Calimet CM-5-ACFP Manual de usuario
1
2
PRODUCT SPECS：
Voltage Input：110V
Maximum output current：15AM，Fuse: AC110V 15AM
Remote control distance： Open space >150 Feet (50 meters)
WARNING
To reduce the risk of INJURY or DEATH:
Never let children operate or play with gate control, keep remote control
away from children.
ALWAYS keep people and objects away from gate. NO ONE SHOULD CROSS
THE PATH OF MOVING GATE.
Test gate operator monthly. The gate MUST reverse in contact with a rigid
object of reverse when an object activates the non-contact sensors. After
adjusting the force or limit of travel, reset gate operator. Failure to adjust
and reset the gate operator properly can increase the risk of INJURY or
DEATH.
Use the emergency release ONLY when gate is not moving.
KEEP GATE PROPERLY MAINTAINED. Read owner’s manual. Having a
qualified service person make repairs to gate hardware.
The entrance is for vehicles ONLY. Pedestrians MUST use separate
entrance.
SAVE THESE INSTRUCTIONS.
3
Installation of Base
1. Lay out position of 6 Anchors by measuring clearance between anchors
and inside edge of gate. Figure 1
2. Install underground conduits in area for conduits. Figure 2
Figure 1 Figure 2
4
Installation Barrier distance
Figure 3
Figure 4
5
Position of gate and operator
Two options of chain connection.
Figure 5 Front Mount
Figure6 Rear Mount
6
Welding Bracket of Chain
Figure 7
Correct connection of chain
Figure 8
Figure 8. Follow the correct way to install chain. Incorrect installation will cause
malfunction of operator and potential damages.
7
Power Connection
Figure9
1. MUST us UL proved power wires, power wires MUST have minimum capacity
for 25 Am current.
2. All operators MUST properly grounded in order to prevent electrical charge.
Must use dedicated circuit for power supply.
3. When power connected, turn power switch in operator to ON position.
8
EMERGENCY RELEASE
Figure 10
A. Emergency Release of gate
1. Disconnect power.
2. Push Release pedal downward and move slightly to the right until it was locked in down
Position.
3. Hold and push gate to desired direction.
B. Reset pedal (Only when operator has No reaction while using remote control)
1. Push pedal downward from locked position and slightly move to the left, unlocked
Pedal.
2. Allow Pedal rise up to reset position and release pedal.
9
Entrapment protection
Safety and Exit loop
Figure 11
10
Control Board lay out
Figure 12
Otros manuales para CM-5-ACFP
2
Tabla de contenidos
Otros manuales de Abridor de puerta de Calimet
Calimet
Calimet CM-5-ACFP Manual de usuario
Calimet
Calimet CM6 Instrucciones de instalación
Calimet
Calimet CM7-DCNB Manual de usuario
Calimet
Calimet CM3-DCNB Manual de usuario
Calimet
Calimet CM7-DCFP Manual de usuario
Calimet
Calimet CM6-DCFP Manual de usuario
Calimet
Calimet CM7-ACFP Manual de usuario
Calimet
Calimet CM3 Instrucciones de instalación
Calimet
Calimet CM6-ACFP Manual de usuario
Calimet
Calimet CM9-975 Manual de usuario
