Chattanooga 70005 Manual de usuario

Neo Laser

Module Manual

Installation

Instructions

DJO, LLC

A DJO Global Company

1430 Decision Street

Vista, CA 92081-8553

T: 1-800-592-7329 USA

T: 1-760-727-1280

F: 1-760-734-5608

DJOGlobal.com

Neo Laser Module Manual

13-8907 Rev E

For complete User Operating Instructions,

including Cautions, Warnings, Dangers,

Indications, and Contraindications, refer to the

User’s Manuals.

• Domestic Market, US only, refer toVectra Neo

Clinical Therapy System User Manual, Item

#13-7646 (CDVersion, item #13-7647).

• International Market, refer to Intelect Neo

Clinical Therapy System User Manual, Item

#13-7651 (CDVersion, item #13-7652).

• To obtain a copy, contact your local

representative or DJO Customer Care.

0086

Neo Laser Module Manual

Install module from the left side (when facing the screen)

of the unit.

Items included in this module:

Laser Module – PN 70005

• Lasermodule

• ProtectiveEyewear,2Pair

• LaserInterlock

• PatientRemote,LaserInterruptSwitch

• Faceplates(tocovermoduleafterinserted)

Tools required (not included):

• #2Phillipsscrewdriver

• Standardslottedscrewdriver.

TheSystemisprogrammedtoautomaticallyrecognize

thenewModule,therefore,nosoftwareinstallationis

required.

Completethefollowingstepstoinstallthemodule:

1. Poweroffdevice.Removethepowercordfromthe

rearofthedevice.

2. Removetheblankfaceplateoverthefourthslotfrom

the front on the left and right sides of the unit. Insert

astraight-slotscrewdriverinthetopslot,pressing

downwithslightpressure.Pullthefaceplateaway.

3. Thefourthslotisillustratedbelow,butthetechnique

is the same for all modules.

4. Themodulemustbeinsertedontheleftsideinthe

fourthslotasshown.Insertthemoduleintotheslot,

with32pins(2x16)infirst.

5. Setthemoduleinplacewithgentlepressureuntilyou

feelanendpointoftravel.

MODULE INSTALLATION

Neo Laser Module Manual

MODULE INSTALLATION (CON’T)

Cable Insertion

ShownbelowistheCableInsertionlocation

ForcompleteUserOperatingInstructions,including

Cautions,Warnings,Dangers,Indications,and

Contraindications,refertotheUser’sManuals.

• DomesticMarket,USonly,refertoVectraNeoClinical

TherapySystemUserManual,item#13-7646(CD

Version,item#13-7647).

• InternationalMarket,refertoIntelectNeoClinical

TherapySystemUserManual,Item#13-7651(CD

Version,item#13-7652).

• Toobtainacopy,contactyourlocalrepresentativeor

DJOCustomerCare.

6. Usinga#2Phillipsscrewdriver,securethemodule

withtheprovided8-32x5/16”screwatthebottom

tab,asshown.

7. InserttheFaceplatewithconnectionopenings,

suppliedwiththemodule,ontheLeftandRightsides,

atthebottomandsnapintoplaceatthetopasshown.

8. Plugintheunitandpressthepowerbutton,allow

theunittoinitializeandthenverifythatthenewly

installedmoduleisshownasavailableontheHome

screen.

Neo Laser Module Manual

LASER SPECIFICATIONS

Power

Electrical Type.................................................TYPE B

Output Type ..................................... Infrared Lamp (Laser)

Laser Class....................................................... 3B

Laser Technical Specications

Pulse Frequencies........................ 8 Hz - 10000 Hz and continuous

Wavelengths......................670-950 nm (dependent on applicator)

Output......................... 100-1440 mW (dependent on applicator)

Output accuracy ................................... +/- 20% of nominal

Description of Device Markings

RefertotheDomesticandInternationalUser’sManualsfor

detailedinformationontheDeviceMarkings.

Laser Applicator Specications

ForallsinglediodeandclusterlaserandLEDapplicators,

theexpectedincreaseinthemeasuredquantitiesafter

manufacturecombinedwiththevaluesmeasuredatthe

timeofmanufactureis±20%.

Thesoftwareincorporatesacoolingfunctionthatforces

theusertocoolthelaserclusterspriortothenext

treatmentwhentreatmenttimesexceed3minutesper

application.Thesoftwarewillcalculatethecoolingtime

needed as follows:

• Fora3minutetreatment,itwillforcea15secondcool

downperiod

• Fora4minutetreatment,itwillforcea2minutecool

downperiod

• Thesoftwareextrapolatesfortimesbetween3and4

minutes

Note:Amessagewilldisplayfor5secondsonthescreen

informingtheuserthattheprobeiscoolingdownandthe

timeperiodrequired.Iftheuserattemptstousetheprobe

beforethecooldownperiodiscompleted,themessage

re-displays.Whencooldowniscomplete,amessage

displaystheunitisreadyforuse.

• Read, understand, and practice the precautionary and operating instructions.

Know the limitations and hazards associated with using any electrical

stimulation, laser device or ultrasound device. Observe the precautionary and

operational decals placed on the unit.

• Device is designed to comply with electromagnetic safety standards. This

equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with instructions, may cause harmful

interference to other devices in the vicinity. However, there is no guarantee that

interference will not occur in a particular installation. Harmful interference to

other devices can be determined by turning this equipment on and off.Try to

correct the interference using one or more of the following:

- Reorient or relocate the receiving device

- Increase the separation between the equipment

- Connect the equipment to an outlet on a different circuit from that to

which the other device(s) are connected and consult the factory field

service technician for help.

- Consult your authorized DJO dealer for help.

• Do not operate this unit when connected to any unit other than DJO devices or

accessories specifically described in user or service manuals.

• DO NOT disassemble, modify, or remodel the unit or accessories. This may cause

unit damage, malfunction, electrical shock, fire, or personal injury.

• Failure to use and maintain the Intelect® Neo System, its modules, and its

accessories in accordance with the instructions outlined in this manual will

invalidate the warranty.

• Use of parts or materials other than DJO’s can degrade minimum safety.

• The Intelect® Neo ClinicalTherapy System is not designed to prevent the ingress

of water or liquids. Ingress of water or liquids could cause malfunction of internal

components of the system and therefore create a risk of injury to the patient.

DANGER

CAUTION

Neo Laser Module Manual

• Read, understand, and practice the precautionary and operating instructions.

Know the limitations and hazards associated with using any electrical

stimulation, laser device or ultrasound device. Observe the precautionary and

operational decals placed on the unit.

• Device is designed to comply with electromagnetic safety standards. This

equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with instructions, may cause harmful

interference to other devices in the vicinity. However, there is no guarantee that

interference will not occur in a particular installation. Harmful interference to

other devices can be determined by turning this equipment on and off.Try to

correct the interference using one or more of the following:

- Reorient or relocate the receiving device

- Increase the separation between the equipment

- Connect the equipment to an outlet on a different circuit from that to

which the other device(s) are connected and consult the factory field

service technician for help.

- Consult your authorized DJO dealer for help.

• Do not operate this unit when connected to any unit other than DJO devices or

accessories specifically described in user or service manuals.

• DO NOT disassemble, modify, or remodel the unit or accessories. This may cause

unit damage, malfunction, electrical shock, fire, or personal injury.

• Failure to use and maintain the Intelect® Neo System, its modules, and its

accessories in accordance with the instructions outlined in this manual will

invalidate the warranty.

• Use of parts or materials other than DJO’s can degrade minimum safety.

• The Intelect® Neo ClinicalTherapy System is not designed to prevent the ingress

of water or liquids. Ingress of water or liquids could cause malfunction of internal

components of the system and therefore create a risk of injury to the patient.

DANGERWARNING

• Handle, clean and dispose of components and accessories that have

come in contact with bodily fluids according to National, Local and

Facility rules, regulations and procedures.

• This unit is considered to be a Class 3B Laser product and thus emits

visible and invisible Laser radiation (IR). Avoid direct eye exposure to

the Laser beam. The symbol to the left is located on the back of the

applicator and indicates the active radiant surface (the area on the

applicator that emits infrared Laser energy and the direction of the

beam of light).When the unit is on, not all wavelengths are visible

to the naked eye.Therefore, when performing any operational or

functional check, always wear Chattanooga laser protective

eyewear.

• DO NOT connect the unit to an electrical supply without first

verifying that the power supply is the correct voltage. Incorrect

voltage may cause unit damage, malfunction, electrical shock, fire,

or personal injury. Your unit was constructed to operate only on the

electrical voltage specified on the Voltage Rating and Serial Number

Plate. Contact your DJO dealer if the unit is not properly rated.

• Laser protective eyewear should be worn during laser treatment by

the operator and patient to block infrared light energy from the

eyes during treatment.

• DO NOT point the Laser beam directly into human or animal eyes.

The lens of the eye does not detect the invisible, coherent Laser

beams, potentially resulting in permanent retinal damage.

• Thisdeviceshouldbeusedonlyunderthecontinuedsupervisionofa

physician or licensed practitioner.

• Makecertaintheunitiselectricallygroundedbyconnectingonlyto

a grounded electrical service receptacle conforming to the applicable

national and local electrical codes.

• Thisdeviceshouldbekeptoutofthereachofchildren.

• UseofaccessoriesotherthanthosespecifiedinthisUserManualmay

increase electrical emissions and decrease electrical immunity of the

device.

• DONOToperatethisunitinanenvironmentwhereotherdevicesarebeing

used that intentionally radiate electromagnetic energy in an unshielded

manner.

• Cleanapplicatorsaftereachuse,otherwiseitcanleadtocross

contamination and infection.

• Intheeventofall300-Levelora200-Levelerrormessagethatcannotbe

resolved, immediately stop all use of the system, and contact the dealer

or DJO for service. Errors andWarnings in these categories indicate an

internal problem with the system that must be tested by DJO or a Trained

Technician before any further operation or use of the system.

• UseofasystemthatindicatesanErrororWarninginthesecategoriesmay

pose a risk of injury to the patient, user, or extensive internal damage to

the system.

• Useofcontrolsoradjustmentsorperformanceofproceduresotherthan

those specified herein may result in hazardous exposure to ultrasonic

energy.

• Disconnectthesystemfromthepowersourcebeforeattemptingany

maintenance, installation, removal or replacement procedures to prevent

electrical shock and possible damage to system.

Tabla de contenidos

Otros manuales de Unidad de control de Chattanooga

Chattanooga

Chattanooga Intelect Advanced Series Manual de usuario

Chattanooga

Chattanooga Intelect Advanced 2766 Manual de usuario

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario