CheckVideo CV136 Manual

Things You Need for Installaon

Step Two Connect Camera to Router

CheckVideo High Denion Outdoor Bullet Camera

Installaon Quick Reference

Step Three Create/Access Your Account

1. Go to the CheckVideo Dashboard login page:

portal.checkvideo.net

Click the Start here link to create your account.

If you have an exisng account, log in and skip to the next

secon to register your CheckVideo devices.

2. Complete the User Informaon secon.

3. In the Dene Nocaon Methods secon, for Contact

Informaon enter the email addresses that may receive event

nocaons. For MMS nocaons to mobile phones, the

address format will vary by carrier (ex: mobile number@

mms.a.net). Check your carrier’s website for more

informaon.

Fig. 1a- Connecon path using a PoE injector as the mid span

Router

HD Camera

1. For later reference, enter the device’s serial number. This

number, “the MAC”, is found on the underside of the

camera:

2. Before installing the camera in its nal locaon, connect

the router to “Data In” on the PoE injector and connect the

injector’s “Data & Power Out” port to the Camera using

Cat-5 network cables. Note: Runs can be no longer than 100

meters. Connect the PoE injector to a power outlet.

3. If you intend to take advantage of the camera’s onboard

heater, the camera must be powered using a 12VDC/24VAC

power supply. Aach the camera’s “Power” connector

to the power cable adapter using the oponal Phoenix

connector and plug in a power supply to the female barrel

connector. When using a separate power supply, the PoE

injector is no longer necessary. Instead use a Cat-5 network

cable to connect the camera’s network jack to the router.

Included in the box:

• CheckVideo® HD Outdoor Bullet Camera

• Bag of mounng parts: screws (5), drywall

mounts (5), hex wrench, 2 Phoenix connectors

• 32GB MicroSD card, pre-inserted

• Power Over Ethernet (PoE) injector

• Power cable adapter (female connector)

You’ll also need:

• PC or Mac® with Broadband Internet Service

• Router, connected to the Internet

• Phillips screwdriver

• Cat-5 network cables

• 12VDC/24VAC, 2A camera power supply, not

provided

4. Choose a maximum Video Resoluon for each email address. If

you intend to use MMS to send video to a mobile phone, do not

select a resoluon higher than 480p. For 720p or 1080p, send the

nocaons as an aached video clip to a tradional email address

(ex: [email protected]). Use the Test buon to conrm that the video

resoluon is valid for your device/carrier.

5. In the Billing Preferences, choose your Service opon. If you choose

Central Service, complete the form and CheckVideo Support will contact

you directly.

6. (Professional Service only) Specify method of payment, authorize service

fees, and accept the License Agreement.

If this CheckVideo device will be monitored

by a central staon, please contact the central

staon for a username and password on their

exisng CheckVideo account. The central

staon will add the device to their account.

If this device will be self-monitored, you will

be creang a CheckVideo account in Step Two.

PoE Injector

4. If the connecons have been made correctly, the network jack

on the camera will light green and yellow. This will be your sign

to connue.

Fig. 1b - Camera cables

A: Power

B: Video out

C: Network jack

D: Power Cable Adapter

E: Phoenix Connector

To power

supply

Step One Adjust Focus and Zoom

1. The CheckVideo High Denion Outdoor Bullet camera

(CV136) contains a manual var-focal lens set to 3mm at the

factory.

2. To adjust the lens sengs:

• Remove the sunshield, reserving the screws.

• Loosen the screw on the boom of the camera just above the

product scker.

• Gently twist the lens cover unl it comes apart from the camera.

• The lens has two adjustments: Focus (A) and Zoom (B)

• Connect a video monitor to the BNC connector on the camera

before contribung.

• Loosen the Zoom adjustment lever (B) and move the lever

clockwise/counterclockwise unl you have reached the desired

posion. Tighten the lever with a screwdriver.

• Loosen the Focus

adjustment lever (A) and

move the lever clockwise/

counterclockwise unl the

lens is focused. Tighten the

lever with a screwdriver.

• If you remove the lens cover

in the future, you should

replace the desiccant inside

the unit. A spare desiccent

pack can be found inside the

camera’s packaging.

• Replace the lens cover and

sunshield.

For more detailed informaon, refer to the CheckVideo HD Outdoor Bullet

Camera Installaon Guide available at www.checkvideo.com.

Step Five Install Camera

Step Six Conguraon

Fig. 6 - A zone, dened by eight end points

(rst point is green; other points are blue)

Fig. 7 - A completed zone

1. On the CheckVideo Dashboard, click on Devices >

Congure Device.

2. Select Device: Select the device and video resoluons

for event clips and DVR. CheckVideo will default both

resoluons to 240p. You may wish to start with these

sengs. Your chosen resoluon sengs will depend

upon the upload capacity of your Internet provider.

3. Congure Events: Click the Edit buon to create a

zone for a parcular object type. Then use your mouse

to draw the zone by clicking the le mouse buon

wherever you want to dene a point of the zone. The

zone should cover the enre area where you want to

detect an event. Enter a me span, event type, zone,

and duraon and click Add Event buon.

4. Select Nocaon Method - Central Staons: Select a

Central Staon type that should receive alert metadata.

5. Select Nocaon Method - Users: Click the checkbox

next to any user(s) who should receive nocaons for

this camera and their method of nocaon.

6. Click Save.

7CVCBQC000E-06.01

Fig. 3 - MORE EFFECTIVE: Cameras

are at a 15 to 45 degree downward

lt and are mounted 8 to 20 feet high

Fig. 4 - LESS EFFECTIVE: Cameras are

directly overhead (90 degrees) or parallel

to (0 degrees) the target

To opmize event detecon, place your CheckVideo HD Camera as

follows:

• HEIGHT: Each camera must be installed 8 to 20 feet o the

ground.

• DISTANCE: If you are mainly detecng people at a 3mm focal

length, the distance between the camera and the people you

wish to detect should be 15 to 50 feet. If you are primarily

concerned with detecng vehicles, the range is 40 to 150

feet.

The CheckVideo Camera Placement Guide includes a summary

checklist on improving your camera placement.

Fig. 5 - Rotate Image buon

Fig. 2 - Add Device: Enter device serial number

1. If camera will be monitored by a central staon,

contact them to add the device to their account.

2. If self-monitored:

• On the CheckVideo Dashboard, click on Devices >

Add Device.

• In the Register Device secon, enter the serial

number found on the underside of the camera

and a Device Name.

Step Four Add CheckVideo HD Camera

The Camera can be placed on a ceiling, wall or shelf. Once you’ve

determined where to place the Camera, run Cat-5 network cable from

the router to the desired locaon. Adjust the camera angle seeking to

maintain a 15 to 45 degree downward lt.

Power the camera (refer to Step 2 for addional informaon)

• Click the Test Device

buon to make sure the

CheckVideo Soware Service

(CVSS) can communicate

with the device.

• (Professional Service only)

Authorize service fees.

• If prompted, update the

device rmware.

Make sure your browser is set to 100% when drawing

your zone.

Otros manuales de Cámara de seguridad de CheckVideo

CheckVideo

CheckVideo CV154 Manual

CheckVideo

CheckVideo CV167 Manual

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario