The controller then automatically activates the chemical feeders for sanitizer and acid (or
soda) feed, as required to maintain the set ORP and pH levels - regardless of fluctuations
in bather load, contamination and weather. Like a thermostat maintaining a constant
temperature, it prevents overfeeding or underfeeding, both of which are detrimental to
good water quality.
ALARMS
When there is an alarm condition, the corresponding display flashes the alarm value:
●ORP out-of-range,
●pH out-of-range,
●ORP overfeed,
●pH overfeed.
The display stops flashing when the condition is corrected. To reset the overfeed timers,
turn the feed mode to off and then back to Manual or Auto.
RESET
The ideal values are set as default values. They can be adjusted by the operator at any
time. To reset all factory default values, press ORP and pH for 5 seconds.
SPECIFICATIONS
ORP CONTROL Adjustable from 400 to 900 mV
pH CONTROL Adjustable from 4.0 to 10.0
ORP SENSOR Platinum electrode with 10-ft (3 m) cable
pH SENSOR Glass electrode with 10-ft (3 m) cable
READOUTS ORP (3 digits) and pH (2 digits) LEDs
FEED MODES Manual, automatic, proportional
ADJUSTMENTS Setpoint, calibration, limits, feed rate
INDICATORS LEDs for feed mode, feed status, alarms
SAFETY Audio, visual and remote alarms
Out-of-range limits and overfeed safety timers
CABINET Polystyrene 9x7x4 in. (22x18x10 cm)
ELECTRICAL 110V, 230V or 24 VAC (specify)
PLUMBING PVC tees for 1-1/2" or 2" line
WARRANTY 5 years on electronic module
1 year on all other parts
SHIPPING 12x12x12-in (30x30x30 cm) carton
8 lbs (3 kg) without pumps
16 lbs (6 kg) with 2 chemical feed pumps
BROCHURE FOR PRINTING
