Caberg JUST SPEAK EVO Manual de usuario
1.
2.
3.
4.
Remove the anti-noise inserts by
pulling them out of the chinstrap.
Place the right speaker (R)
on the cheekpad’s pp plate after
applyingthe adhesive round
shapedvelcroincludedinthe
package.
Repeat the operations performed
for the right (R) speaker for
positioning the left (L).
Without pulling the chinstrap
out of the cheekpads, pass the
microphone cable and the flat
cable of the remote control into
the hole of the cheekpads.
ASSEMBLY
INSTRUCTION
5.
6.
7.
8.
Pass the flat cable of the remote
control cable between the
neckroll’s pp plate and the shell.
The remote control must remain
accessible outside the helmet.
Place the base of the microphone
under the cheekpads, place
the microphone’s boom in the
seat ensuring that the neckroll
pp plate has been previously
positioned against the shell.
Adjust the microphone’s position
by deforming its boom.
WARNING: check that the triangle
on the microphone is facing the
mouth.
Place the USB socket between the
cheekpad and the neckroll.
ASSEMBLY
INSTRUCTION
9.
10.
House the cable that connects the
right speaker to the left between
the rear cushion and the neckroll.
Stick the remote control on the
side of the shell verifying the
correct adhesion.
ASSEMBLY
INSTRUCTION
Otros manuales para JUST SPEAK EVO
8
Tabla de contenidos
Otros manuales de Auriculares de Caberg
Caberg
Caberg JUST SPEAK EVO Manual de usuario
Caberg
Caberg JUST SPEAK EVO Manual de usuario
Caberg
Caberg JUST SPEAK EVO Manual de usuario
Caberg
Caberg JUST SPEAK EVO Manual de usuario
Caberg
Caberg JUST SPEAK EVO Manual de usuario
Caberg
Caberg JUST SPEAK EVO Manual de usuario
Caberg
Caberg JUST SPEAK EVO Manual de usuario
Caberg
Caberg JUST SPEAK EVO Manual de usuario
