Bticino TI 369711 Manual de usuario
369711
Video KIT
Installation manual
01/13-01 PC
2
Video Kit
Installation manual
3
Contents
1 Introduction 4
1.1 Warnings and tips 4
1.2 Basic diagram 5
2 Description 6
2.1 Entrance panel 6
2.2 Internal unit 7
3 Installation 9
3.1 Entrance panel installation 9
3.2 Internal Unit installation 12
3.3 Cable section (mm2) 14
4 Configuration 15
4.1 Entrance panel configuration 15
4.2 Internal unit configuration 16
4.2.1 Selection of the M mode 17
4.2.2 Meaning of the symbols 19
4.2.3 Completing the Quick Configuration 20
4.2.4 Configuration menu 21
5 Badge programming 23
5.1 Manager master badge 23
5.1.1 New manager master badge 23
5.1.2 Deleting the manager master badge 25
5.2 Resident badge 26
5.2.1 New resident badge 26
5.2.2 Cancellation of all the residents badges saved in the memory 28
5.3 Reset 29
6 Diagrams 30
6.1 Diagram with relay door lock 30
6.2 Staircase light control 31
6.3 Secondary door lock control 32
6.4 Diagram with additional internal unit 33
7 Trouble shooting 34
7.1 Adjustment volume 34
7.2 Push to Talk mode 35
4
1.1 Warnings and tips
Before proceeding with the installation read this manual carefully. The guarantee is automatically
cancelled in the case of negligence, incorrect use and tampering by unauthorised people.
The Video KIT must only be used on BTicino 2 wire digital systems.
Old system with bell
Existing system with 3 wires and just call.
230 Vac
PS
BUS TK BUS PI
346830
BUS 2 1
}
346000
032206
IP30
PRI230V~ 50 - 60Hz 260mA
BUS
2-1 27V 1,2A
PRI
New video door entry system
System installed without the need for changing the existing 2 wires: call, video, and door lock.
230 Vac 12 V
1 Introduction
Video Kit
Installation manual
5
1.2 Basic diagram
PS
BUS TK BUS PI
346830
BUS 2 1
230 Vac
}
346000
0322 06
IP30
PRI 230V~ 50 - 60Hz 260mA
BUS
2-1 27V 1,2A
PRI
ON
OFF
MODP
N
BUS
PL S+ S-
A
T SN
P
BUS
A=Door lock pushbutton
S+ S- =18 V; 4 A impulsive;
250 mA holding current (30 Ω max)
6
2.1 Entrance panel
2 Description
6
7
9
3
8
4
5
2
1
1 - Antenna / badge reader
2 - Enable / disable the door lock release confirmation sound
3 - Reset / badge programming pushbutton
4 - Microphone adjustment
5 - Loudspeaker adjustment
6 - Green LED: door open notification
7 - Green LED: communication active
8 - LED flashing green: call forwarded; LED flashing red: system busy
9 - Configurator socket
Video Kit
Installation manual
7
2.2 Internal unit
1 - Microphone.
2 - Colour LCD display; displays the menus which guide the use and programming operation,
shows the pictures taken by the entrance panel or other cameras.
3 - Navigation keypad; navigates inside the menus, confirms (OK key) or cancels (C key) the
programming operations.
4 - Switch ON entrance panel and cycling key.
5 - Connection key; activates/deactivates the sound connection.
6 - Connection LED.
7 - Loudspeaker.
8 - Door lock LED.
9 - Door lock key; activates the electric door lock of the associated or connected entrance panel.
10 - Answering machine status notification LED.
11 - Pushbutton for enabling/disabling the answering machine function.
12 - Call bell exclusion LED. It lights up when the bell volume is set to 0.
2
1
3
5
4
68 7
9
10
11
12
8
3
4
2
1
1 - Connection to the BTicino 2-wire digital system BUS
2 - Stretch end ON/OFF microswitch
3 - Configurator socket
4 - Connector for extra power supply
For proper magnetic coupling between the
Internal Unit and the sound device, it is rec-
ommended to stay 25-35 cm from the front
side of the device.
Remember that the presence of metal and
background noise generated by electric/
electronic equipment (e.g. computers), can
affect the quality and the performance of
the coupling device.
2
5
-3
5 c
m
40cm
Inductive loop use: Switch hearing device in T position.
2 Description
Video Kit
Installation manual
9
3 Installation
3.1 Entrance panel installation
The camera must not be installed in front of large light sources, or in places where the subject
viewed remains in deep shadow. To solve the problems described above change the height at
which the camera is installed, normally 160 to 165 cm, to a height of 180 cm, and face the lens
downwards to improve the quality of the views.
Note: in poor lighting conditions cameras with colour CMOS detector are less sensitive than black/
white cameras. An extra lighting source should be added in poorly lit rooms.
1
2
160 –165 cm
135 –140 cm
140 cm
50 cm
185 mm
106 mm 35 mm
5 mm
max
3
10
4
5
CLAC
1 2
CLAC
4 5
CLAC
3
3 Installation
Tabla de contenidos
Otros manuales de Sistema de intercomunicación de Bticino
Bticino
Bticino 315411 Manual de funcionamiento
Bticino
Bticino 342630 Manual de usuario
Bticino
Bticino 391 875 Manual de usuario
Bticino
Bticino 334402 Manual de usuario
Bticino
Bticino 323001 Manual de usuario
Bticino
Bticino 344842 Manual de usuario
Bticino
Bticino 344522 Manual de usuario
Bticino
Bticino Sfera video kit Manual de usuario
Bticino
Bticino 363910 Manual de usuario
Bticino
Bticino 367811 Manual de usuario
Bticino
Bticino D45 Manual de usuario
Bticino
Bticino Terraneo 363211 Manual de usuario
Bticino
Bticino 364614 Manual de usuario
Bticino
Bticino AXOLUTE Nighter Manual de usuario
Bticino
Bticino 315211 Manual de funcionamiento
Bticino
Bticino 361511 Manual de usuario
Bticino
Bticino 347400 Manual de usuario
Bticino
Bticino 344642 Manual de usuario
Bticino
Bticino terraneo Manual de usuario
Bticino
Bticino 316911 Manual de usuario
