Cisco 1805 Manual de usuario
CHAPTER
9-1
Cisco 1805 DOCSIS Cable Router Hardware Installation Guide
OL-14661-01
9
Installing and Replacing CompactFlash Memory
Cards on Cisco 1805 DOCSIS Cable Router
This chapter describes installing and replacing CompactFlash memory cards in Cisco 1805 DOCSIS
cable router. You can perform these procedures when the router has been installed in its working location
with all power and interface cables connected. This chapter contains the following sections:
•Preventing Electrostatic Discharge Damage, page 9-1
•Replacing CompactFlash Memory Cards, page 9-1
Preventing Electrostatic Discharge Damage
CompactFlash memory cards are sensitive to electrostatic discharge (ESD) damage. ESD damage, which
can occur when electronic cards or components are handled improperly, results in intermittent or
complete failures.
To prevent ESD damage, follow these guidelines:
•Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
•Connect the equipment end of the strap to an unfinished chassis surface.
•Place a removed CompactFlash memory card on an antistatic surface or in a static shielding bag. If
the card will be returned to the factory, immediately place it in a static shielding bag.
•Avoid contact between the card and clothing. The wrist strap protects the card from ESD voltages
on the body only; ESD voltages on clothing can still cause damage.
•Do not remove the wrist strap until the installation is complete.
Caution For safety, periodically check the resistance value of the antistatic strap. The measurement should be
between 1 and 10 megohms (Mohms).
Replacing CompactFlash Memory Cards
This section describes how to remove and install CompactFlash memory cards.
9-2
Cisco 1805 DOCSIS Cable Router Hardware Installation Guide
OL-14661-01
Chapter 9 Installing and Replacing CompactFlash Memory Cards on Cisco 1805 DOCSIS Cable Router
Removing a CompactFlash Memory Card
To remove a CompactFlash memory card from an external slot, follow these steps:
Caution If the CF LED is on or blinking, do not remove the CompactFlash memory card. The router could crash,
or the flash memory contents could be corrupted.
Step 1 Press the ejector button next to the CompactFlash memory card. The ejector button moves outward so
that it projects from the panel.
Step 2 Press the ejector button again to unseat the card.
Step 3 Carefully pull the card out of the slot.
Step 4 Place the removed CompactFlash memory card on an antistatic surface or in a static shielding bag.
Step 5 Push the ejector button in until it clicks.
Caution To prevent damage to the ejector mechanism, the ejector button must remain fully seated when it is not
being used to eject a CompactFlash memory card.
Installing a CompactFlash Memory Card
To install a CompactFlash memory card, follow these steps:
Step 1 Make sure that the ejector button is fully seated so that it does not project from the panel.
Note If the ejector button projects from the panel, push it in until it clicks.
Step 2 With the label facing up, insert the connector end of the CompactFlash memory card into the slot until
the card is seated in the connector. The card is keyed so that it cannot be inserted incorrectly.
Note If the ejector button projects from the panel after you insert the CompactFlash memory card,
remove the card, press the ejector button until it clicks, and reinsert the card.
Caution To prevent damage to the ejector mechanism, the ejector button must remain fully seated when not being
used to eject a CompactFlash memory card.
9-3
Cisco 1805 DOCSIS Cable Router Hardware Installation Guide
OL-14661-01
Chapter 9 Installing and Replacing CompactFlash Memory Cards on Cisco 1805 DOCSIS Cable Router
Using the Compact Flash Guard
The Compact Flash guard (CF-guard) provides protection for the compact flash memory slot.
Note A small flat-head screwdriver is required to attach the CF-guard.
To install the CF-guard, follow these steps:
Step 1 Unpack the CF-guard.
Step 2 Slip the CF-guard flap into the notch in the CompactFlash memory slot.
Step 3 Screw the CF-guard into the screw hole.
158076
9-4
Cisco 1805 DOCSIS Cable Router Hardware Installation Guide
OL-14661-01
Chapter 9 Installing and Replacing CompactFlash Memory Cards on Cisco 1805 DOCSIS Cable Router
Otros manuales para 1805
3
Tabla de contenidos
Otros manuales de Enrutador de red de Cisco
Cisco
Cisco ASR 920-24SZ-IM Manual de instrucciones
Cisco
Cisco ASR 920 series Manual de usuario
Cisco
Cisco Linksys SFE2000 Manual de usuario
Cisco
Cisco CSR 1000v Series Manual de usuario
Cisco
Cisco Profile Series Manual de instrucciones
Cisco
Cisco XR 12000 Manual de usuario
Cisco
Cisco ASR 914 Manual de usuario
Cisco
Cisco 7600 Series Manual de usuario
Cisco
Cisco RV130 Manual de instrucciones
Cisco
Cisco 500 Series Manual de usuario
Cisco
Cisco 7206-VXR NPE-400 Manual de usuario
Cisco
Cisco RV042 - Small Business Dual WAN VPN Router Instrucciones de uso
Cisco
Cisco Catalyst 2928 Manual de usuario
Cisco
Cisco Cisco 12416 Manual del operador
Cisco
Cisco 7513 Series Manual de instrucciones
Cisco
Cisco ASR1004 - ASR 1004 Modular Expansion Base Manual de usuario
Cisco
Cisco Nexus 9000 Series Manual de usuario
Cisco
Cisco ASR 9000 Series Manual de usuario
Cisco
Cisco cBR Series Manual de usuario
Cisco
Cisco ASR 1004 Guía de instalación
