Car and Driver CAD-9900 Manual de usuario

User Manual

CAD-9900

We’re here to help!

Call us at this number

(833) 227-3274

Or email us

[email protected]

FCC Statement

This device complies with part 15 of the FCC rules. Operation is

subject to the following two conditions (1) this device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate

the equipment.

1Warnings

Please read this warning carefully before using this product. Improper

use of this product may result in damage to this or attached products.

To ensure the product works well, please never use it in the following

conditions:

•While wet or submerged in water

•Near a heater or in high temperature scenarios

•In direct/intense sunlight

Never dismantle the product, otherwise it may nullify the warranty

clause.

2Introduction

Specifications

•Bluetooth version: V2.1

•Bluetooth ID: CAD-9900

•Screen: 20*8*4mm

•LED digital display

•Frequency range: 87.5-108.0 MHz

•Frequency stability: ±10ppm

•Product input: DC 12-24V

•Charger output: 5V/2.1A

•Music format: MP3, WMA

•Memory card (Max capacity): 32GB

•Product dimension: 99*55*34 mm

•Product weight: 82.8g

Contents

•Phone mount

•User manual

Features

•Adjustable clamps expand to securely grip most

smartphones

•Stream music and calls from a Bluetooth enabled device

through your car’s speakers

•Automatically switch from music to hands-free mode

when receiving a call

•Includes a charging port for USB compatible devices

•LED display

•Allows you to play music via memory card

3Getting Started

Installation

•Plug the power adapter into the car’s cigarette lighter

socket.

•Place your air-vent mount in the desired position and

adjust until you reach the desired angle.

•Pull out the left side of the clamp mechanism to make the

grip wide enough to hold your phone.

Using the FM Transmitter

•Turn your car radio to an unoccupied FM frequency, click

the spin button on your CAD-9900 and hold for two

seconds until the LED screen flashes the frequency. Then,

rotate the spin button to match the same frequency.

•Optional: insert into the card slot a memory card that

contains MP3/WMA music files. Once the card is inserted,

the music you put on the memory card will begin playing

automatically.

Using Bluetooth

•To pair your phone with the device for the first time, you

must:

oOpen your phone’s Bluetooth settings.

oMake sure that Bluetooth is turned on.

oWait for available Bluetooth enabled devices to

appear on the Bluetooth settings page.

oWhen the mobile phone detects this device (named

“CAD-9900”),tap the name toconnect.

oNote: If someone calls you while you’replaying

music, this device will automatically switch to

telephone mode. Press thespin button to answer/

redial as desired.

3.3.1 Charging Your Phone

When this device is plugged into a car cigarette lighter

socket, you can use the USB port on the side of the

mount to charge your phone or any other USB

compatible device (a USB cable is not included in this

package).

3.3.2 Siri Function

Press and hold down the spin button for 5 seconds to

activate Siri when connected to an iOS device.

SUMMIT CE GROUP ONE YEAR LIMITED WARRANTY

SUMMIT CE GROUP LIMITED WARRANTY (“Warranty”) ― For Product

Categories Listed in Chart Below (as applicable, “Product”) Before

returning your Product for service under this Warranty, please (i) read

the instruction manual carefully. If you are still having trouble with

your Product, please contact Technical Support at

[email protected]

Warning: Some Products may contain components that are small

enough to be swallowed. Please keep out of reach of children.

Subject to the terms and conditions herein, SUMMIT CE GROUP LLC

(hereinafter called “SUMMIT CE GROUP”) warrants to the original

purchaser of the Product (“Customer”) that for the applicable

Warranty Period listed below, the Product will be free from defects in

material or workmanship under normal, non-commercial use

(“Defects”). Warranty Period encompasses, as listed below, separate

“Coverage Periods” for Parts and Labor, each Coverage Period for one

year, to begin from the original date of Customer purchase. If

Customer returns a defective Product (or any component thereof)

during the applicable Warranty Period, SUMMIT CE GROUP will, at its

option, during the specified Coverage Periods for Parts and Labor (as

applicable) either: (i) repair the Product (or, as applicable, any

component thereof) or (ii) replace the Product (or, as applicable, any

component thereof) with a new or refurbished Product (or, as

applicable, any component thereof), in either case free of charge to

Customer for Parts and/or Labor (as applicable) during the specified

Coverage Period only, and excluding applicable shipping charges

(noted below), for which the Customer is responsible. The foregoing

states the Customer’s exclusive remedy and SUMMIT CE GROUP’s

sole liability for breach of the limited warranty contained herein.

This warranty specifically excludes any Product (or, as applicable, any

component thereof) that has been subject to or Defects resulting

from: (a) any neglect or misuse by a Customer, an accident, improper

application, violation of operating instructions for the Product, any

other Customer-induced damage, or the alteration or removal of any

Product serial number; (b) any modification of repair to Product (or,

as applicable, any component thereof) by any party other than

SUMMIT CE GROUP or a party authorized in writing by SUMMIT CE

GROUP; (c) any damage to Product (or, as applicable, any component

thereof) due to power surges, incorrect electrical

voltage, misconnection to any device, or malfunction of any device

used with the Product (or, as applicable, any component thereof); (d)

cosmetic damage to the Product (or, as applicable, any component

thereof) caused by normal wear and tear; (e) shipping damage that

occurs while the Product is in transit; (f) damage caused by heat

sources, sunlight, electromagnetic conditions, or other climatic

conditions; or (g) any acts of God. Product is sold to Customer for

personal, non-commercial use only. Product is not warranted for

Customer’s commercial or rental use.

In addition, Product is not warranted against failure, and should not

be used by Customer for any application where (i) there is a risk that

any data stored on Product will be breached or otherwise

compromised, or (ii) the data stored on Product is relied upon for

medical or lifesaving applications. SUMMIT CE GROUP disclaims any

Warranty for any of the foregoing uses to the fullest extent permitted

by law. Customer assumes any and all risks associated with such uses

of Product, and agrees to indemnify SUMMIT CE GROUP for any

damages claimed against SUMMIT CE GROUP for such uses. EXCEPT

FOR EXPRESS WARRANTIES STATED ABOVE AND TO THE MAXIMUM

EXTENT PERMITTED BY LAW, THE PRODUCTS ARE PROVIDED “AS IS”,

AND SUMMIT CE GROUP DISCLAIMS ALL OTHER WARRANTIES,

INCLUDING WITHOUT LIMITATION ANY IMPLIED WARRANTY (I) OF

MERCHANTABILITY, (II) OF FITNESS FOR A PARTICULAR PURPOSE, OR

(III) OF NON-INFRINGEMENT OF THIRD PARTY RIGHTS. TO THE

MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT

WILL SUMMIT CE GROUP BE LIABLE TO CUSTOMER OR ANY THIRD

PARTY FOR ANY INDIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL,

EXEMPLARY OR PUNITIVE DAMAGES, INCLUDING, WITHOUT

LIMITATION, ANY LOST PROFITS OR REVENUES, LOSS OR INACCURACY

OF ANY DATA OR COST OF SUBSTITUTE GOODS, REGARDLESS OF THE

THEORY OF LIABILITY (INCLUDING NEGLIGENCE) AND EVEN IF

SUMMIT CE GROUP HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH

DAMAGES, SUMMIT CE GROUP’S AGGREGATE LIABILITY TO

CUSTOMER FOR ACTUAL DIRECT DAMAGES FOR ANY CAUSE

WHATSOEVER SHALL BE LIMITED TO THE CUMULATIVE PRODUCT

FEES PAID BY THAT CUSTOMER FOR THE PRODUCT CAUSING THE

DAMAGES, IF ANY. This Warranty gives Customer specific rights, and

Customer may also have other rights that vary from jurisdiction to

jurisdiction. To obtain Warranty service, Customer must email

SUMMIT CE GROUP Technical Support prior to making a Product

return. Customer must include with Product return the following

items (failure to enclose any of these items may result in a delay in

the processing of your Warranty claim): (i) a dated sales receipt that

indicates the place of purchase, model number of Product, and

amount paid; (ii) a detailed description of Customer’s problem with

Product; (iii) Customer’s full name, phone number, and

return address, and; (iv) a money order made out to SUMMIT CE

GROUP Electronics Corporation to cover return shipping charges to

US destinations only, for the applicable dollar amount shown for the

Product in the table above. SUMMIT CE GROUP will not make return

shipments to a P.O. Box. For shipping to international addresses,

actual freight will be charged to Customer. Return your Product

freight-prepaid in its original packaging, or packaging that affords an

equal measure of protection. Please allow 4 to 6 weeks for the

processing of your claim (6 to 8 weeks from November to February).

SHIPPING COSTS: The original consumer is responsible for any

shipping charges incurred to ship the Product or part(s) to the

authorized service provider, for diagnosis, repair or replacement.

You must email [email protected] prior to making a

return. *US destinations only.

[email protected] or call us toll free at

833-227-3274

if you have any questions or regarding return information.

Manual de usuario

CAD-9900

¡Estamos aquí para ayudar!

Llámenos a este número

(833) 227-3274

O envíenos un correo electrónico

[email protected]

Tabla de contenidos

Idiomas:

Otros manuales de Transmisor de Car and Driver

Car and Driver

Car and Driver CAD-6057 Manual de usuario

Manuales populares de Transmisor de otras marcas

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manual del propietario

Honeywell

Honeywell 5816WMBR Manual de usuario

Kamstrup

Kamstrup READy MTU Instrucciones de funcionamiento

Omega

Omega ZW Series Manual de usuario

ABB

ABB Field 264H Guía

Alinco

Alinco DJ-V17T Manual de usuario

Dejero

Dejero EnGo 3x Manual de usuario

Rosemount

Rosemount 4600 Manual de usuario

Speaka Professional

Speaka Professional 2342740 Manual de usuario

trubomat

trubomat GAB 1000 Manual de usuario

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manual de usuario

Rondish

Rondish UT-11 Manual de usuario

MG 10JRE Manual de usuario

Burkert

Burkert 8177 Manual de usuario

Firetide

Firetide HotPort 3203 Manual

Tele Radio

Tele Radio T9-02 Manual de usuario

Rotronic

Rotronic HygroFlex HF3 Series Manual de usuario

Jamara

Jamara FCX6 Pro Tel Manual de usuario