Check-line DLM 107A Manual de usuario

CHECK-LINE

O  

E  E  

OMATIC Equip’t Co., Inc

600 Oakland Ave. Cedarhurst, NY 11516

TEL (516) 295-4300 - FAX (516) 295-4399

www.checkline.com

Digital Length Meter

Model DLM 107A

Model DLM 107AH

Operating Instructions

The Model DLM-107A and DLM-107AH Digital Length

Meters are designed to accurately measure fabric length (or

other moving belt material), in feet or meters. The operator

controls the start and end of the measuring interval by

pressing the Measure Button. The Following procedure

should be followed:

1. The meter is supplied with 2 AA batteries installed in

the housing. To replace batteries, it will be necessary

to remove the extension handle by removing the two

flat head screws. (Important: Save these 4mm screws

for reassembling the handle to the instrument.) Be sure

to follow the polarity markings on the battery cartridge

when installing new batteries. (NOTE: If unit is to be

operated without the handle extension, disconnect the

remote switch by opening the in-line receptacle and

jack within the handle itself, attach the battery car-

tridge end plate to the housing and tape the remote

switch wire to the housing, covering the exposed

receptacle end.) With the handle extension removed,

the momentary power button on the side of the housing

must be held in during the measuring period.

2. Affix the measuring wheel to the instrument shaft,

being sure that the shaft cross pin engages the slot of

the wheel hub. TIGHTEN THE HUB SET SCREW. With

the handle held firmly, using one or two hands, bring the

wheel edge to the moving surface belt or fabric, supply-

ing a light to moderate amount of pressure, only

enough to assure good contact. There should be no

indication in the LED readout.

3. To start measurement on DLM-107A or DLM-107AH

models, press and release the red push button on the

handle. An increasing reading in feet will appear in the

window. To end the measurement, press the button

again and release it.* The reading will be displayed for

approximately 10 seconds and then disappear. To recall

the measurement after the reading has disappeared,

press the Memory Recall button on the face of the

instrument. To clear memory push and hold memory

button for 5 seconds.

Even though the measuring wheel continues to rotate after

the switch is turned off or the wheel is lifted from the

surface, the last reading will be held in memory. Measure-

ment is made only during the period when the power is on.

Reactivating the power switch erases the previous reading.

NOTE: a flashing display indicates battery low voltage.

Replace batteries as indicated in 1., above. To conserve

battery power, do not leave handle switch in the down or

“on” position, except during the measuring period.

Operating Instructions

Este manual sirve para los siguientes modelos

Otros manuales de Instrumento de medición de Check-line

Check-line

Check-line DXN Manual de usuario

Check-line

Check-line AD-100 Manual de usuario

Check-line

Check-line DCF-900 Manual de usuario

Check-line

Check-line TI-007DLX Manual de usuario

Check-line

Check-line DX2/DXX Manual de usuario

Check-line

Check-line TI-25SX Manual de usuario

Check-line

Check-line DTMX-200 Manual de usuario

Check-line

Check-line ETB Manual de usuario

Check-line

Check-line TI-25DLX Manual de usuario

Check-line

Check-line SLW Manual de usuario

Check-line

Check-line TI-007 Manual de usuario

Check-line

Check-line DTS-200 Manual de usuario

Check-line

Check-line YSL-2000HD Manual de usuario

Check-line

Check-line BTM-400PLUS Manual de usuario

Check-line

Check-line MINI-MAX Manual de usuario

Check-line

Check-line TI-25DL Manual de usuario

Check-line

Check-line BP1 Manual de usuario

Check-line

Check-line DLM-107A Manual de usuario

Check-line

Check-line TMT-425 Manual de uso y cuidado

Check-line

Check-line TI-CMXDL Manual de usuario

Check-line

Check-line humimeter RH5.1 Manual de usuario

Check-line

Check-line CTM2 Manual de usuario

Check-line

Check-line TI-25MX Manual de usuario

Check-line

Check-line DT-735 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario