Chuango G5 Manual de usuario
Printed in Hong Kong
PA: OI-G5/EN-Oct.2012-V1.0
GSM Alarm System
GSM Alarm System
FCC Statement
Features Control Panel Layout
2
1
ARM + Auror CPU
Support 10 remote controls, 50 wireless sensors
and 50 RFID tags
Built-in 1,000,000 RF codes combination
maintains high reliability
Cellular communicator, simple operation
Store 5 phone numbers, 1 speed-dial number,
and 1 RFID SMS notification number
Exit and entry delay
SMS alert for low battery of two-way accessories
Arm and disarm the system by SMS or free phone call
Remote monitoring site via phone
Built-in loud speaker for siren and two-way talking
Built-in two pieces of 800mAh lithium batteries
enable 5-hour standby
SMS alerts for power failure, power recovery
and low battery
850/1900MHz GSM frequency,
applicable for universal
GSM Signal Indicator
GSM network searching: Flashes once every second
GSM signal in normal: Flashes once every two seconds
Touch Keypad
Status Indicator
RFID Reader / Play Voice Memo
Stay Arm (Home Mode)
Disarm
Arm
Call
Record Voice Memo /
Connect Button
Bottom
4
3
Arm
Home mode
Disarm on keypad:
Disarm by RFID tag:
Press to arm the system.
Press to arm the sytem in home mode.
All the sensors in Normal Zone are armed except those in
Home Mode Zone which are disarmed so that user can move
freely at home.
Input 4 digits password (default:1234) , and press to disarm
the system after one beep.
If three beeps are heard, password is wrong and
please input again.
Induce the RFID tag to the RFID Reader area to
disarm the system.
MIC
Buzzer
Back-up Batteries
Loudspeaker Tamper Switch
Record / Play Voice Memo
Press to record 10 seconds voice messages.
Or send SMS to system for calling back to record the
voice messages. The Play Voice Memo Button will be
flashing in purple to remind you. Users can touch the
center of circle to listen to the voice memo. The LED
indicator blacks out when the voice memo is played.
Replay by touching it again.
6
5
Bottom
SIM Card Slot
Power On/Off
Input for Wired Sensors
(24-hour zone)
Output for
Electronic Lock
Adapter Interface
Output for Wired Siren
≤ 500mA
Input for Wired Sensors
(normal zone)
8
7
Speed Dial
Phone Call
Electronic Lock Output
Press Call Button , the panel auto dials to pre-stored
phone number of the host, the LED blacks out after talk.
User can also press Call Button to end talk.
Dial phone number and then press Call Button to
start talk, the LED blacks out after talk.
User can also press Call Button to end talk.
When system is disarmed, the output signal opens
electronic lock automatically.
SMS Operation
?
Insert a SIM card to the control panel,
then send a text of to the SIM card number,
the operation guide message will be replied.
You can control the alarm system by
following the guide message:
“?”
System replies first grade guide menu:
‘0’ Disarm
‘1’ Arm
‘2’ Home mode
‘3’ Two-way talk
‘4’ Call-back voice memo
‘00’ Settings inquiry
‘??’ Store phone and SMS No.
Send:
10
9
???
System replies third grade guide menu:
‘91~99’ Zone name
‘10’ RFID tags SMS notice
‘11’ Entry and exit delay time
‘12’ Siren volume and ringing time
‘13’ Disarm password
‘14’ Single zone delay time
Send:
??
‘5’ Store alarm phone No.
‘6’ Store alarm SMS No.
‘7’ Store SMS No. for RFID tags
‘8’ Store speed dial phone No.
‘???’ System setups
System replies second grade guide menu:
Send:
0
Disarm
Send:
System disarmed.
Arm
Stay Arm (Home Mode)
12
11
2
Send:
System in home mode.
1
Send:
System armed.
4
3
Two-Way Talk
Send to the SIM card number, the alarm will call back.
Pick up the phone and start two-way talk.
‘3’
Call-Back to Record Voice Memo
Send to the SIM card number, the alarm will call back.
Pick up the phone, and leave 10 seconds message.
The panel will hang up after 10 seconds.
‘4’
Send:
Send:
Settings Inquiry
14
13
00
System status
Entry and exit delay time: 0sec
Single zone delay time: 30sec
Siren volume: 2
Siren ringing time: 5min
Disarm password: 1234
Send:
Note:
Value of default setting will be changed
once users finish programming.
5
Send:
Store Alarm Phone No.
TEL:
1.
2.
3.
4.
5.
TEL:
1. 67890033
2. 67890022
3. 67890011
4. 67890000
5.
Forward > Edit
Store alarm phone No.
successfully.
Store Alarm SMS No.
16
15
6
Send:
SMS:
1.
2.
3.
4.
5.
SMS:
1. 67890033
2. 67890022
3. 67890011
4. 67890000
5.
Forward > Edit
Store alarm SMS No.
successfully.
Note:
Only after SMS No. is stored, and the
RFID tags SMS notice is changed, users
can receive notice SMS once someone
disarms the system by RFID tag.
7
Store SMS No. for RFID tags
Send:
Forward > Edit
Store SMS No. for RFID
tags successfully.
SMS No. for RFID tags
(0-20 digits):
1.
SMS No. for RFID tags
(0-20 digits):
1. 67890033
Note: Only after SMS No. is stored, and the RFID tags
SMS notice is changed, users can receive notice SMS
once someone disarms the system by RFID tag.
Otros manuales para G5
4
Este manual sirve para los siguientes modelos
1
Otros manuales de Sistema de seguridad de Chuango
Chuango
Chuango WS-105 Manual de usuario
Chuango
Chuango WS-280 Manual de usuario
Chuango
Chuango B11 Manual de usuario
Chuango
Chuango G5 Manual de usuario
Chuango
Chuango H4 PLUS Manual de usuario
Chuango
Chuango AWV Plus Manual de usuario
Chuango
Chuango A11 Manual de usuario
Chuango
Chuango OV6 Manual de usuario
Chuango
Chuango SPS-260 Manual de usuario
Chuango
Chuango AW1 Plus Manual de usuario
Chuango
Chuango G5 Manual de usuario
Chuango
Chuango O2 Manual de usuario
Chuango
Chuango LTE-400 Manual de usuario
Chuango
Chuango G5 Manual de usuario
Chuango
Chuango CG-A11 Manual de usuario
Chuango
Chuango A9 Manual de usuario
Chuango
Chuango G5 Manual de usuario
Chuango
Chuango CG-B11 Manual de usuario
Chuango
Chuango OV-300 Manual de usuario
Manuales populares de Sistema de seguridad de otras marcas
EDM
EDM Solution 6+6 Wireless-AE Manual de usuario
Highway Safety Group
Highway Safety Group EA401 Manual de usuario
Siren
Siren LED GSM Manual de usuario
Detection Systems
Detection Systems 7090i Instrucciones de montaje
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Manual de usuario
Siemens
Siemens FDM273 Manual de usuario