Canon EF28 Manual de usuario

LENS

EF28–135mm f/3.5–5.6 IS USM

Instruction

EENNGG

007594H1JEFSKFOR.qxd10.2.164:17PMページ2

COPY

-1

English Instructions

Thank you for purchasing a Canon product.

Canon EF28-135mm f/3.5-5.6 IS USM is a high-

performance lens developed for EOS cameras that

incorporates an Image Stabilizer function.

●“IS” stands for Image Stabilizer.

●“USM” stands for Ultrasonic Motor.

Features

1. The Image Stabilizer gives the equivalent effect of a

shutter speed two stops* faster.

2. High-magnification zoom from 28 mm wide-angle to

135 mm telephoto.

3. Ultrasonic motor (USM) for fast, quiet autofocus.

4. Manual focusing is available after the subject comes

into focus in autofocus mode (ONE SHOT AF).

5. Great close-ups at 0.5 m/1.6 ft at all focal lengths.

*Based on [1/focal length] second.

Generally, it requires a shutter speed [1/focal length]

second or faster to prevent camera shake.

Conventions used in this instruction

Warning to prevent lens or camera

malfunction or damage.

Supplementary notes on using the lens and

taking pictures.

aHandling Cautions

If the lens is taken from a cold environment into a warm

one, condensation may develop on the lens surface and

internal parts. To prevent condensation in this case, first put

the lens into an airtight plastic bag before taking it from a cold

to warm environment. Then take out the lens after it has

warmed gradually. Do the same when taking the lens from a

warm environment into a cold one.

02-7594_ENG 10.2.13 9:46 AM Page 1

COPY

-2

aSafety Precautions

installed and used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of

the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•

Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

Do not make any changes or modifications to the equipment

unless otherwise specified in the instructions. If such changes or

modifications should be made, you could be required to stop

operation of the equipment.

This equipment has been tested and found to comply with the limits

for a class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

aSafety Precautions

1. Do not look at the sun or a bright light source through

the lens or camera. Doing so could result in loss of vision.

Looking at the sun directly through the lens is especially

hazardous.

2. Whether it is attached to the camera or not, do not

leave the lens under the sun without the lens cap

attached. This is to prevent the lens from concentrating the

sun’s rays, which could cause a fire.

02-7594_ENG 10.2.13 9:46 AM Page 2

COPY

-3

Nomenclature

Zoom ring(→ 5)

Focusing ring(→ 5)

Image stabilizer switch(→ 6)

Hood mount Focus mode switch(→ 5)

Distance scale(→ 8)

Contacts(→ 4)

Lens mount index(→ 4)

Zoom position index

For detailed information, reference page numbers are

provided in parentheses (→**).

02-7594_ENG 10.2.13 9:46 AM Page 3

COPY

-4

1. Mounting and Detaching the Lens

See your camera’s instructions for details on mounting and detaching the lens.

•After detaching the lens, place the lens with the rear end up to

prevent the lens surface and contacts from getting scratched.

•If the contacts get soiled, scratched, or have fingerprints on them,

corrosion or faulty connections can result. The camera and lens

may not operate properly.

•If the contacts get soiled or have fingerprints on them, clean them

with a soft cloth.

•If you remove the lens, cover it with the dust cap. To attach it properly, align the lens mount index and the index of the

dust cap, and turn clockwise. To remove it, reverse the order.

02-7594_ENG 10.2.13 9:46 AM Page 4

COPY

-5

3. Setting the Focus Mode

To shoot in autofocus (AF) mode, set the focus mode switch to AF.

To shoot in manual focus (MF) mode, set the focus mode switch to MF, and

focus by turning the focusing ring. The focusing ring always works,

regardless of the focus mode.

After autofocusing in ONE SHOT AF mode, focus manually by pressing the

shutter button halfway and turning the focusing ring. (Full-time manual focus)

2. Zooming

To zoom, turn the lens’ zoom ring.

Be sure to finish zooming before focusing. Changing the zoom ring after

focusing can affect the focus.

02-7594_ENG 10.2.13 9:46 AM Page 5

COPY

-6

4. Image Stabilizer

If you set the camera’s Custom Function to change the assigned button to

operate the AF, the Image Stabilizer will operate when you press the newly

assigned AF button.

1 2

➡

OFF ON

You can use the image stabilizer in AF or MF mode.

1. Set the STABILIZER switch to ON.

• If you are not going to use the image stabilizer function, set the switch

to OFF.

2. When you press the shutter button halfway, the Image Stabilizer will start

operating.

• Make sure the image in the viewfinder is stable, press the shutter

button the rest of the way down to take the picture.

02-7594_ENG 10.2.15 5:11 PM Page 6

COPY

-7

5. Tips on Using the Image Stabilizer

The image stabilizer in this lens is effective for hand-held shots under the following conditions.

•In semi-darkened areas such as indoors or outdoors at night.

•In locations where flash photography is prohibited, such as art museums and theater stages.

•In situations where your footing is uncertain.

•In situations where fast shutter settings cannot be used.

•The Image Stabilizer cannot compensate for a blurred shot caused by a subject that moved.

•Set the STABILIZER switch to OFF when using the camera on a tripod. If the switch is set to ON, the Image Stabilizer may

introduce errors.

•Set the STABILIZER switch to OFF when you are taking pictures using the Bulb setting (long exposures). If the

STABILIZER switch is set to ON, the image stabilizer function may introduce errors.

•The Image Stabilizer might not be fully effective in the following cases:

•You move the camera for a panned shot.

•You shoot while riding on a bumpy road.

•The Image Stabilizer consumes more power than normal shooting, so fewer shots can be taken if you use the function.

•The image stabilizer operates for about two seconds even when your finger is off the shutter button. Do not remove the

lens while the stabilizer is in operation. This will cause a malfunction.

•With the EOS-1V/HS, 3, ELAN 7E/ELAN 7/30/33, ELAN 7NE/ELAN 7N/30V/33V, ELAN II/ELAN II E/50/50E, REBEL

2000/300, IX, IX Lite/IX7, and D30, the Image Stabilizer will not work during self-timer operation.

•The stabilizer is equally effective for hand-held photography and photography with a monopod.

•The image stabilizer function also operates when the lens is used with an extension tube EF12 II or EF25 II.

•Depending on the camera there may be image shake, such as after releasing the shutter. However, this does not affect

shooting.

•If you set the camera’s Custom Function to change the assigned button to operate the AF, the Image Stabilizer will operate

when you press the newly assigned AF button.

02-7594_ENG 10.2.13 9:46 AM Page 7

COPY

-8

6. Infinity Compensation Mark

To compensate for shifting of the infinity focus point that results from changes in

temperature. The infinity position at normal temperature is the point at which the

vertical line of the L mark is aligned with the distance indicator on the distance

scale.

7. Infrared Index

The infrared index corrects the focus setting when using monochrome infrared

film.

Focus on the subject in MF, then adjust the distance setting by moving the

focusing ring to the corresponding infrared index mark.

For accurate focusing in MF on subjects at infinity distance, look through the

viewfinder while rotating the focusing ring.

•The infrared index position is based on a wavelength of 800 nm.

•Be sure to observe the manufacturer’s instructions when using infrared film.

•Use a red filter also when you take the picture.

Some EOS cameras cannot use infrared film. See the instructions for your EOS

camera.

Distance index

Infinity compensation mark

02-7594_ENG 10.2.15 5:11 PM Page 8

COPY

-9

8. Hood and Filters

Hood (Sold Separately) The EW-78B II lens hood can keep unwanted light out of the lens, and also

protects the lens from rain, snow, and dust. To attach the hood, align the

hood’s attachment position mark with the red dot on the front of the lens,

then turn the hood in the direction of the arrow until the lens’s red dot is

aligned with the hood’s stop position mark. The hood can be reverse-

mounted on the lens for storage.

•Part of the picture may be blocked if the hood is not attached properly.

•When attaching or detaching the hood, grasp the base of the hood to turn it.

To prevent deformation, do not grasp the rim of the hood to turn it.

02-7594_ENG 10.2.13 9:46 AM Page 9

COPY

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Lente de la cámara de Canon

Canon

Canon FD Lens Manual de usuario

Canon

Canon digi super 86 XS Manual de usuario

Canon

Canon EF 50mm 1:1.8 II Manual de instrucciones

Canon

Canon EF14mm f/2.8L II USM Manual de usuario

Canon

Canon HJ22EX7.6B Manual de usuario

Canon

Canon Serenar Manual de usuario

Canon

Canon EF200 mm Manual de usuario

Canon

Canon CN-E45-135mm T2.4 L F Manual de usuario

Canon

Canon IMAGE STABILIZER ULTRASONIC EF300MM f/4L IS... Manual de usuario

Canon

Canon 5123B006 Manual de usuario

Canon

Canon EF-M 18-55mm f3.5-5.6 IS STM Manual de usuario

Canon

Canon EF24-105MM F/4L IS USM Manual de usuario

Canon

Canon EF 70-200mm f/2.8L IS II USM Manual de usuario

Canon

Canon EF 70-300mm f/4.5-5.6 IS USM Manual de usuario

Canon

Canon EF 100mm 1:2.0 MACRO Manual de instrucciones

Canon

Canon EF 28mm 1:2.8 Manual de instrucciones

Canon

Canon RF 70-200mm Manual de usuario

Canon

Canon RF 100-500mm F4.5-7.1 L IS USM Manual de usuario

Canon

Canon EF 100mm f/2.8 Macro USM Manual de usuario

Canon

Canon EF 20mm 1:2.8 USM Manual de instrucciones

Canon

Canon EOS 5D Mark IV + 70-200mm Manual de usuario

Canon

Canon RF-S 18-45mm F4.5-6.3 IS STM Manual de usuario

Canon

Canon CN-E30-300mm T2.95-3.7L SP Manual de usuario

Canon

Canon EF 100mm f/2.8 Macro USM Manual de usuario

Manuales populares de Lente de la cámara de otras marcas

THORLABS

THORLABS ELL15 Manual de usuario

FUJICA

FUJICA ZC1000 Manual de usuario

Tamron

Tamron A09 Manual

Sony

Sony SEL-55210 Manual de usuario

Sony

Sony VCL-HG2037 Manual de usuario

Honeywell

Honeywell HLM25V6F12 Manual de usuario

Sony

Sony VCL-ST30 Manual de usuario

Sony

Sony SAL-85F14Z - 85mm f1.4 Carl Zeiss Planar T Coated Telephoto... Manual de usuario

ARRI

ARRI Lenses Manual de usuario

Panasonic

Panasonic LUMIX G X Vario 45-175mm f/4.0-5.6 Manual de usuario

Nikon

Nikon AF-S VR 24-120 f/3.5-5.6G IF-ED Manual de usuario

Rokinon

Rokinon DS50M-C Manual de usuario

Olympus

Olympus M.Zuiko Digital ES 300mm f4.0 IS PRO Manual de usuario

Sony

Sony VCL-DE07T Manual de usuario

Tamron

Tamron A036 Manual de usuario

Samsung

Samsung 20-50mm F3.5-5.6 ED II Manual de usuario

Tamron

Tamron 272E Manual de usuario

Sinar

Sinar Rolleiflex 6008 AF Manual de usuario