seen in the table, the time and water dispensing
change according to the program selected.
After the first start, subsequent irrigation cycles will run every 24 hours on the remaining days.
DELAYED IRRIGATION START:
To select the desired program, turn the dial from OFF to the desired position: 7, 14, 21 or 28 days, and
press START.
Press the START button again, as many times as the number of hours you wish to delay the start time
by. The maximum delay that can be set is 23 hours.
The amount of time remaining before the irrigation cycle will start is shown on the screen. Once the
cycle has started, the time remaining until the end of the cycle is shown.
At the end of the cycle, the time until the next irrigation cycle is shown.
TURNING OFF:
If Oasis Evolution is not used for a certain period of time, switch it to OFF mode by turning the dial on
the front panel and pressing START. When the device is in this mode, it will not dispense water.
Remember to reactivate programming the first time you use it again.
VENTING THE AIR FROM THE CIRCUIT:
Tabla de contenidos
Otros manuales de Equipos para césped y jardín de claber
claber
claber AQUAUNO PRATICO PLUS Manual de usuario
claber
claber 8487 Manual de usuario
claber
claber OASIS EVOLUTION Manual de usuario
claber
claber Rotoroll Manual de usuario
claber
claber IDRIS SPIKE Manual de usuario
claber
claber HYDRO-4 RF Manual de usuario
claber
claber 90832 Manual de usuario
claber
claber AQUAUNO VIDEO 8428 Manual de usuario
claber
claber Aquauno PRATICO Manual de usuario
claber
claber AQUAUNO SELECT Manual de usuario
claber
claber Aquauno Logica Plus Manual de usuario
claber
claber 8061 Manual de usuario
claber
claber Aquauno PRATICO Manual de usuario
claber
claber Colibri Series Manual de usuario
claber
claber TURBO-JET Manual de usuario
claber
claber Dual Select 8488 Manual de usuario
claber
claber 8900 Manual de usuario
claber
claber Rotoroll Especificaciones técnicas
claber
claber AQUAUNO LOGICA 8422 Manual de usuario
claber
claber 90831 Manual de usuario
Manuales populares de Equipos para césped y jardín de otras marcas
Vertex
Vertex 1/3 HP Especificaciones técnicas
GHE
GHE AeroFlo 80 Manual de usuario
Millcreek
Millcreek 406 Manual de usuario
Land Pride
Land Pride Post Hole Diggers HD25 Manual de usuario
extraspace
extraspace GardenStore Manual de usuario
Yazoo/Kees
Yazoo/Kees Z9 Commercial Collection System Z9A Manual de programación
