Caberg JUST SPEAK EVO Manual de usuario

JUST SPEAK EVO
1. INTRODUCTION .................................................................................3
2. PACKAGE CONTENTS ........................................................................4
3. GETTING STARTED .............................................................................5
Installing the JUST SPEAK EVO on Your Helmet..........................................5
Powering On................................................................................................. 6
Powering Off................................................................................................. 6
Charging the JUST SPEAK EVO .................................................................. 7
Checking Battery Level ................................................................................ 8
Adjusting the Volume Level.......................................................................... 8
Function Priority............................................................................................ 8
Fault Reset.................................................................................................... 9
4. OPERATION QUICK REFERENCE ......................................................9
5. PAIRING AND USING THE JUST SPEAK EVO WITH BLUETOOTH
DEVICES .............................................................................................11
Mobile Phone Pairing ................................................................................. 11
Multipoint Mobile Phones Pairing ............................................................... 12
Bluetooth Stereo Device Pairing................................................................. 12
Bluetooth GPS Navigation Pairing.............................................................. 13
Mobile Phone Call Making and Answering ................................................ 15
Stereo Music............................................................................................... 16
CONTENTS
6. INTERCOM CONVERSATION ...........................................................16
Pairing with Other JUST SPEAK EVO Headsets for Intercom
Conversation .............................................................................................. 16
Starting and Ending Intercom Conversation .............................................. 17
Intercom and Mobile Phone Call................................................................ 17
Intercom Failure.......................................................................................... 17
Intercom Reconnection .............................................................................. 17
7. CONFIGURATION SETTING .............................................................18
Enabling/Disabling Voice Activated Phone Answering .............................. 18
Enabling/Disabling Voice Prompts ............................................................. 19
Delete All Bluetooth Pairing Information..................................................... 19
Reset to Factory Default Setting................................................................. 19
Exit Voice Conguration Menu ................................................................... 19
8. FIRMWARE UPGRADE ......................................................................20

JUST SPEAK EVO
3
English
1. INTRODUCTION
Thank you for choosing the JUST SPEAK EVO, Bluetooth Headset and
Intercom for Scooters and Motorcycles. With the JUST SPEAK EVO,
you can call handsfree on your Bluetooth mobile phone, listen to stereo
music or GPS navigation voice instructions via Bluetooth, and have
intercom conversations in full duplex with a passenger or other riders.
The JUST SPEAK EVO is compliant with the Bluetooth specication 3.0
supporting the following proles: Headset Prole, Hands-Free Prole
(HFP), Advanced Audio Distribution Prole (A2DP), and Audio Video
Remote Control Prole (AVRCP). Please conrm compatibility with other
devices with the manufacturers.
Please read this user guide carefully before using the headset. Also visit
www.caberg.it for the latest version of the user guide and for additional
information related to CABERG Bluetooth products.
The JUST SPEAK EVO includes the following features:
• Bluetooth handsfree for Bluetooth mobile phones
• Bluetooth stereo headset for Bluetooth stereo devices such as MP3
players
• Bluetooth stereo headset for Bluetooth GPS navigations
• Bluetooth intercom up to 200 meters (220 yards)*
• Easy two-button operation
• Installation friendly unibody design
• Firmware upgradeable
Key Specications:
• Bluetooth 3.0
• Supporting proles: Headset Prole, Hands-Free Prole (HFP),
Advanced Audio Distribution Prole (A2DP), Audio Video Remote
Control Prole (AVRCP)
* in open terrain

JUST SPEAK EVO
4
2. PACKAGE CONTENTS
Microphone
connector (–) Button
(Intercom)
(+) Button
(Phone, Music)
DC Power Charging &
Firmware Upgrade Port
Status LED
Speakers
Pin-hole
Reset Button
Attachable Boom
Microphone
USB Power & Data Cable
Hook and Loop Fasteners
for Speakers
Hook and Loop Fastener
for Microphone
Microphone Sponges Double Sided Adhesive Tape

JUST SPEAK EVO
5
English
3. GETTING STARTED
Installing the JUST SPEAK EVO on Your Helmet
1. Peel off the hook fasteners for the speakers and attach them on the
back sides of the speakers.
2. Attach the loop fasteners for the speakers in the deep ear pockets of
your helmet.
3. Place the speakers in the helmet along with the hook and loop
fasteners, centered to your ear.
4. Locate a suitable surface on the left side of your helmet to attach
the unit, clean the location with a moistened towel, and allow to dry
thoroughly.
5. Peel off the adhesive tape covers of the control unit and attach it on
your helmet.
6. Attach the hook and loop fastener for the boom microphone between
the internal helmet cheek pad and the internal wall of the helmet
shell. Place the attachable boom microphone on the hook and loop
fastener and attach the microphone connector to the 2 pin connector
of the main unit cable. The microphone should be mounted so it is
positioned close to your mouth when you are wearing the helmet.
7. Hide the wire under the helmet padding after the installation.
1
2

JUST SPEAK EVO
6
3
4
5
Powering On
Press and hold the (+) Button and the (–) Button at the same time for 1
second to power on. The blue LED turns on and you will hear ascending
beeps and “Hello”.
Powering Off
Press the (+) Button and the (–) Button at the same time. The red LED
turns on for about 2 seconds until it turns off completely and you will hear
“Goodbye” and descending beeps.

JUST SPEAK EVO
7
English
Note:
1. The USB power & data cable is also used for firmware upgrade of the JUST
SPEAK EVO.
2. The USB wall charger is not included in the package. Any 3rd party USB
charger can be used with CABERG products if the charger is approved
by either FCC, CE, IC, or other locally approved agencies that CABERG
accepts. Please contact CABERG regarding locally approved agencies
CABERG accepts.
Charging the JUST SPEAK EVO
You can charge the JUST SPEAK EVO by connecting the supplied USB
power & data cable into a computer USB port or USB wall charger. You
can use any standard micro-USB cable to charge the JUST SPEAK EVO.
The LED turns red while charging, and turns blue when the headset is
fully charged. It takes about 2.5 hours to fully charge.
Note:
Please make sure to take off your JUST SPEAK EVO-installed helmet while
charging.

JUST SPEAK EVO
8
Checking Battery Level
You can check the battery level in two different ways when the headset
is powering on.
LED Indicator
When the headset is powering on, the red LED ashes rapidly indicating
the battery level.
LED Status
4 ashes High, 70~100%
3 ashes Medium, 30~70%
2 ashes Low, 0~30%
Voice Prompt Indicator
When you power on the headset, keep pressing and holding the (+)
Button and (–) Button simultaneously for about 3 seconds until you hear
three high tone beeps. Then you will hear a voice prompt indicating the
battery level. However, if you release the buttons as soon as the headset
turns on, you will not hear the voice prompt for the battery level.
Low Battery Warning
When the battery is low, the blinking blue LED in stand-by mode turns to
red and you will hear mid-tone triple beeps and a voice prompt saying
“Low battery”.
Adjusting the Volume Level
You can easily adjust the volume by pressing the (+) Button or the
(–) Button. You will hear a beep when the volume reaches maximum
or minimum level. The volume is set and maintained independently at
different levels for each audio source even when you turn off and on
the headset. For example, once you set the volume for mobile phone
handsfree, it will not change even if you adjust the volume when you
hear Bluetooth MP3 music. So you can always maintain the preferred
optimum volume level for each audio source.
Function Priority
The JUST SPEAK EVO operates in the following order of priority:
(Highest) Mobile Phone
Intercom
(Lowest) Bluetooth Stereo Music

JUST SPEAK EVO
9
English
A lower priority function is always interrupted by a higher priority function.
For example, stereo music is interrupted by an intercom call, and intercom
conversation is interrupted by an incoming mobile phone call.
Fault Reset
When the JUST SPEAK EVO is not working properly or is in faulty status
for any reason, you may reset by pushing the pin-hole reset button on
the left speaker unit. Insert a paper clip into the reset pin-hole and press
and hold the reset button for a second with light pressure. The JUST
SPEAK EVO will be switched off. Turn the system back on and try again.
However, this will not restore the headset to factory default settings.
4. OPERATION QUICK REFERENCE
Function Operations
Power
On/Off
1 sec. 1 sec.
+
Power On
1 press 1 press
+
Power Off
Volume
Adjustment
1 press 1 press
or
Intercom
Pairing
pairing
AB
1) 5 sec. 5 sec.
2) 1 sec.

JUST SPEAK EVO
10
Function Operations
Bluetooth
Pairing
(Phone, MP3,
GPS)
1)
Caberg JSE v1.0
5 sec.
2)
Caberg JSE v1.0
Select Caberg JSE
3)
Caberg JSE v1.0
Enter PIN
Start & End
Intercom
Conversation
1 sec.
Conguration
10 sec.
Function Operations
Mobile
Phone
Answer
or
1 press
End
2 sec.
Voice Dial
*
3 sec.
*
3 sec.
Reject
2 sec.
Otros manuales para JUST SPEAK EVO
8
Tabla de contenidos
Otros manuales de Auriculares de Caberg

Caberg
Caberg JUST SPEAK EVO Manual de usuario

Caberg
Caberg JUST SPEAK EVO Manual de usuario

Caberg
Caberg JUST SPEAK EVO Manual de usuario

Caberg
Caberg JUST SPEAK EVO Manual de usuario

Caberg
Caberg JUST SPEAK EVO Manual de usuario

Caberg
Caberg JUST SPEAK EVO Manual de usuario

Caberg
Caberg JUST SPEAK EVO Manual de usuario

Caberg
Caberg JUST SPEAK EVO Manual de usuario

















