CiDRA SMARThatch Guía de inicio rápido

Contact Information:

Concrete Quality Measurement

Batch Plant to Job Site

smarthatchsupport@cidraconcrete.com

If you have any questions/concerns, please contact us:

Technical Support Line: +1.203.626.3430

or E-mail below

SMART Driver Notes:

hatch

Reset Water Add Meter, Rev Counters and Batch Timer:

• Every time the truck cycles power, the water add meter,

revolution counter and batch timer, will automatically reset

• Driver can reset these features at any time by pressing

menu button #1, then button #2

Resetting

Counters

Swapping Batteries:

• Battery in hatch lasts 7-8 days. Swap battery from cab

with sensor battery every Monday morning. Sensor

battery can be accessed via the (4) ¼ turn screws

• Insert new battery foam side first – then gently insert

female terminals into male terminals

In-cab charger Battery in sensor

Insert foam

side first

To Get Volume Reading:

Same 9 revolutions criteria as air and temperature applies

for establishing volume from 1- 5cy

• Park the truck on FLAT ground

• Drum must be turning SLOW enough (1-6 RPM)

• If this criteria is met and there is less than 5cy in the drum,

the volume will report on the In-Cab Display and on the Portal

• For small volumes approximately 2cy or less, turning the drum

slower 1-2 rpm may be needed to obtain a reading

Volume is on

page 2

Press either arrow for page 2

To Get Air Reading:

9 Revolutions at 5 rpm in the yard or at job site to get Air and Temp in < 2 min

Drive to job normally at 1-2 rpm. Will get updated info with each drum rev. Countdown

Display page 1

Otros manuales de Instrumento de medición de CiDRA

CiDRA

CiDRA SMART HATCH Manual de usuario

CiDRA

CiDRA AIRtrac Instrucciones de instalación

CiDRA

CiDRA CYCLONEtrac PST Manual de usuario

CiDRA

CiDRA Sonartrac GVF-100 Manual de instalación y operación

CiDRA

CiDRA CYCLONEtrac PST Manual de usuario

CiDRA

CiDRA SMARThatch Manual de operación y mantenimiento

CiDRA

CiDRA SONARtrac 20924 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario