CHANCEE U190CAR Manual de usuario
U190CAR Floor Sweeper
Instruction Manual
We explore safer, higher-end and more user-friendly cleaning equipment
through technical advantage and idea innovation.
Preface
This instruction manual contains all the information that you need to use and
maintain the machine. Please read it carefully before getting started. Only with
correct operation and regular maintenance can the machine be kept in its best
working condition.
This instruction manual is an important part of the product and should be kept
together with the machine.
If this manual is lost, please contact us immediately and we will be glad to provide
you with a new one. All technical details included in this manual are property of
Anhui Chancee Technology Co., Ltd and are protected by law.
Some components of the product may be harmful or dangerous and we have tried
our best to include them in this manual. It is the user’s obligation to pay special
attention to them during the work. However, since it is impossible for us to point out
all potential dangers, we expect you to be extremely cautious during the work so as
to protect the machine, yourself and other people in the working area
In this manual we use illustrations to show the components and functions of the
machine. It is possible that some of them contain details that are slightly different
from those of yours. However, all the instructions presented here still apply to
your product and should be followed strictly during the operation.
.
Only accessories from the original manufacturer can be used on the machine. Using
accessories from other sources may lead to low working efficiency or even accidents
in extreme cases.
We usually modify or improve our products to meet the latest market demand.
However, this is NOT suitable for machines that have been sold. We will NOT be
responsible for any injury or loss caused due to the user’s improper operation either.
If you have any question, complaint or suggestion, please feel free to contact us and
we will be at your service with all our knowledge and enthusiasm.
We wish you a pleasant experience with our product!
Technical parameters
1
Chapter 1 General description
2/3
1.1 Contents and purposes
1.2 General instructions
1.3 Safety requirements for the batteries
1.4 General safety requirements
Chapter 2 Operating the machine
4/7
2.1 Buttons and pedals of the machine
2.2 Operation process of the machine
2.3 Cautions during the operation
Chapter 3 Regular inspection and replacement of damaged parts
8/10
3.1 Adjustment and replacement of the main brush
3.2 Adjustment and replacement of the side brushes
3.3 Replacement of the filter element
3.4 Adjustment of the height of the baffles
3.5 Replacement of the fuses
Chapter 4 Common problems and solutions
11
Chapter 5 Maintenance
12
Chapter 6 After-sale services
13
Warranty card
14
Contents
- 1 -
Technical parameters
Category Unit Parameter
Cleaning width mm 1,900
Main brush width mm 700
Side brush width mm 500 * 4
Cleaning efficiency m2/h 16,800
Battery capacity V/Ah 48/100
Water tank capacity L 80
Garbage can capacity L 180
Main brush motor power W 800
Side brush motor power W 80 * 4
Driving motor power W 1,200
Suction motor power W 500
Working time h 4-5
Grade ability % 25
Product size mm 2,330 * 1 ,900 * 1,960
- 2 -
Chapter 1 General description
1.1 Contents and purposes
Potential risks concerning the use of the machine are listed in the following
sections. Since most accidents take place when safety rules are ignored, it is
necessary that you read them carefully and take precautions before getting
started. The best guarantee against any accident is a careful and cautious user,
which might be better than other precautions available. When using the
machine, pay special attention to the people in the working area, especially
children.
1.2 General instructions
Before any maintenance and repair, turn off the power and remove the key
from the general switch.
The machine can only be operated by qualified personnel. Children and
disabled people are strictly forbidden to use it.
Keep the battery away from sparks, flames and smoke.
Do NOT use the machine in places with dangerous, flammable or explosive
gases, liquids or water vapor.
The machine can be used to clean regular garbage. It must NOT be used to
clean silk ropes, belts, high-temperature sundries, accumulated water, or
flammable, toxic and harmful materials, so as to avoid entanglement and
burning of the brushes.
Keep loose clothing, hair, fingers and other parts of your body away from the
air vent and any moving part of the machine.
Turn off the power if you do not use the machine.
Do NOT use the machine in slopes with an inclination larger than the fixed
value.
Do NOT smoke when charging the battery.
Do NOT use the machine in very dirty places. Repeat the sweeping if there is
too much garbage.
The machine should be stored at a temperature between -10 °C and 40 °C.
The temperature of the working area should be between -10 °C and 40 °C, and
the humidity should be between 30% and 95%.
Do NOT use the machine as a means of transportation.
When the machine is not moving, stop the brushes to avoid damage to the
ground.
In the event of a fire, use a POWDER extinguisher rather than water.
- 3 -
When a failure is produced, make sure that it is NOT due to the lack of regular
maintenance.
If some spare parts need to be replaced, you can purchase them from the
original manufacturer or an authorized distributor.
To make sure that the machine is in the proper operating and safety condition,
the user or service center must abide by what is stated in Chapter III and
Chapter V.
Attention must be paid even when the machine is about to be dismantled and
scrapped. Since some harmful substances (such as batteries, waste oil, etc.)
have met the required standards, they should be sent to a specific center for
treatment.
1.3 Safety requirements for batteries
The battery must NOT be in a low voltage state; charge the battery as soon as
possible when the voltage is below 42 V;
To avoid electric leakage, keep the battery dry and clean;
Do NOT put metallic objects (such as tools) on the battery to prevent it from
being short-circuited and burned;
The charging room should be well ventilated;
When the key switch is in the position “ON”, do NOT install or remove the
battery;
Before installing or removing the battery, disconnect first the negative wire (-)
and then the positive wire (+). When rewiring, pay special attention to the
polarity of the battery, as wrong connection would probably damage electrical
components;
Avoid direct contact between the positive and the negative electrodes, because
it would cause a large current short circuit, high heat or even a fire.
1.4 General safety requirements
In addition to what is mentioned in this manual, the general safety
requirements must also be observed. Even if you have used a similar product
before, we recommend that you read this manual carefully so that you can
save much time as well as take precautions to protect the machine and
yourself. It is vital that you become familiar with all the accessories and
components before turning on the machine. Read our instructions carefully so
that you will not be confused when you get started.
- 4 -
Chapter 2 Operating the machine
2.1 Buttons and pedals of the machine
2.1.1 Key controlling buttons of the machine
Voltmeter
Note: when the general switch is turned on, the
current voltage of the machine will be displayed; if
the voltage is lower than 42V, charge the batteries
immediately.
Loudspeaker button
Main light button
Forward/backward button
Sweeping button
Dust-vibrator button
Sprinkler button
Note:
The sweeping button has three gears: the front gear, the middle gear and
the reset gear.
Do NOT use the dust-vibrator button with the sweeping button turned on.
Before turning on the sprinkler button, make sure that the sprinkler valve
is open; when it is turned off, close the valve to prevent splashes.
Large garbage pedal
Brake pedal
Accelerator
pedal
- 5 -
Note:
2.1.2 Charging the batteries
A socket with a minimum diameter of 6 mm is required.
If you need to stop charging the batteries, disconnect directly.
2.1.3 Adding water to the water tank
Before using the machine, add clean water to the clean water tank. Pay
attention to the water quality so that the waterway will not be blocked.
2.2 Operating the machine
2.2.1 Before the operation
Before getting started, make sure that no doors or covers are open and the
The sweeping button has three gears: the front gear, the middle gear and
the reset gear.
The dust-vibrator button can only be used when the sweeping button is
turned off.
Before turning on the sprinkler button, make sure that the sprinkler valve
is open; when it is turned off, close the valve to prevent splashes.
Hand brake: release the hand brake before driving
the machine.
- 6 -
garbage can is correctly closed. If the machine does not work after
transportation, check every part first.
2.2.2 Power display
Insert the start key in the steering wheel console and turn the start switch
clockwise to the "ON" position. The current voltage of the battery will be
displayed in three seconds. If the voltage is lower than 42 V, charge the battery
first.
2.2.3 Starting the machine
Be seated on the driver’s seat.
Step on the brake pedal and turn the start key to the "ON" position.
Move the machine to the work area using the steering wheel and the
forward/backward button.
The moving speed can be adjusted from 0 to the maximum value by pressing
the accelerator pedal.
Press the sweeping button to start work, and use the steering wheel,
accelerator pedal and forward/backward button to move the machine.
The garbage can must be closed during the sweeping work.
The sweeper applies automatic and one-button operation. When the sweeping
button is turned on, all motors (including the main brush motor, side brush
motor, and ventilator motor) will automatically start, and the main brush and
side brushes will automatically descend.
2.2.4 Stopping the machine
Release the accelerator pedal to stop the machine.
Press the stop button and all sweeping functions are stopped, and the main
brush and side brushes are raised.
Turn the start switch to the "OFF" position.
2.3 Cautions
2.3.1 General instructions
When the brushes are rolling, do NOT leave the machine in the same place for
a long time, because this would leave unnecessary marks on the ground.
If you need to remove large light garbage, you can lift the front baffle so that
the garbage can be recycled into the garbage can. Note that when the front
baffle is lifted, the suction efficiency of the machine will be reduced.
In order for the machine to achieve its best cleaning effects, the filter screen
Tabla de contenidos
Otros manuales de Soplador de CHANCEE
