Series ATP Reciprocating Drive - Single or Dual Head
With External Adjustable Stroke Length
CP-MAN-PRD-021 REV01 EFF. DATE 3/31/2023 Page 5 of 13
WARNING - DO NOT OPEN, MAINTAIN, OR SERVICE IN AN AREA
WHERE AN EXPLOSIVE ATMOSPHERE MAY BE PRESENT
WARNING – THE CLEANING OF THE EQUIPMENT SHALL BE DONE
ONLY WITH A DAMP CLOTH
REFER TO MANUAL FOR CONDITIONS OF SAFE USE
2. SPECIAL CONDITIONS OF SAFE USE:
i. The maximum surface temperature rise has been assigned as T3 (200°C). Any flammable
substances with an auto-ignition temperature of less than 200°C must not be used when the equipment is
energized.
ii. It is the responsibility of the end-user that the intended site of operation has been correctly
classified in accordance with the ATEX Directive and that the equipment placed into service is compatible
with that classification.
iii. It is the responsibility of the end-user to ensure that an appropriate inspection and maintenance
schedule is established to ensure effective operation.
iv. Only competent, trained operators should use the equipment.
v. The replaceable components must be identical and meet the same specifications as the replaced
ones as per the OEM’s recommendation. All the replacement activities shall take place only when the
equipment is de-energized AND the area is known to be NON-HAZARDOUS AREA.
3. SYSTEM REQUIREMENTS
3.1 Inspection
Before installation, please inspect the pump carefully. If the pump appears to have sustained damage in
transit, call your CheckPoint Authorized Distributor or CheckPoint Customer Service directly at +1 (504) 340-
0770 to report and confirm damage. If it is determined that damage occurred in transit, a carrier claim will be
required.
3.2 Storage
The ATP pump has been thoroughly tested at the CheckPoint factory prior to shipment. This testing may
leave residual fluids in the pump head. Although our pumps can be placed in service without environmental
protection, we suggest that they are stored indoors until being commissioned.
